NEC Neax 2400 Ipx Hotel Office Data Specification

NDA-24315 CHAPTER 4
Page 179
Issue 1
AGSPL: Assignment of Guest Special Access Code for LDM
(j) Telephone Number (SRV = TELN)
 
TENANT
NUMBER 
(TN)
ACCESS CODE 
(ACC)
MAXIMUM
6 DIGITS
CONNECTIONSTATUS INDEX(CI) 
N/H
KIND OF
SERVICE (SRV)
NUMBER OF 
NECESSARY 
DIGITS
(NND) 1-24
REMARKS
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking
NNormalTELNHHooking...

CHAPTER 4 NDA-24315
Page 180
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
AG S P N: Assignment of Guest Special Access Code for NDM
1. General
This command assigns the numbering plan data for the Network Control Node (NCN). The data assigned in this
command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the
NDM at each Local Node (LN). 
2. Precautions
1. This command is used for the Hotel Application only.
2. If the Guest and Admin. Numbering are...

NDA-24315 CHAPTER 4
Page 181
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
3 . Data Entry Instructions
Access code (Max. 6 digits)TENANT
NUMBER
(TN)ACCESS CODE
(ACC)
MAX. 6 DIGITSCONNECTION 
STATUS INDEX
(CI) N/H/BKIND OF
SERVICE 
(SRV)
ACC
CISRV
SSCA=Service code appendix
OGCA=Outgoing call with route advance  
LCR=Least cost routing N=Normal service
H=Hooking service
B=Busy serviceSSC=Service code
OGC=Outgoing call
UNIF=Office termination
ANNC=Announcement service-single announcement...

CHAPTER 4 NDA-24315
Page 182
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
         STATE
(Hotel Service Code)
  1    To be cleaned without ID code
  2    Cleaning Completed without ID code
  3    Ready for Occupancy without ID code
  4    Use Not Allowed without ID code
5-8    -
  9    Maid Dial Answer Back without ID code-1
10    Maid Dial Answer Back without ID code-2
11    Maid Dial Answer Back without ID code-3
12    Maid Dial Answer Back without ID code-4
13    Maid Dial Answer...

NDA-24315 CHAPTER 4
Page 183
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
SERVICE INDEX
    (SID) 1-63      NO.1
56
NO.1
(Kind of Assignment Number)
  Available numbers are 0-15.
  This data is used to assign “Floor Service” data by the ASPF command.
Note: When programming “Floor Service” data,
 ASYD SYS1 INDEX 165, bit7=1 must have been assigned.
SERVICE INDEX
    (SID) 1-63NO.2KIND
57
NO.2
This parameter specifies the number (0-63) of the
access code being assigned for mutual Access....

CHAPTER 4 NDA-24315
Page 184
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
Table 4-1 SIDA (AGSPN)
SIDASERVICE NAMESIDASERVICE NAME
1-49–56Guest/Admin. Service
50UCD Busy Out; Entry56-62–
51UCD Busy Out; Cancel63Call Pickup Expand
52-55–64-255–
SERVICE INDEX A (SIDA) 1-255PNO 1-15A/G
56
PNO
This parameter specifies the Admin./Guest
Numbering Parameter Classification.
After assigning the PNO, go to the AOSP
command to skip this ACC.
After skipping the access code, the system
refers to the...

NDA-24315 CHAPTER 4
Page 185
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
LOGICAL ROUTE NUMBER
(LGRT)
Assign a dummy route number.LGRT
Second dial tone sending (which is sent when a station has
dialed the digits specified in NND of the AGNP command)
0=Second DT is not sent
1=Second DT is sent2nd DTAuthorization code after dialing
ACC (LCR)+Destination number
0=Out of Service
1=In ServiceAH
ISDN-Sub Address Dialing
0=Out of Service
1=In ServiceSUB
LOGICAL ROUTE NUMBER
(LGRT)SECOND DIAL...

CHAPTER 4 NDA-24315
Page 186
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
Assign the skip digits to terminate the call.
Assign the announce equipment number.
EQP3 and 5-14 can be used for SRV=ANNC (Single announcement).SKIP DIGITS
(SKIP) 0-5 When SRV=UNIF (Office termination) is assigned
When SRV=ANNC (Announcement service-Single announcement) is assigned
SKIP
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 0-127
EQP
Note:This data is available for ACIS only. For CCIS, use the AUNE command.
Assign...

NDA-24315 CHAPTER 4
Page 187
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
4. Data Sheet
(a) Service Code (SRV = SSC)
TENANT NUMBER(TN)
ACCESS CODE
(ACC)MAXIMUM6 DIGITS
CONNECTION STATUS
INDEX(CI) N/H/B
KIND OF
SERVICE (SRV)
SERVICEINDEX(SID)
1 – 63
NUMBER OF NECESSARYDIGITS
(NND)
NUMBER OF 
NECESSARY
DIGIT FOR
SPEEDCALLING(NND1)
1 – 24
FUSIONPOINT
CODEFPC)1-253
SERVICE CONTENTS
HHookingSSC1Not used
NNormalSSC2Dial Access to Attendant
(Operator Call)HHooking
3Not used4
NNormalSSC5Call...

CHAPTER 4 NDA-24315
Page 188
Issue 1
AGSPN: Assignment of Guest Special Access Code for NDM
(a) Service Code (SRV = SSC) (Continued)
SID = 36 (Hotel Service)
TENANTNUMBER(TN)
ACCESS CODE(ACC)
MAXIMUM6 DIGITS
CONNECTIONSTATUS INDEX
(CI)N/H/B
KIND OFSERVICE(SRV)
SERVICEINDEX(SID)
MAIDSTATUS
(STATE)1 – 63
SERVICE CONTENTS
NNormalSSC36
1To be cleaned without ID Code
2Cleaned without ID Code
3Ready for Occupancy without ID 
Code
4Use Not Allowed without ID Code
5
8
Not used
9Maid Dial Answer Back without ID...