Nikon Camera D810 Users Manual

377
Select Save settings  to save the following settings to the 
memory card, or to the memory ca rd in the primary card slot if 
two memory cards are inserted ( 086; if the card is full, an error 
will be displayed).
 Use this option to share settings among D810 
cameras.
Save/Load Settings
G  button ➜Bsetup menu
MenuOption
Playback Playback display options
Image review
After delete
Rotate tall
Shooting 
(all banks) Shooting menu bank
Extended menu banks
File naming
Primary slot selection
Secondary slot...

378
Settings saved using this model of camera can be restored by 
selecting Load settings .
 Note that Save/load settings  is only 
available when a memory card is inserted in the camera, and 
that the  Load settings  option is only available if the card 
contains saved settings.
Shooting 
(all banks) High ISO NR
ISO sensitivity settings
Movie settings
Custom settings  (all banks) All Custom Settings
Setup Clean image sensor
Flicker reduction
Time zone and date (exc
epting date and time)
Language
Auto...

379
Display roll and pitch information based on information from 
the camera tilt sensor.
 If the camera is tilted neither left nor 
right, the roll reference line will turn green, while if the camera is 
tilted neither forward nor back, the dot in the center of the 
display will turn green.
 Each division is equivalent to about 5 °.
Virtual Horizon
G  button ➜Bsetup menu
Camera level Camera tilted left or 
rightCamera tilted forward 
or back
DTilting the Camera
The virtual horizon display is not...

380
Fine-tune focus for up to 20 lens types. AF tuning is not 
recommended in most situations and may interfere with normal 
focus; use only when required. 
AF Fine-Tune
G  button ➜Bsetup menu
OptionDescription
AF fine-tune  (On/Off ) •
On : Turn AF tuning on.
• Off : Turn AF tuning off.
Saved value Tune AF for the current lens 
(CPU lenses only). Press 
1 
or  3 to choose a value 
between +20 and –20. 
Values for up to 20 lens 
types can be stored. Only 
one value can be stored for 
each type of lens....

381
List saved values List previously saved AF tuning values. To delete a lens 
from the list, highlight the desired lens and press 
O (Q ). To 
change a lens identifier (for example, to choose an 
identifier that is the same as  the last two digits of the lens 
serial number to distinguish it from other lenses of the 
same type in light of the fact that  Saved value can be used 
with only one lens of each ty pe), highlight the desired lens 
and press  2.
The menu shown at right will be 
displayed; press...

382
This option is displayed only when an Eye-Fi memory card 
(available separately from third-party suppliers) is inserted in the 
camera.
 Choose  Enable to upload photographs to a preselected 
destination.
 Note that pictures will not be uploaded if signal 
strength is insufficient.
Observe all local laws concerning wireless devices and choose 
Disable  where wireless devices are prohibited.
Eye-Fi Upload
G button ➜Bsetup menu
DEye-Fi Cards
Eye-Fi cards may emit wireless signals when  Disable is...

383
When an Eye-Fi card is inserted, its status 
is indicated by an icon in the information 
display:
•d : Eye-Fi upload disabled.
• e : Eye-Fi upload enabled but no 
pictures available for upload.
• f  (static): Eye-Fi upload enabled; 
waiting to begin upload.
• f  (animated): Eye-Fi upload enabled; uploading data.
• g : Error — camera can not control Eye-Fi card.
 If a flashing 
W  appears in the control panel or viewfinder, refer to page 
470; if this indicator is not flashing, pictures can be taken...

384
To display the retouch menu, press G and select the  N 
(retouch menu) tab.
Retouch Menu Options
The options in the retouch menu are used to create trimmed, or 
retouched copies of existing pictures.
 The retouch menu is only 
displayed when a memory card containing photographs other 
than small NEF (RAW) images is inserted in the camera.
1 Can only be selected by pressing  G and selecting  N tab.
2 Available only if  b button is pressed in full-frame playba ck when a retouched image or original 
is...

385
Creating Retouched Copies
To create a retouched copy:
1Select an item in the retouch menu.
Press 1 or  3 to highlight an item,  2 
to select.
2Select a picture.
Highlight a picture and press  J.
 To  
view the highlighted picture full 
screen, press and hold the  X button.
To view images in other locations, 
press  W and select the desired card 
and folder as described on page 237.
ARetouch
In the case of images recorded at image quality settings of NEF + 
JPEG, only the NEF (RAW )  image will be...

386
3Select retouch options.
For more information, see the section for the selected item.
 
To exit without creating a retouched copy, press G.
4Create a retouched copy.
Press  J to create a retouched copy.
 
Retouched copies are indicated by a 
N  icon.
AMonitor off Delay
The monitor will turn off and the operation will be cancelled if no 
actions are performed for a brief period.
 Any unsaved changes will 
be lost. To increase the time the monitor remains on, choose a 
longer menu display time for...