Optoma Ep719 Projector User Manual

11... English
™To ensure the projector works well with your computer, please
set the display mode of your graphic card less than or equal to
1024 X 768 resolution. Make sure the timing of the display mode is
compatible with the projector.  Refer to the “Compatibility Modes”
section on page 38.
S-Video OutputVideo Output DVD Player,
Settop Box,
HDTV receiver
6
8
1
7
RGB
1. .............................................................................................................Power Cord
2....

12English ...
Installation
Powering On the Projector
1.Remove the lens cap. n
2.Ensure that the power cord and signal cable are securely
connected.  The Power LED will flash green.
3.Turn on the lamp by pressing “Power/Standby” button on
the control panel.o And the Power LED will turn green.
The first time you use the projector, you can select your
prefered language from quick menu after the startup
screen display.
4.Turn on your source (computer, notebook, video player,
etc.).  The projector will detect...

13... English
Warning Indicator
™When the “LAMP” indicator lights solid red, the projector will
automatically shut itself down. Please contact your local
reseller or service center. See page 35~36.
™When the “TEMP” indicator lights solid red for about 10
seconds, it indicates the projector has been overheated. The
projector will automatically shut itself down.
Under normal conditions, the projector can be switched on
again after it has cooled down.  If the problem persists, you
should contact your local...

14English ...
Installation
Adjusting the Projected Image
Adjusting the Projector Image Height
Tilt Adjusting
Wheel Elevator Foot
23
Elevator Button
The projector is equipped with an elevator foot for adjusting
the image height.
To raise the image:
1.Press the elevator button 
n.
2.Raise the image to the desired height angle o, then release
the button to lock the elevator foot into position.
3.Use 
p to fine-tune the display angle.
To lower the image:
1.Press the elevator button.
2.Lower the image, then...

15... English
69.3
(176.1cm)115.6
(293.5cm)161.8
(410.9cm)184.9
(469.6cm)231.1
(587.0cm)
38.1 
(96.8cm)76.2
(193.6cm)127.1
(322.7cm)177.9
(451.8cm)203.3
(516.3cm)254.1
(645.4cm)
4.92
32.81 26.25 22.97 16.409.84(1.5m)
(10.0m) (8.0m) (7.0m) (5.0m) (3.0m)34.7
(88.1cm)
Max.38. 1(96.8cm)76. 2(193. 6cm)127.1(322.7cm)177.9(451.8cm)203.3(516.3cm)254.1(645.4cm)
Min. 34. 7(88.1cm) 69. 3(176. 1cm) 115. 6( 293. 5cm) 161.8(410.9cm) 184.9(469.6cm) 231.1(587.0cm)
Max.(WxH)30. 48 x 22.86
(77. 4 x 58. 1cm)60. 96 x 45.72...

16English ...
Remote Control Control Panel
Control Panel & Remote Control
There are two ways for you to control the functions: Remote
Control and Control Panel.
Using the Control Panel
Power/Standby  
4Refer to the “Power On/Off the Projector” section on pages
12-13.
Source
4Press “Source” to choose RGB, Component-p, Component-i,
S-Video, Composite Video and HDTV sources.
Menu 
4Press “Menu” to launch the on screen display (OSD) menu.
To exit OSD, press “Menu” again.
Keystone   / 
4Adjusts image...

17... English
Installation
Using the Remote Control
Power
4Refer to the “Power On/Off the Projector” section on pages
12-13.
Re-Sync
4Automatically synchronizes the projector to the input source.
Volume + / - (Vol+/Vol-)
4Increases/decreases speaker volume.
Reset
4Changes the adjustments and settings to the factory default
value.
Hide
4Press “Hide” to hide image, press again to restore display of the
image.
Keystone   / 
4Adjusts image distortion caused by tilting the projector (±15
degrees).
Freeze...

18English ...
Composite
4Press “composite” to choose Composite video source.
VGA
4Press “VGA” to choose VGA connector.
DVI-D
4Press “DVI-D” to choose DVI connector.
Installation
USA
USA   

19... English
The Projector has multilingual On Screen Display menus
that allow you to make image adjustments and change a
variety of settings. The projector will automatically detect
the source.
How to operate
1.To open the OSD menu, press “Menu ” on the Remote Control
or Control Panel.
2.When OSD is displayed, use     keys to select any item in the
main menu.  While making a selection on a particular page, press
 or “Enter” key to enter sub menu.
3.Use      keys to select the desired item and adjust...

20English ...
User Controls
Menu Tree