Panasonic 58ghz Cordless Phone Manual

Useful Information
31
Wall mounting
Base unit
1
Lead the telephone line cord through 
the hole in the wall mounting adaptor 
in the direction of the arrow.
2Tuck the telephone line cord inside 
the wall mounting adaptor (A). 
Connect the AC adaptor cord and 
telephone line cord (B).
3Insert the hooks on the wall 
mounting adaptor into the holes 1 
and 2 on the base unit.
4Adjust the adaptor to hold the base 
unit, then push it in the direction of 
the arrow until it clicks into place.
A B
Hook
2
1 21...

Useful Information
32
5Connect the telephone line cord. 
Drive the screws (not included) into 
the wall. Mount the unit, and then 
slide it down. Connect the AC 
adaptor to power outlet (page 9).
To remove the wall mounting adaptor
While pushing down the release levers 
(A), remove the adaptor (B).
Charger
1
Drive the screws (not included) into 
the wall.
2Mount the charger (A), then slide it 
down (B) and to the right (C) until it 
is secure.
Available for:
KX-TG4312
(220-240 V AC, 
50/60 Hz)
Screws
83...

Useful Information
33
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display messageCause/solution
Busy
or
System is busy. Please 
try again later.LThe called handset is in use.*1
LAnother handset is in use and the system is 
busy. Try again later.*1
LThe handset you are using is too far from the 
base unit. Move closer and try again.
LThe handset’s registration may have been 
canceled. Re-register the handset (page 38).
Check tel lineLThe supplied...

Useful Information
34
*1 KX-TG4312Phonebook fullLThe phonebook memory is full. Erase 
unnecessary entries (page 18).
Display messageCause/solution
TG4311BX.book  Page 34  Monday, November 10, 2008  9:32 AM 

Useful Information
35
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect 
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the 
batteries from the handset, and then insert the batteries into the handset again.
General use
Programmable settings
Battery recharge
ProblemCause/solution
The unit does not work.LMake sure the batteries are installed correctly 
(page 10).
LFully charge the batteries (page 11).
LCheck the...

Useful Information
36
Making/answering calls, intercomI fully charged the batteries, but 
7 still flashes or 8 is 
displayed.LClean the charge contacts and charge again 
(page 11).
LIt is time to replace the batteries (page 10).
I fully charged the batteries, but 
the operating time seems to be 
shorter.LClean the battery ends (S, T) and the 
charge contacts with a dry cloth, and charge 
again.
ProblemCause/solution
Noise is heard, sound cuts in 
and out.LYou are using the handset or base unit in an...

Useful Information
37
Caller ID
ProblemCause/solution
Caller information is not 
displayed.LYou need to subscribe to Caller ID service. 
Contact your service provider/telephone 
company for details.
LIf your unit is connected to any additional 
telephone equipment such as a Caller ID box 
or cordless telephone line jack, plug the unit 
directly into the wall jack.
LIf you use a DSL/ADSL service, we 
recommend connecting a DSL/ADSL filter 
between the base unit and the telephone line 
jack. Contact your...

Useful Information
38
Registration
ProblemCause/solution
The handset registration may 
have been canceled or the 
communication between the 
base unit and the handset is 
unstable.LRe-register the handset.
1Handset: {MENU} i {#}{1}{3}{0}
2Base unit: Press and hold {LOCATOR} 
for 4 seconds. (No registration tone).
– If another registered handset start 
ringing, press the same button to stop. 
Then repeat this step. (KX-TG4312)
– The next step should be completed 
within 90 seconds.
3Handset: Press {OK},...

Useful Information
39
Dial lock
Important:
LAnyone can turn off the dial lock using the following method. Be sure to 
keep these operating instructions in a safe place in order to prevent 
unauthorized persons from using your phone without permission.
Liquid damage
Caution:
LTo avoid permanent damage, do not use a microwave oven to speed up the drying 
process.
ProblemCause/solution
I cannot remember the dial 
lock password.LTurn the dial lock off using the following method.
1{MENU} i {#}{2}{5}{1}
2Press...

Useful Information
40
Specifications
General
Base unit
Handset
Charger (KX-TG4312)
Note:
LDesign and specifications are subject to change without notice.
LThe illustrations in these instructions may vary slightly from the actual product. Operating
environment5 °C – 40 °C
Frequency5.76 GHz – 5.84 GHz
DimensionsApprox. height 53 mm × width 144 mm × depth 107 mm
Mass (Weight)Approx. 160 g
Power consumptionStandby: Approx. 1.9 W
Maximum: Approx. 5.7 W
RF Transmission
power200 mW (max.)
Power supplyAC adaptor...