Home > Nortel > Communications System > Nortel Modular Ics 6.1 Installer Guide

Nortel Modular Ics 6.1 Installer Guide

Here you can view all the pages of manual Nortel Modular Ics 6.1 Installer Guide. The Nortel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 221

Installation / 221
P0603534  02Modular ICS 6.1 Installer Guide
åensure that all relevant documentation is left with the 
person in charge of the system
åtrain the Administrator using the Getting Started section in 
the Modular ICS 6.1 System Coordinator Guide
åfor information on upgrading your ICS without adding 
digital T1, see Trunk and Station Modules on page 210. 
To avoid electrical shock hazard to personnel or 
equipment damage, observe the following 
precautions when installing telephone...

Page 222

222 / Installation
Modular ICS 6.1 Installer GuideP0603534  02
Testing the ISDN BRI network connection
Before you install a Norstar system which uses BRI cards you 
should test your connection to the ISDN network. 
If you are installing a system which connects to the network 
using BRI-ST cards, the network connection must be equipped 
with an NT1. See the ISDN chapter and the wiring information 
in this chapter for more information about installing an NT1. 
To test the ISDN BRI connection:
1. Connect...

Page 223

Installing the cartridges / 223
P0603534  02Modular ICS 6.1 Installer Guide
Installing the cartridges
The following table shows you which cartridges can be 
installed in which ICS and TM slots.
Note: Use Slot 1 only when installing cartridges for 12-port, fully 
expanded systems. In this case, both slots 1 and 2 are installed with 
6-port Expansion or a Combination Fiber 6-port Services Cartridge. 
If you use both slot 1 and 2, the software must be MICS-XC.
Cartridge type ICS Slot  TM Slot
Modular ICS...

Page 224

224 / Installing the cartridges
Modular ICS 6.1 Installer GuideP0603534  02
• LS/DS Global Analog Trunk Cartridges and CI Global 
Analog Trunk Cartridges both support loop start external 
lines.
• The Digital trunk Interface (DTI) supports both digital T1 
and PRI lines. The DTI card can be configured to support 
ISDN PRI. Systems running Profile 1 or 4 can support 1 
off-core DTI module.
• The Loop Start Trunk Cartridge supports loop start 
external lines.
• The E&M Trunk Cartridge supports E&M lines...

Page 225

Mounting the modules / 225
P0603534  02Modular ICS 6.1 Installer Guide
Mounting the modules 
Attach bracket to secure surface.
Do not screw bracket directly to drywall. Use the two 
inner screw holes on the bracket.
faa
C100 Controller
Trunk Module
19mm (3/4) in
wood screws
38mm
(1-1/2 in)
wood screws 

Page 226

226 / Mounting the modules
Modular ICS 6.1 Installer GuideP0603534  02
1. Secure a 19 mm wood backboard to a wall. It must be 
capable of supporting a 20 kg mass. 
2. Position the module mounting bracket on the backboard, 
smooth side against the backboard, with the screw holes at 
the top. Ensure that the bracket is level.
3. Fasten the bracket to the backboard with two 3/4-inch 
No. 10 round head wood screws through the inner pair of 
holes. The other two holes are optional.
4. Slide the module down...

Page 227

Mounting the modules / 227
P0603534  02Modular ICS 6.1 Installer Guide
Installation tips
• For a two-port (midi) system, a two-port fiber Expansion 
Cartridge is installed only in ICS slot 2.
• For a six-port (maxi) system, a six-port fiber Expansion 
Cartridge or a Combination Fiber six-port Services 
Cartridge is installed only in ICS slot 2.
• When a six-port fiber Expansion Cartridge is installed in 
ICS slot 2, either an additional six-port fiber Expansion 
Cartridge, for a fully analog trunk...

Page 228

228 / Mounting the modules
Modular ICS 6.1 Installer GuideP0603534  02
• One two-port copper Expansion Cartridge is supported for 
a midi configuration and can only be installed in slot 1.
• Depending on your system configuration, BRI-ST, 
BRI-U2, BRI-U4, the off-core DTI cards can only reside 
in certain trunk modules. In a midi system, the cards must 
be in trunk modules 3 or 4, for a maxi or mega system, the 
cards must be in trunk modules 7 or 8. The cards can reside 
in the ICS regardless of system...

Page 229

Installing the ROM Software Cartridge / 229
P0603534  02Modular ICS 6.1 Installer Guide
Installing the ROM Software Cartridge
 NVRAM cartridge
MICS NVRAM cartridge
MICS ROM 
software cartridge 

Page 230

230 / Installing the ROM Software Cartridge
Modular ICS 6.1 Installer GuideP0603534  02
MICS ROM software cartridge
Side view End view
Insert this end into the ICS 
Start reading Nortel Modular Ics 6.1 Installer Guide

Related Manuals for Nortel Modular Ics 6.1 Installer Guide

All Nortel manuals