NEC Projector P502HL User Manual

ix
Table of Contents
Important Information ........................................................................\
....................i
1. Introduction ........................................................................\
...................................1
❶
	What’s	in	the	Bo x? ........................................................................\
..................................1
❷
	Introduction	to	the	Projector ........................................................................\...

x
Checking	Energy-Saving	Effect	[CARBON	METER] ..............................................29
❺
	Preventing	the	Unauthorized	Use	of	the	Projector	[SECURITY] ..................................30
❻
	Viewing	3D	Images ........................................................................\
...............................33
LCD	shutter	eyeglasses	(recommended) ...............................................................33
Steps	for	viewing	3D	images	on	the...

xi
Connecting	HDMI	Input........................................................................\
...................78
Connecting	your	document	camera ........................................................................\
79
Connecting	to	a	Wired	LAN ........................................................................\
............80
Connecting	to	a	Wireless	LAN	(Optional:	NP05LM	series) .....................................81
Connecting	to	a	HDBaseT	transmission	device	(sold	commercially)...

1
1. Introduction
❶ What’s in the Box?
Make	sure	your	box	contains	everything	listed.	If	any	pieces	are	missing,	contact	y our	dealer .
Please	save	the	original	box	and	packing	materials	if	you	ever	need	to	ship	your	projector.
Projector
Remote control(7N901121)Batteries (AAA × 2)
Power cord(US: 7N080240/7N080243)
(EU: 7N080027/7N080029)Computer cable (VGA)
(7N520089)
Lens cap strap
For North America only
Limited warranty
For customers in Europe: 
You will find our current valid Guar-
antee Policy on our...

2
❷ Introduction to the Projector
This	section	introduces	you	to	your	new	projector	and	describes	the	features	and	controls.
General
•	 Single-chip	DLP	projector	with	high	resolution	and	high	brightness
Model	nameDMD	panelResolutionAspect	ratio
P502HL0.65	type1920	×	1080	pixels16:9
P502WL
0.65	type1280	×	800	pixels16:10
Light source · Brightness
•	 A	long-life	laser	diode	is	equipped	in	the	light	module
	 The	product	can	be	operated	at	low	cost	because	the	laser	light	source	can	be	used	for	a	long	time...

3
Energy-saving
•	 0.15	W	(100-130	V	AC)/0.36	W	(200-240	V	A C)	in	standb y	condition	with	ener gy	sa ving	tec hnology
	 Selecting	[NORMAL]	for	[STANDBY	MODE]	from	the	menu	can	put	the	projector	in	power-saving	mode.
	 NORMAL:	0.15	W	(100-130	V	AC)/0.36	W	(200-240	V	A C)
	 NETWORK	STANDBY:	2.1	W	(100-130	V	AC)/2.3	W	(200-240	V	A C)
•	 “ECO	MODE”	for	lo w	po wer	consumption	and	“CARBON	METER”	displa y
	 The	projector	is	equipped	with	a	“LIGHT	MODE”	for	reducing	power	consumption	during	use.	Further more,...

4
❸ Part Names of the Projector
Front
Intake	Vent(→ page 113)
Lens shift cover(→ page 17)
Lens Cap Tilt Foot
(→ page 20)
Intake	Vent(→ page 113)
Remote Sensor
(→ page 9)
Focus Ring
(→ page 19) Indicators
(→ page 6)
Zoom Lever (→ page 19)
Lens
Monaural	Speaker
Mounting the lens cap strap
1. Insert the tip of the strap into the lens cap mount hole and pass 
the knot through.
Lens cap mount hole
2. Insert the knot into the strap mount hole (large) on the bottom of 
the projector, then press it into the...

5
Controls(→ page 6)Remote Sensor(→ page 9)
Built-in Security Slot ( 
 )*
Wireless LAN cover (→ page 81)
AC	InputConnect the supplied power cord’s three-pin plug here, and plug the 
other end into an active wall outlet.  (→ page 11)
Exhaust Vent
Security chain opening 
Attach an anti-theft device.
The security chain opening accepts 
security wires or chains up to 0.18 
inch/4.6 mm in diameter.
Rear
Connection for cable cover (Left/Right) Screw holes (→ page 122)
*	 This	security	slot	supports	the...

6
Controls/Indicators
7
9 11
10
2
34
6
8
15
1. 	(POWER)	Button	
	(
→	page	12, 24)
2.	 POWER	Indicator	
	(→	page	11, 12, 24, 115)
3. STATUS Indicator 
	(→	page	115)
4.	 LIGHT	Indicator	
	(→	page	115)
5.	 ECO	Button	
	(→	page	28)
6.	 SOURCE	Button	
	(→	page	14)
7.	 AUTO	ADJ.	Button	
	(→	page	23)
8.	 MENU	Button	
	(→	page	37)
9. ▲▼◀▶	/	Volume	Buttons	◀▶	/	Keystone	Buttons	
	(→	page	13, 21, 23, 37)
10.	ENTER	Button	
	(→	page	37)
11.	EXIT	Button	
	(→	page	37)
1. Introduction  

7
Terminal Panel Features
1.	 COMPUTER	IN/	Component	Input	Terminal	(Mini	
D-Sub	15	Pin)	
	(→	page	73, 77, 79)
2.	 COMPUTER	AUDIO	IN	Mini	Jack	(Stereo	Mini)	
	(→	page	73, 77)
3.	 HDMI	1	IN	Terminal	(T ype	A)	
	(→	page	73, 74, 78)
4.	 HDMI	2	IN	Terminal	(T ype	A)	
	(→	page	73, 74, 78)
5.	 MONITOR	OUT	(COMP.)	Terminal	(Mini	D-Sub	15	
Pin)	
	(→	page	75)
6.	 AUDIO	OUT	Mini	Jack	(Stereo	Mini)	
	(→	page	75)
7.	 VIDEO	IN	Terminal	(RCA)	
	(→	page	76, 79)
8.	 VIDEO/S-VIDEO	AUDIO	IN	L/MONO,	R	(RCA)	
	(→	page	76)...