Panasonic Aj D700 Operating Instructions Manual

Setting the Electronic Shutter
Shutter Modes
The shutter modes which can be used with the unit’s electronic shutter and the shutter speeds
which can be selected are as follows.
Shutter modes and shutter speeds which can be selected
Mode
Standard
SYNCHRO
SCAN
SUPER V
Shutter speedApplication
1/100, 1/120, 1/250, 1/500,This mode is used to shoot clear images of
1/1000 and 1/2000quickly moving subjects.
(seconds)
248 steps in the range fromThis mode is used to reduce horizontal stripe
30.4 Hz to 250...

Setting the Electronic Shutter
Setting the Shutter Mode/Speed
The shutter speed during shutter mode and standard mode is set by the SHUTTER switch.
During SYNCHRO SCAN mode, the shutter speed can be set beforehand at the SYNCHRO
SCAN page of the setting menu. The shutter speed can also be set by the UP and DOWN but-
tons during SYNCHRO SCAN mode. (In addition, if S. SCAN SEL on the FUNCTION 2/5 page
of the setting menu is set to ON, the shutter speed can also be varied by the SUPER IRIS and
MODE CHECK...

Setting the Synchro Scan Mode
1Set the MENU SET/OFF switch to SET.
The page on which the previous setting menu operations were completed appears on the
viewfinder screen. (When the menu is used for the first time, the first page appears.)
2Press the PAGE button repeatedly until the SYNCHRO SCAN page shown below appears.
(This operation can also be performed using the PAGE+UP/DOWN function.)
– SYNCHRO SCAN –
1/61.7
3Press the UP (the value increases) or DOWN (the value decreases) button repeatedly to...

Setting the Electronic Shutter 

Adjusting the Audio Level
If the AUTO SELECT CH1/CH2 selector switch is set to AUTO, the input levels of audio CH1 and
CH2 are automatically adjusted. If are the level of audio channels 1 and 2 to be manually ad-
justed, perform the following operations.
3
1
2
Manually Adjusting the Audio Level
1Set the AUTO SELECT CH1/CH2 selector switch to MAN.
2Turn the AUDIO LEVEL CH1 control at the bottom of the front panel completely to the right.
3Turn the AUDIO LEVEL CH1/CH2 controls to adjust the audio level so...

Adjusting the Audio Level
4Turn the AUDIO LEVEL CH1 control at the bottom of the front panel to adjust the input vol-
ume so that the audio level display appears as shown below.
When the input volume is normal, the audio level display turns ON up to the sixth of the
seven level display bars from the left.
When the rightmost (0 dB) turns asterisk (*) mark, the input volume is excessive. Adjust the
level so that the seventh (0 dB) does not turn * mark.
When the optimal level cannot be set
The maximum...

Setting the Time Data 

Setting the Time Data 

Locking the Time Code to an External Source 

Setting the Time Data
External Lock Operation Procedure
3
2
1
1Set the POWER switch to ON.
2Set the F-RUN/R-RUN switch to F-RUN
3Set the DISPLAY switch to TC.
4Supply reference time code and reference video signals with a phase relationship which
meets the time code standards to the TC IN and GENLOCK IN connectors, respectively.
This locks the built-in time code generator to the reference time code. After about 10 seconds
have passed since the time code generator was locked, the external lock status is...