Nikon Coolpix S630 User Manual

9
Basic Operations
Introduction
The c (playback) Button
Playback-mode Selection MenuThe rotary multi selector can be used  in the playback-mode selection menu to 
change the playback mode. To exit the playback-mode selection menu, choose a 
playback mode and press the  k button or press the  c button again.
•
Press the  c button in shooting mode to change to 
playback mode.
• Press the  c button in playback mode to display the 
playback-mode selection menu.
• When the camera is off, holding down the  c...

10
Basic Operations
Introduction
The Rotary Multi Selector
This section describes standard uses of the rotary multi selector to select modes, 
select menu options, and to apply selection.
For Shooting
* Options can also be chosen by pressing the rotary multi selector up or down.
For Playback
* Subsequent or previous pictures can also be selected by rotating the rotary multi selector.
Flash mode
Display o 
(exposure compensation) 
( A 34) guide
Display 
n (self-timer) 
( A 32) menu Display 
m (flash...

11
Basic Operations
Introduction
For the Menu Screen
* Options can also be chosen by rotating the rotary multi selector.
CNote on the Rotary Multi Selector
In this manual, up, down, left, and right presses of the rotary multi selector may be indicated with H, 
I , J  and  K.
Scene auto selector
Shooting menu
Image mode
MeteringContinuous
ISO sensitivityExit
White balanceApply selection
(advance display to the next 
screen)
Choose the option 
on the left*/
Return display to the 
previous screen Choose...

12
Basic Operations
Introduction
The d Button
Press the  d button to display the menu for the chosen mode.
• Use the rotary multi selector to navigate the menus  ( A11).
• Choose the  z tab on the left to display the setup menu.
• Press the  d button again to exit the menu.
Switching Between Tabs
Shooting menu
Image mode
White balance
Metering
Continuous
ISO sensitivity
Exit
The selected option
Displayed when the menu contains two or more pages
Displayed when there are one 
or more menu options to...

13
Basic Operations
Introduction
Help Displays
Rotate the zoom control to g (j ) when  M/L  is displayed at the bottom of the 
menu screen to view a description of the currently selected menu option.
To return to the original menu, rotate the zoom control to  g (j ) again.
Pressing the Shutter-Release Button Halfway/All the Way 
Down
The camera features a two-stage shutter-release button. To set focus and exposure, 
press the shutter-release button halfway, stopping when you feel resistance. Focus 
and...

14
First Steps
First Steps
Charging the Battery
Charge the Rechargeable Li-ion Battery EN-EL12 (supplied) using the Battery 
Charger MH-65 (supplied).
1Connect the power cable in the order of  1-2 .
2Insert the battery into the battery charger 
by sliding the battery forward  1, and 
press down until it locks into place  2.
•CH AR GE lam p sta r ts b link in g w hen  ch arging sta r ts.
• Charging is complete when the lamp stops 
blinking.
• About 150 minutes are required to charge a fully 
exhausted...

15
Charging the Battery
First Steps
The following chart explains CHARGE lamp status.
3Remove the battery and unplug the charger.
BNotes on the Battery Charger
•The supplied battery charger is for use only with a Rechargeable Li-ion Battery EN-EL12. Do not use 
with incompatible batteries.
• Be sure to read and follow the warnings and cautions of “For Your Safety” ( Aii) thoroughly before 
using the battery charger.
BNotes on the Battery
• Be sure to read and follow the warnings and cautions of “For Your...

16
First Steps
Inserting the Battery
Insert a Rechargeable Li-ion Battery EN-EL12 (supplied) into the camera.
•Charge the battery before first use or when the battery is running low ( A14).
1Open the battery-chamber/memory card slot 
cover.
2Insert the battery.
•Confirm that the positive (+) and negative (–) terminals 
are oriented correctly, as shown on the label at the 
entrance of the battery chamber, and insert the battery.
• Use the battery to push the orange battery latch in the 
direction...

17
Inserting the Battery
First Steps
Removing the Battery
Tu r n t he  c am e ra of f and confirm that the power-on 
lamp and the monitor are off before opening the 
battery-chamber/memory card slot cover. 
To eject the battery, open the battery-chamber/
memory card slot cover and slide the orange battery 
latch in the direction shown  1. The battery can then be 
removed by hand  2.
• Note that the battery may become hot during use; 
observe due caution when removing the battery.
Turning On and Off the...

18
First Steps
Setting Display Language, Date and Time
A language-selection dialog is displayed the first time the camera is turned on.
1Press the power switch to turn on the camera.
•The power-on lamp (green) will light for a moment and 
the monitor will turn on.
2Use the rotary multi selector to 
choose the desired language and 
press the  k button.
•For information on using the rotary multi 
selector, see “The Rotary Multi Selector” 
(A 10).
3Choose  Ye s and press the  k button.
•If No  is selected,...