NEC Neax 2400 Ipx Installation Manual

LIST OF TABLES
Table TitlePage
NDA-24306 LIST OF TABLES
Page xiii
Revision 1.0 Table 2-1 Temperature and Humidity  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .   8
Table 2-2 Typical Installation Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .   13
Table 2-3 Condition for Configuration  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .   20
Table 2-4...

LIST OF TABLES NDA-24306
Pag e xi v
Revision 1.0
This page is for your notes. 

NDA-24306 SAFETY CONSIDERATIONS
Page xv
Revision 1.0
SAFETY CONSIDERATIONS
IMPORTANT — SAVE THESE INSTRUCTIONS
(1) Never install telephone wiring during a lightning storm.
(2) Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
(3) Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
(4) Use caution when installing or moving telephone lines.
When using your telephone equipment,...

SAFETY CONSIDERATIONS NDA-24306
Page xvi
Revision 1.0
(14) To reduce the risk of electric shock, do not disassemble this product, but take it to a qualified
serviceman when some service or repair work is required. Opening or removing covers may expose
you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the
appliance is subsequently used.
(15) Unplug this product from the wall outlet and refer servicing to qualified service personnel under the
following...

NDA-24306 REGULATORY INFORMATION
Page xvii
Revision 1.0
REGULATORY INFORMATION
1. REGULATORY REQUIREMENTS
The Federal Communications Commission (FCC) has established rules that permit the NEAX2400 IPX to be
directly connected to the telephone network. A jack is provided on party lines or coin lines.
The telephone company may make changes in its technical operations and procedures. If such changes affect
the compatibility or use of the NEAX2400 IPX, the telephone company is required to give adequate...

REGULATORY INFORMATION NDA-24306
Page xviii
Revision 1.0
3.2 Service Requirements
In the event of equipment malfunction, all repairs will be performed by NEC or an authorized distributor of
NEC. It is the responsibility of users requiring service to report the need for service to NEC or to one of their
authorized distributors.
If the equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice...

NDA-24306   REGULAT ORY I N FO RM ATION
P ag e xix
Re visi on 1 .0
   Route d  t o  a  r ec ord ed  an nounc em en t  th at can  be adm in is te red  by  th e CPE  u ser
   Routed  to  a  dial  p rompt
( b )  This  e q uip m en t r etu rn s  a n sw er s uperv is io n o n a ll  D ID  c a ll s f orw ard ed  to  th e  PST N . Perm is sib le
e xce ptions  a re:
   A c a ll i s  u n an swer ed
   A b usy  tone  is  r e ce iv ed
   A r e o rd er  ton e is  r e ce iv ed .
EQUAL ACCESS REQU IR EM ENTS
T his...

REGULATORY  INFORM ATIO N  NDA-24306
P ag e x x
Re visi on 1 .0
R inger  Eq uiv ale nce  Numbe r:  2.1
NOT IC E: The I ndus tr y  Ca nada  l ab el id en ti f ies  c e rtif ied eq uip m ent. The  c erti f ic a tion  m eans t hat  the equ ip m en t
me ets  ce rta in  te le com muni ca tio ns n etwo rk p rot ec ti ve  op era tional  and  sa fe ty  requ ir e men ts. The  de par tment  do es
n ot  gua ran tee the  eq uip m en t  w ill  op era te  to the  us er’s  s a ti s fa ction.
B efo re i nsta ll ing t he...

NDA-24306 CHAPTER 1
Page 1
Revision 1.0
CHAPTER 1 INTRODUCTION
1. GENERAL
During the period from equipment carry-in of the system till it is placed in service, the following must be 
performed:
 Installation of the system and its peripheral equipment
System startup
 Installation test
 Miscellaneous jobs
This manual explains how to proceed with these activities, and related precautions. It is recommended that the
installer thoroughly read Section 2., “HOW TO FOLLOW THE MANUAL” before engaging in any...

CHAPTER 1 NDA-24306
Pag e 2
Revision 1.0
INTRODUCTION
 Chapter 7, WORK AFTER INSTALLATION TESTS
This chapter explains various kinds of work and site cleaning, etc., which must be performed after com-
pletion of installation tests so that the system can be cut over normally.
2.2 How to Follow NAPs
This manual categorizes the work contents of installation, system startup and installation tests into detailed work
items, and an NEC Action Procedure (NAP) number is assigned to each of such work item.
The...