Nortel Compact Ics 6.1 Programming Record Manual

							Page  81
P0603545   02Compact ICS 6.1 Programming Record
 AlarmSetting that allows the installer to configure the Alarm operation.
 Attn attempts:Number of times the Alarm time feature attempts to get the attention of the 
occupant before cancelling.
 Retry intrvlThe interval period in minutes, between each Alarm attempt.
 Attn durationThe period programmed in seconds for which a set alerts on each alarm 
attempt.
 Time formatChoose if alarm times are entered using a 12 hour or 24 hour clock.
 Expired AlarmsThese commands allow you to determine how the system will notify you about 
expired alarms.
 Notify setUse this command to choose whether the set where the alarm was 
programmed will be notified if the alarm expires.
 Use ToneUse this command to choose what tone will be used if the set is notified that 
an alarm has expired.
Network Services (profile 2)This section allows you to set the available system features for ETSI lines.
 ETSIEnter the telephone numbers (up to 24 digits) of the voice message centers. 
You can enter numbers for up to five voice message centers.
 MCIDThe Malicious Call Identification feature allows a user to record caller 
information at the service provider.
 NCDNetwork Call Redirection allows users to redirect calls outside of the local 
system. (This is the equivalent to external call forward in the other profiles).
SM SetsIndicate the number of silent monitoring telephones that you want to allow in 
your system (1 - 30). Note that telephones that have been allowed as SM 
supervisors cannot be monitored.
Telco featuresThis programming section lets you assign settings for external voice 
messaging services.
 VMsg ctr tel#s
 VMsg center 1
 Te l #
 VMsg center 2
 VMsg center 3
 VMsg center 4
 VMsg center 5Enter the telephone numbers (up to 24 digits) of the voice message centers. 
You can enter numbers for up to five voice message centers.
 ONN blockingAllow s outgoing name and number to be blocked at the called party end on 
both analog and digital lines.
 Analog VSCAnalog Vertical service code.
 ToneVertical service code for analog tone dialing trunks.
 PulseVertical service code for analog pulse dialing trunks.
 BRI VSCBasic Rate Interface Vertical service code.
 Code: 
						

							Page  82
Compact ICS 6.1 Program ming RecordP0603545   02
Software Keys In this section, you can access optional features and services.
 SysIDThis number can be viewed on any M7324, M7310, or T7316 telephone 
display. Record the number,  which you will be asked to provide when you call 
the Nortel Customer Response Center.
 Password KeysThe keys are obtained by calling the Nortel Customer Response Center at 1-
800-321-2649. The keys are required for some system expansion activities 
and to activate the remote 
monitoring capability.
 Key 1Enter the eight-digit password.
 Key 2Enter the eight-digit password.
 Key 3Enter the eight-digit password.
HardwareIn this section, you can view and configure the Trunk Cartridges and BRI 
Cards installed in the ICS.
 Cd1-KSUConfigure the cartridge or card that occupies the left-most slot in the ICS.
 Card typeThe display shows the current card type.
 LinesView the line-number range for the lines on an LS/DS or CI Analog Trunk 
Cartridge.
 Discon timerSpecify the duration of an Open Switch Interval for an LS/DS or CI Analog 
Trunk Cartridge.
 LoopsView the loops on this BRI Card.
 LoopView the settings for a particular loop on this BRI Card.
 Ty p eView or change the loop type.
 LinesView the lines on this loop (only for S, T, and U-NT loops).
 No SPIDs assigndAssign one or two service profile identifiers (SPIDs) as supplied by your 
service provider. SPID settings appear only for S, T, and U-NT loops.
 SPID1Enter the SPID supplied by your service provider.
 # of B-channlsSelect the number of B-channels that are associated with the SPID.
 Network DNsEnter the Network DNs that are associated with the SPID.
 Call typeSelect the Call type used with the Network DN. For each Network DN, use 
only one of each of the Voice and Data call type settings, or a single Both call 
type setting. 
 SPID2Enter the second SPID supplied by your service provider, if applicable.
 D-packet srvceConfigure the D-packet service for this loop.
 D-packet srvcTurn the D-packet service for this loop on or off.
 Lp201Select the S-loop (for BRI-ST Card) or U-LT loop (for BRI-U2 or BRI-U4 Card) 
that supports the D-packet service.
 TEIsAdd up to eight Terminal Endpoint Identifiers (TEIs). Each TEI is supplied by 
your service provider and is associated with an ISDN device.
 No TEIs on loopEnter the two-digit TEIs supplied by your service provider. 
						

							Page  83
P0603545   02Compact ICS 6.1 Programming Record
 ONN blkDetermine the ONN blocking for BRI loops.
 SamplingSelect the sampling used by an S loop.
 DNs on Loop 201Assign the ISDN DNs that use this S loop or U-LT loop.
 Assign DNsEnter up to seven ISDN DNs for each S loop or U-LT loop.
 Loop DNDesignate one of the ISDN DNs assigned to the loop as the main ISDN DN.
 Cd2 on KSUSelect the type of cartridge or  card that occupies the second slot in  the ICS 
(The slots are numbered from left to right). If your system is using restricted 
software which has not been upgraded, this setting does not appear.
MaintenanceThis programming section lets you make diagnostic checks on the system.
 System versionRecord the system version shown on the display after entering the 
maintenance section.
 Por t/DN statusView the Port/DN status.
 Module status View the Module status.
 Sys test logView items in Sys test log.
 Sys admin logView items in log.
 ProvisioningPlace BRI loops in or out of service.
 Te s t sRun and list any BERT set tests.
 Remote montrSelect whether or not the system can be monitored remotely.
Usage metricsThis section allows you to gather statistical information on Hunt group usage.
 Hunt groups 
						

							Page  84
Compact ICS 6.1 Program ming RecordP0603545   02 
						

							Meridian, Norstar, and Companion are trademarks of No rtel Networks Corporation.
Meridian Norstar Business Communication System is manufactured by Nor tel Networks Corporation.
This document is for use with Norstar Compact ICS 6.1.
© 2003 Nortel Networks Corporation
All rights reserved
P0603545   02
Printed in Canada