Optoma Projector EH505 User Manual

							91 
English   
						

							92
                                                                                                                                                                 
(5 minutes for each step). 
~XX107 n  7E 30 30 31 30 37 20 a 0D                                    Sleep Timer (min)    n = 0 (a=30) ~ 995 (a=39 39 35) 
                                                                                                                                                                   
(30 minutes for each step) .
~XX114 1  7E 30 30 31 31 34 20 31 0D  Power Mode(Standby) Active (
						

							93
Telnet Commands
4 Port: support 3 ports of 23/1023/2023
4 Multi-connections: Projector could receive commands from different ports at the same time
4 Command Format: Follow RS232 command format (support both of ASCII and HEX)
4 Command Response: Follow RS232 return message.
Lead 
Code Projector 
ID Command ID
SpaceVariable Carriage 
Return
~ XXX XX nCR
Fix code 
One 
Digit~ 00 Defined by 
Optoma 2 or 3 
Digit. See the 
Follow content One Digit
Per item 
Definition Fix code 
One 
Digit
v For wide screen resolution (WXGA), the compatibility support is  dependent on Notebook/PC models.
AMX Device Discovery commands
4 DP : 239.255.250.250
4 Port No. : 9131
4 Each UDP broadcast information as below are updated around 40 seconds
Command DescriptionRemark (Parameter)
Device-UUID MAC address (Hex value 
without’ ‘:’ separator) 12 digits
Device-SKDClass The Duet DeviceSdk class name VideoProjector
Device-Make Maker name MakerPXLW
Device-Model Model name Projector
Appendices 
English   
						

							94
CommandDescriptionRemark (Parameter)
Config-URL Device’s IP address
LAN IP address is shown up if 
LAN IP address is valid.
Wireless LAN IP address is 
shown up if Wireless LAN IP 
address is valid. http://xxx.xxx.xxx.
xxx/index.html
Revision The revision must follow a 
major.minor.micro scheme. The 
revision is only increased if the 
command protocol is modified. 1.0.0
v For wide screen resolution (WXGA), the compatibility support is  dependent on Notebook/PC models.
v This AMX function is only to support AMX Device Discovery.
v The broadcast information only send out through valid interface.
v Both LAN and Wireless LAN interfaces could be supported at  the same time.
v If “Beacon Validator” was used. Please take care below   
information.
PJLink™ supported commands
The table below shows commands to control the projector using the 
PJLink™ protocol.
Command Description Remark (Parameter)
Command Description Remark (Parameter)
POWRPower control
0 = Standby
1 = Power on
POWR? Inquiry about the 
power state 0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
INPT INPT Input switching
11 = VGA1
Appendices 
English   
						

							95
CommandDescription Remark (Parameter)
INPT?Inquiry about input 
switching 12 = VGA2
13 = Component
14 = BNC
21 = VIDEO
22 = S-VIDEO
31 = HDMI 1
32 = HDMI 2
AVMT Mute control 30 = Video and audio mute 
disable
AVMT? Inquiry about the 
mute state 31 = Video and audio mute enable
ERST? Inquiry about the 
error state 1st byte: Fan error, 0 or 2
2nd byte: Lamp error, 0 to 2
3rd byte: Temperature error, 0 
or 2
4th byte: Cover open error, 0 or 2
5th byte: Filter error, 0 or 2
6th byte: Other error, 0 or 2
0 to 2 mean as follows:
0 = No error detected, 1 = 
Warning, 2 = Error
LAMP? Inquiry about the 
lamp state 1st value (1 to 5 digits): 
Cumulative LAMP operating 
time (This item shows a lamp 
operating time (hour) calculated 
based on that LAMP MODE is 
LOW.)
2nd value: 0 = Lamp off, 1 = Lamp 
on
INST? Inquiry about the 
available inputs The following value is returned.
“11 12 21 22 31 32”
NAME? Inquiry about the 
projector name The projector name set on 
the NETWORK menu or the 
ProjectorView
Setup window is returned
INF1? Inquiry about the 
manufacturer name “Optoma” is returned.
INF2? Inquiry about the 
model name “EH7700” is returned.
v This projector 
is fully 
compliant 
to the 
specifications 
of JBMIA 
PJLink™ 
Class 1. It 
supports all 
the commands 
defined by 
PJLink™ Class 
1, and the 
compliance 
has been 
verified with 
the PJLink™ 
standard 
specifications 
Version 1.0.
Appendices 
English   
						

							96
CommandDescription Remark (Parameter)
INF0?Inquiry about other 
information No other information is available. 
No parameter is returned.
CLSS? Inquiry about the 
class information “1” is returned.
Trademarks
4 DLP is trademarks of Texas Instruments.
4 IBM is a trademark or registered trademark of International 
Business Machines Corporation.
4 Macintosh, Mac OS X, iMac, and PowerBook are trademarks of Apple Inc., registered in the U.S. and other countries.
4 Microsoft, Windows, Windows Vista, Internet Explorer and PowerPoint are either a registered trademark or trademark of 
Microsoft Corporation in the United States and/or other countries.
4 HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.
4 AMX Device DiscoveryThe pro.jector is monitored and controlled by the control system of 
AMX.
4 Crestron RoomView Connected™The projector is monitored and controlled by the control system and 
software of Crestron Electronics, Inc.
4 PJLink™PJLink trademark is a trademark applied for registration or is 
already registered in Japan, the United States of America and other 
countries and areas.
This projector supports standard protocol PJLink™ for projector 
control and you can control and monitor projector’s operations 
using the same application among projectors of different models 
and different manufacturers.
4 Other product and company names mentioned in this user’s manual may be the trademarks or registered trademarks of their 
respective holders.
4 About Crestron RoomView Connected™Electronics, Inc. to facilitate configuration of the control system of 
Crestron and its target devices.
For details, see the website of Crestron Electronics, Inc.
URL http://www.crestron.com
URL http://www.crestron.com/getroomview/
Appendices 
English   
						

							97
Ceiling Installation
To prevent damage to your projector please use the recommended 
mounting package for installation.
To ensure compliance, only use a UL Listed ceiling mount and 
screws that meet the following specifications:
4 Screw Type: M4
4 Maximum screw length: 11 mm
4 Minimum screw length: 9 mm
Refer to the following diagram to ceiling mount the projector.
68.50 100.00
160.50 141.50
141.50
88.00
26.50
165.00 354.41
85.49
20.00
130.00
240.00
260.00 430.97
( 1.024 )
( 1.697 )
( 0.945 )
( 0.512 )
( 0.079 ) ( 0.337 )
( 0.557 )
( 0.632 ) 160.50
( 0.632 )
( 0.557 )
( 0.270 )
( 0.394 )
( 0.650 ) ( 1.395 )
( 0.104 ) ( 0.346 )
v Damage to the 
projector as a 
result of   
incorrect   
installation 
voids the   
warranty. 
v Ensure at least  10cm clearance 
between the 
ceiling and the 
underside of 
the projector.
v Avoid locating  the projector 
near heat   
sources such as 
air conditioning 
and heaters. 
Excess heat 
may cause the 
projector to 
power off.
Appendices 
English   
						

							98
Optoma Global Offices
For service or support please contact your local office.
USA
3178 Laurelview Ct.
Fremont, CA 94538, USA
Tel : 888-289-6786    Fax : 510-897-8601
www.optomausa.com    Service : [email protected]
Canada
2420 Meadowpine Blvd., Suite #105
Mississauga, ON, L5N 6S2, Canada
Tel : 888-289-6786    Fax : 510-897-8601
www.optoma.ca   Service :  [email protected]
Europe
42 Caxton Way, The Watford Business Park  
Watford, Hertfordshire, WD18 8QZ, UK
Tel : +44 (0) 1923 691 800   Fax : +44 (0) 1923 691 888
www.optoma.eu
Service Tel : +44 (0)1923 691865  Service : [email protected]
France
Bâtiment E 81-83 avenue Edouard Vaillant 
92100 Boulogne Billancourt, France
Tel.: +33 1 41 46 12 20    Fax : +33 1 41 46 94 35
Service : [email protected]
Spain
C/ José Hierro,36 Of. 1C 
28522 Rivas VaciaMadrid, Spain
Tel.: +34 91 499 06 06    Fax : +34 91 670 08 32
Deutschland
Werftstrasse 25 D40549  
Düsseldorf, Germany
Tel : +49 (0) 211 506 6670   Fax : +49 (0) 211 506 66799
Service : [email protected]
Appendices 
English   
						

							99
Scandinavia
Optoma Scandinavia AS
Lerpeveien 25
3040 Drammen
Norway 
PO.BOX 9515 
3038 Drammen 
Norway
Tel : +4732988990    Fax : +4732988999
Service : [email protected]
Latin America
3178 Laurelview Ct. 
Fremont, CA 94538, USA
Tel : 888-289-6786     Fax : 510-897-8601
www.optomausa.com.br   Service : www.optomausa.com.mx
Korea
WOOMI TECH.CO.,LTD 
4F,Minu Bldg.3.tw3-14, Kangnam-Ku, seoul,135-815, KOREA
Tel : +82+2+34430004    Fax : +82+2+34430005
Japan
東京都足立区綾瀬3-25-18
株式会社オーエスエム
サポートセンター:0120-46-5040
E-mail : [email protected] www.os-worldwide.com
Taiwan
231, 新北市新店區北新路3段215號12樓
Tel : +886-2-8911-8600    Fax : +886-2-8911-9770
www.optoma.com.tw   asia.optoma.com
Service : [email protected]
Hong Kong
Unit A, 27/F Dragon Centre, 79 Wing Hong Street,  
Cheung Sha Wan, Kowloon, Hong Kong
Tel : +852-2396-8968    Fax : +852-2370-1222
www.optoma.com.hk
China
5F, No. 1205, Kaixuan Rd., Changning District  
Shanghai, 200052, China
Tel : +86-21-62947376    Fax : +86-21-62947375
www.optoma.com.cn
Appendices 
English   
						

							100
Regulation & Safety notices
This appendix lists the general notices of your projector.
FCC notice
This device has been tested and found to comply with the limits for 
a Class B digital device pursuant to Part 15 of the FCC rules. These 
limits are designed to provide reasonable protection against  
harmful interference in a residential installation. This device  
generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a 
particular installation. If this device does cause harmful  
interference to radio or television reception, which can be  
determined by turning the device off and on, the user is  
encouraged to try to correct the interference by one or more of the 
following measures:
4 Reorient or relocate the receiving antenna.
4 Increase the separation between the device and receiver.
4 Connect the device into an outlet on a circuit different from that  to which the receiver is connected.
4 Consult the dealer or an experienced radio/television technician for help.
Notice: Shielded cables
$OO FRQQHFWLRQV WR RWKHU FRPSXWLQJ GHYLFHVPXVWEH
PDGHX VLQJV KLHOGHG FDEOHVWRP DLQWDLQ FRPSOLDQFH 
ZLWK)&&UHJXODWLRQV
Caution
 FDWLRQVQRWH[SUHVVO\DSSURYHGE\WKH
PDQXIDFWXUHU FRXOGYRLGWKHXVHU¬V DXWKRULW\ ZKLFKLV
JUDQWHG E\WKH )HGHUDO &RPPXQLFDWLRQV &RPPLVVLRQ 
WRRSHUDWHWKLVSURMHFWRU
Appendices 
English