Nortel Bcm Ata 2 Instructions Manual

Feature List  11
P0908546 Issue 01 Enterprise Edge ATA 2 User Guide
Priority Call
û¥á
Allows you to interrupt an internal call in progress on a digital telephone, or make 
a voice call to a digital telephone on Voice Call Deny or Do Not Disturb. The 
session in progress is automatically put on hold.
Note:Priority Call must be enabled in Enterprise Edge System Administration.
Privacy Control
û¥¡Ü
Prevents another telephone that shares your line from joining your current call or 
permits another telephone...

12  Feature List
Enterprise Edge ATA 2 User Guide P0908546 Issue 01
Saved Number Redial
û¥ßà
Allows you to save an external number while you are on a call or while the called 
telephone is ringing. To automatically redial the saved number:
1. Press û¥à.
Send Message
û¥Ú
Allows you to leave a message on a co-worker’s telephone.
To cancel send message, press û£Ú.
Ser vice Mode
In service mode the Enterprise Edge ATA 2 telephone can be assigned as the control 
telephone for one or more lines, or as the...

Feature List  13
P0908546 Issue 01 Enterprise Edge ATA 2 User Guide
Tr a n s f e r
Allows you to transfer a call. To transfer a call you must have an available intercom 
line.
Blind Transfer
1. Press û¥àâ. 
2. Press the transfer destination number.
3. Replace the handset.
Transfer using announce
1. Press û¥àâ (intercom dial tone is heard).
2. Press the transfer destination number.
3. Announce the call to the receiving party (optional).
4. Replace the handset.
Transfer using Conference
1. Press ûÛ.
2....

14  Feature List
Enterprise Edge ATA 2 User Guide P0908546 Issue 01
Trunk Answer from any Telephone
û¥¡ââ
Allows you to pick up a ringing external call on a line that has been placed into any 
service mode.
Vo i c e  C a l l
û¥ßß 
Allows you to make a voice announcement or begin a conversation through the 
speaker of a digital telephone without making the other telephone ring. 

P0908546 Issue 01 Enterprise Edge ATA 2 User Guide
Data Communication
This section supplies additional information for using Enterprise Edge Analog 
Terminal Adapter 2 with data communication devices.
Set Tones to OFF 
Enterprise Edge ATA 2 must have tones OFF so tones do not interfere with data 
transmissions.
The following progress tones are not heard when Enterprise Edge ATA 2 is in the 
tones OFF mode:
• Held Line Reminder
• Call Waiting
• Ring Again 
To turn tones OFF:
Lift the handset and press...

16  Data Communication
Enterprise Edge ATA 2 User Guide P0908546 Issue 01 

P0908546 Issue 01 Enterprise Edge ATA 2 User Guide
Troubleshooting for Data Applications
If you are having trouble, check the following before calling a repair person:
1. Make sure the data parameters (parity, baud) are set correctly.
2. Make sure Enterprise Edge Analog Terminal Adapter 2 is in the tones OFF 
mode.
3. Make sure you are dialing out on the proper line. The proper line is either an 
intercom or external line. See Alternate Line
 on page 6 of the Feature List. To 
change your prime line, see...

18  Troubleshooting for Data Applications
Enterprise Edge ATA 2 User Guide P0908546 Issue 01