Panasonic Air Conditioner Cz 64esmc1U Installation Instructions

85464369524010
INSTALLATION INSTRUCTIONS
System Controller
Model No. CZ-64ESMC1U
$;&4.$6@FOHJOEE


$;&4.$6@FOHJOEE








 

2
Contents
Page
Product Information ............................................................................................... 2
Alert Symbols ........................................................................................................ 2
Installation Location ............................................................................................... 3
Electrical Requirements......................................................................................... 3
Safety Instructions...

3
Installation Location
We recommend that this system controller be installed properly by  
quali ed installation technicians in accordance with the Installation 
Instructions provided with the system controller.
Do not install this system controller where there are fumes or  
 ammable gases, or in an extremely humid space such as a 
greenhouse.
Do not install the system controller where excessively high heat- 
generating objects are placed.
Electrical Requirements
1.  All wiring must conform to the...

4
1. General
This booklet brie y outlines where and how to install the system controller. 
Please read over the entire set of instructions for the indoor and outdoor units 
and make sure all accessory parts listed are with the controller before beginning.
NOTE
Give these instructions to the customer after  nishing the installation.
Part Name Figure Q’ty
System Controller 1
4
2
2
1 Rubber bushing
(7/8 in.)
Screws for fixture
(1-3/16 in.)
Wire joints
Switch box
1
1
1 T10 cable
CRV cable
Identification...

5

6

7

8
WARNING
To avoid an electric shock hazard,
DO NOT touch any terminal on the 
Printed Circuit Board with a metal 
rod, a screwdriver edge nor a bare 
handwhen power is supplied.After installation and adjust-
ment, be sure to turn the 
BACK UP switch ON.
All bits are set off
when shipped from
factory.To Installers,
How to reach the P.C. board
Remove the  at-top screw on the bottom of the back case. When you open 
up the decorative cover, you will see two notches under the controller. Inset 
a coin or...

9
Main/sub selection switch
OFF: System controller operates as main controller. 
ON: System controller operates as sub-controller.
ALL/ZONE mode selection switch
ALL mode:
All indoor units can be controlled by system controller 
ZONE 1, 2, 3, 4 mode: 
Indoor units in one of zone 1, 2, 3, or 4 can be 
controlled by system controller. All indoor units cannot 
be set.
Central control/Remote control mode selection switch
OFF: Central control mode.
Individual setting by remote controller can be inhibited 
by...

10
Auxilaly switch
Must be set to OFF position.
Beep tone switch
OFF: Beep tone when each button is pushed. 
ON: No tone when each button is pushed.
 Indication switch
Normally set to OFF position.
When set to ON position, 
 indication is not displayed 
on LCD of system controller.
*All switches are OFF position at shipment.
12345678
SW2
SW2
ON
OFF
Fig. 6
$;&4.$6@FOHJOEE


$;&4.$6@FOHJOEE