OKI C8600cdtn User Manual

							Clearing paper jams> 101
PAPER SENSOR ERROR CODES
* (if fitted).
1.If a sheet is well advanced out of the top of the printer, 
simply grip it and pull gently to draw it fully out. If it does 
not remove easily, do not use excessive force. It can be 
removed from the rear later.
2.Press the cover release and open the printer’s top cover 
fully.
CODE #LOCATIONCODE #LOCATION
370 Duplex unit * 383 Duplex unit *
371Duplex unit *385Fuser Unit
372 Duplex unit * 390 MP Tray
373Duplex unit *391Paper Tray
380 Paper feed 392
2
nd Paper tray *
381Paper path400Paper size
382 Paper exit
370
373
382
383
381
372 371
391
392
380, 400 
390
385
WARNING!
If the printer has been powered on, the fuser will be hot. 
This area is clearly labelled. Do not touch.
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 102
3.Note the positions of the four cartridges.
It will be necessary to remove the four image drums to gain 
access to the paper path.
4.Holding it by its top centre, lift the cyan image drum, 
complete with its toner cartridge, up and out of the 
printer.
1
2
3
4
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 103
5.Put the cartridge down gently onto a piece of paper to 
prevent toner from marking your furniture and to avoid 
damaging the green drum surface.
6.Repeat this removal procedure for each of the remaining 
image drum units.
7.Look into the printer to check whether any sheets of paper 
are visible on any part of the belt unit.
>To remove a sheet with its leading edge at the front of the 
belt (1), carefully lift the sheet from the belt and pull it 
forwards into the internal drum cavity and withdraw the 
sheet.
CAUTION!
The green image drum surface at the base of the 
cartridge is very delicate and light sensitive. Do not 
touch it and do not expose it to normal room light for 
more than 5 minutes.
4
2 3
1
CAUTION!
Do not use any sharp or abrasive objects to separate 
sheets from the belt. This may damage the belt surface.
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 104
>To remove a sheet from the central area of the belt (2), 
carefully separate the sheet from the belt surface and 
withdraw the sheet.
>To remove a sheet just entering the fuser (3), separate 
the trailing edge of the sheet from the belt, push the fuser 
pressure release lever (4) towards the front and down to 
release the fuser’s grip on the sheet, and withdraw the 
sheet through the drum cavity area. Then allow the 
pressure release lever to rise again.
4
2 3
1
NOTE:
If the sheet is well advanced into the fuser (only a short 
length is still visible), do not attempt to pull it back. Follow the 
next step to remove it from the rear of the printer.
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 105
8.Starting with the cyan image drum unit nearest the fuser, 
replace the four image drums into the drum cavity, 
making sure to locate them in the correct order.
• Holding the complete assembly by its top centre, lower 
it into place in the printer, locating the pegs at each 
end into their slots in the sides of the printer cavity.
1
2
3
4
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 106
9.Lower the top cover but do not press down to latch it 
closed yet. This will protect the drums from excessive 
exposure to room lighting while you check the remaining 
areas for jammed sheets.
10.Open the rear exit tray (5) and check for a sheet of paper 
in the rear path area (6).
• Pull out any sheets found in this area.
• If the sheet is low down in this area and difficult to 
remove, it is probably still gripped by the fuser. In this 
case raise the top cover, reach around and press down 
on the fuser pressure release lever (4).
11.If you are not using the rear exit tray, close it once paper 
has been removed from this area.
6
5
4
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 107
12.Open the duplex unit cover (if installed) and remove any 
sheets in this area.
13.Lift the front cover release and pull down the front cover.
a
b
b
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 108
14.Check inside the cover for sheets in this area and remove 
any that you find, then close the cover.
15.Pull out the paper tray and ensure that all paper is 
stacked properly, is undamaged, and that the paper 
guides are properly positioned against the edges of the 
paper stack. When satisfied, replace the tray.
Downloaded From ManualsPrinter.com Manuals 
						

							Clearing paper jams> 109
16.Finally, close the top cover and press down firmly at both 
sides so that the cover latches closed.
When the jam has been cleared, if Jam Recovery is set to ON in 
the System Configuration Menu, the printer will attempt to 
reprint any pages lost due to paper jams.
Downloaded From ManualsPrinter.com Manuals 
						

							Specifications> 110
SPECIFICATIONS
C8600 - N34210B
ITEMSPECIFICATION
Dimensions 485 x 556 x 345mm (W x D x H) without Duplex 
unit
Weight40Kg approx. (without Duplex unit)
Print method LED exposed light source electronic photographic 
memory
Print speeds26 pages per minute colour / 32 pages per minute 
monochrome
Resolution 600 x 600, 1200 x 600dpi or 600 x 600dpi x 2bit 
(ProQ2400)
Auto FeaturesAuto registration
Auto density adjustment
Auto consumable counter reset
Memory 128MB
Operating 
platformWindows
98/Me/2000/XP/XP Pro x64 bit Edition*/NT4.0 /
Server 2003/Server 2003 x64 bit Edition*,
* x86-64 processors only. Itanium is not 
supported.
Mac
OS 9.0 (or higher), OS X (10.2 or higher), Classic
Paper capacity
at 80g/m²300 sheets in main tray
530 sheets in optional 2nd tray
100 sheets in multi purpose tray (or 50 
transparencies or 10 envelopes)
Paper weight64 ~ 120g/m² in main tray
64 ~ 120g/m² in 2nd tray
64 ~ 203g/m² in multi purpose tray
Paper output 250 sheets in face down (top) stacker @ 80g/m²
100 sheets in face up (rear) stacker @ 80g/m²
Paper feed *1Paper tray, manual feed, optional additional paper 
tray(s)
Media size - 
any trayA3, A4, A5, A6 (tray 1 only), B5, Legal 13/13.5/14 
inch, letter, Executive.
Media size - MP 
trayA4, A5, A6, B5, Legal 13/13.5/14 inch, letter, 
executive, custom (up to 1200mm length), com-9 
envelope, com-10 envelope, monarch envelope, DL 
envelope, C5 envelope 
Downloaded From ManualsPrinter.com Manuals