Panasonic 60"65" Class 1080p Plasma Hdtv Tc P60zt60 Owners Manual

							11
  Attaching the pedestal to TV
Assembly screws 
(Black) (8)BracketCover
M5 × 16
Assembly screws 
(Black) (1)BaseCable clamps (4)
M4 × 10
 Cable binding instructions 
(p. 16)
Attaching the pedestal
A
B
E
C
D
1
2
3
45A
Removing the pedestal from the TVBe sure to remove the pedestal in the following way when using 
the wall-hanging bracket or repacking the TV.  
  Remove the assembly screws  from the TV. Lift the TV from the pedestal. Remove the assembly screw  from the cover.  Pull out the cover.  Remove the assembly screws  from the bracket.
Warning
Do not disassemble or modify the pedestal.
 Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
 Otherwise, the TV may fall over and become damaged, and personal injury may result.Do not use the pedestal if it becomes warped or physically damaged. If you use the pedestal when it is physically damaged, personal injury may result. Contact your 
nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
 If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal 
will not be strong enough to support the TV, and it might fall over and become damaged, and personal 
injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified 
procedure. (Above)
 Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result. 
						

							12
  Installing the remote’s batteries
  ■Remote Control
Pull 
open
Hook
Note the correct 
polarity (+ or -).Close
  ■VIERA Touch Pad Controller
Slide 
open
Close
Note the correct polarity
(+ or -) 
Caution
 Incorrect installation may cause battery leakage and corrosion, resulting in damage to the remote 
control.
• Do not mix old and new batteries.
• Do not mix different battery types (such as alkaline and manganese batteries).
• Do not use rechargeable (Ni-Cd) batteries. Do not burn or break batteries. 
						

							13
  Connections
Connection Panels
  ●For , ,  connections, 
please refer to p. 15SD card 
slot 
USB1/2/3 
terminal
Ethernet
connectorBack of the TV 
						

							14
Power Cord
Connect after all other 
connections have been 
made.Back of the TV
Cable TV
VHF/UHF Antenna
or
   
Antenna or Cable connection
VHF/UHF Antenna•  NTSC (National Television System Committee): Analog television system
ATSC (Advanced Television Systems Committee):
Digital TV Standards include digital high-definition television (HDTV), standard-definition television (SDTV), 
data broadcasting, multi-channel surround sound audio and interactive television.
  Cable  ●You need to subscribe to a cable TV service to enjoy viewing their programming.  ●A high-definition connection can be made using an HDMI or Component Video cable. (p. 15)
Note
  ●When using a Cable box, external equipment and video cables shown in this manual are not supplied 
with the TV.
  ●For additional assistance, visit us at:   www.panasonic.com/help
www.panasonic.ca
Insert it firmly until the tabs on 
both sides click into place.Keep pushing both sides 
until they snap and pull.
To attach To remove 
						

							15
   
AV cable connection
Best
Good
Basic
(Not HD)
  To use  HDMI terminals (Set-top-box / DVD recorder / Blu-ray Disc player / Camcorder / etc.)
L
R
HDMI
AV OUT
HDMI cable
DVI OUT
AUDIO OUTe.g. Blu-ray Disc 
player
e.g. Blu-ray Disc 
player
AV Equipment
AV Equipment
Audio cable whitewhite
red redHDMI-DVI 
Conversion cable
 To use  COMPONENT terminals (DVD recorder / Blu-ray Disc player / etc.)
L
RY
P
B
PR
AUDIO
OUT
COMPONENT
VIDEO OUT
white
red green
blue
red
e.g. Blu-ray Disc 
player
AV Equipment
white
redred blue green
white
red red blue green
  To use  COMPOSITE terminals (Camcorder / Game system / DVD recorder / etc.)
L
RCOMPOSITE
OUTyellow
white
red yellow
white
rede.g. Camcorder AV Equipment
white
red yellow
Note
  ●In some cases, it is not possible to connect depending on the type of cable or 
equipment.
  ●The Green terminal is shared for both the COMPONENT and COMPOSITE (VIDEO IN) 
connection. When using COMPOSITE (VIDEO IN) connection, the Yellow connector 
(Video) should be inserted into Green connection. 
						

							16
   
Audio connection
HDMI cable
HDMI OUT 
(ARC)
Optical cable
DIGITAL 
AUDIO IN
e.g. Amplifier with
speaker system
HDMI connection is available if connected audio equipment has ARC (Audio Return Channel) function.
  Please refer to eHELP (p. 22) for Network connection, VIERA link connection or other connections.
Cable Binding Instructions
Back of the TV
  ●Do not bundle the Antenna cable and 
AC cord together (could cause distorted 
image).
  ●Fasten the cables with the Cable tie/
clamp as necessary.
  ●To fix cables with options, please refer to 
the operating manual for the options.
To attach:
Cable tie
InsertTo remove:
Snaps
Apply pressure 
to both sides 
until they snap
HooksSetTo loosen:
Knob
Apply pressure 
to the knob
Hole
To bundle:
To attach:
Cable clamp
To bundle:
HoleTo remove:
Snaps
Apply pressure to 
both sides until 
they snap
To release:
Ta bApply pressure 
to the tab Insert
Set
Panasonic does not guarantee operation and performance of peripheral devices made by other 
manufacturers; and we disclaim any liability or damage arising from operation and/or performance 
from usage of such other maker’s peripheral devices.
(example) 
						

							17
Identifying Controls
TV controls/indicators
Note
  The TV consumes a small amount of electric energy even when turned off.  Do not place any objects between the TV remote control sensor and remote control.
•  An image of the control panel is displayed 
on the screen while in use.
C.A.T.S. (Contrast Automatic Tracking System)
  Power indicator ( on: red, off: no light) Front of the TV
Remote control sensor
Maximum range for remote is 23 feet (7 meters) 
from front of TV set
Back of the TV
Volume up/down Selects channels 
in sequence
POWER button Changes the input mode
Selects Menu and Submenu entries
(Press and hold down for MENU function) 
						

							18
  Remote control
Switches TV On or Off (Standby)
Displays 3D settings
Displays Main Menu
Displays or removes the information 
banner
Display Apps (application) list 
Displays Option Menu for special 
functions (when available)
  Colored buttons 
(used for various functions)
Changes aspect ratio and zoom
  Volume up/down
Use for digital channels
Accesses NETFLIX service directly 
•  This service requires an Internet 
connection.
•  This service might be stopped or the 
conditions changed without notice.
Lights the buttons for 5 seconds 
Press again to turn off the button lights
Selects Secondary Audio Programming
  Exits from menu screen
Displays Home Screen
Select source to watch
Selects/OK/Change
Go back to previous menu
Channel up/down, when viewing from 
ANT/Cable source
Numeric keypad to select any channel or 
press to enter alphanumeric input in menus
  Switches to previously viewed 
channel or input External equipment operations*  Functions are switched depending on 
connected external equipment and 
operation.
 :  Press and hold to skip 
backward/forward.Viewing from external media (SD/USB)
Displays eHELP (built-in manual) 
(p. 22)   Sound mute On/OffClosed caption On/Off
Switches surround sound setting
Operates the Favorite channel list function 
						

							19
VIERA Touch Pad Controller
The Touch Pad Controller is designed to facilitate TV operation, such as when accessing Home Screen 
or the Browser with the Touch Pad and free pointing system. It also covers other TV operations as a 
Remote controller.
  ●Touch Pad Controller must be paired with the TV prior to operation.
(Pairing to this TV with Bluetooth wireless technology.)
■Parts names and functions
Power button
To use microphone Microphone
TOOLS 
(Displays on-screen remote control)Touch Pad
OPTION
(Displays Option menu)
HOME
(Displays Home screen) RETURN
Channel up/down
Apps
(Displays Apps  list)
Volume up/down
OK Front of the Touch Pad Side of the Touch Pad
  The Touch Pad Controller must be pointed toward the TV to turn on the power.
(Only the Power-on switch works at first.)
  The TV can be paired with one Touch Pad Controller only.  About Voice Control:
It is recommended to speak within about 6 inches (15 cm) from microphone of VIERA Touch Pad 
Controller when using Voice Control function.
(Please refer to eHELP (p. 22) for Voice Control function.)
  Transmission Range:
Use the Touch Pad Controller within the range of 10.5 ft (3.2 m) from front surface of the TV.
The range may be shortened if there are any obstacles or can be affected by the surrounding 
environment or building structure.
■Pairing Touch Pad Controller
  (In First Time Setup (p. 20))
  To pair the Touch Pad Controller, hold the touch pad within 1.6 ft (50 cm) of the TV and simultaneously press 
and hold the OPTION and HOME button on the Touch Pad Controller following the instructions on screen.
• You can also pair the Touch Pad Controller.
(Press Menu --> Setup --> VIERA Touch Pad settings)
■Operating Touch Pad Controller
  Touch Pad operations
Tap:
Tap center of the 
pad to “OK”Swipe:
Slide your finger 
to swipe.Trace the fringe to 
scroll.
  ●Some operations differ depending on the application. 
						

							20
First Time Setup
The first time setup screen is displayed only when the TV is turned on for the first time, after 
the power cord is inserted into a wall outlet. 
or
Turn the TV on with the POWER button
or
(Remote) (TV)
Setup the following items
  ●Select your language
  ●Select your country
  ●Select your viewing mode (Be sure to select “Home Use”)If you select “Store Demonstration” by mistake, confirmation screen 
will be displayed.
To display the “Set viewing mode” screen again in order to select 
“Home Use”, perform one of the following actions:
•  Press and hold down the rear POWER button for at least five 
seconds.
•  Unplug the power cord for 30 seconds and then plug it in again.
  ●Configure Network connection
Follow the instructions on screen to complete the Network 
connection.
  ●ANT/Cable setup
Set up based on how your TV programming is connected. Select 
“Yes” if you are connected to a Cable, Satellite or Fiber Optic box. 
Select “No” if you are connected to the Antenna/Cable In with a 
coaxial wire into the screw-on connector. In this case you will need 
to scan for channels that are available in your area.
  ●Adjust the Clock
Select the clock mode and adjust other settings.
When “Auto” is selected, clock will be set automatically according 
to Time zone and DST. The TV must be connected to the Internet to 
use this feature.
  ●Pair the Touch Pad Controller
Follow the instructions on screen to complete the pairing. (p. 19)
  ●Complete First time setup
Completion screen is displayed.
Select type of Home Screen
The “Tutorial” for “my Home Screen” starts.
Follow the instruction of the “Tutorial” to select desired “Home Screen”.
Example: Lifestyle ScreenExample: Home screen selection
•  “Home Screen” is displayed as the start-up screen when the TV is 
turned on or the HOME button is pressed.