NEC Gt2000 Lcd Projector Users Manual

E-71
Default Settings of the Switcher
Picture settings at the time of shipping from the factory are as described below.
Please adjust and set required items.
Press the MENU button to display [Main Menu], select [Switcher] with the
cursor button, then press the ENTER button to display the switcher menu.Main Menu
Picture
Alignment
Memory
Switcher
Display Menu
Settings Menu
Source
Switcher
R Gain
G Gain
B Gain
Color
Tint
Sharpness
Volume
Audio Select
Ð+
Switcher Picture Adjustment
Select [Switcher] from the...

E-72
Audio Control of the Switcher
This is the audio adjustment of the switcher AUDIO OUTPUT.
Setting the Volume (Volume)
This function sets the volume adjustment data that corresponds to the slot.
Select [Switcher] from the main menu.
Press the cursor s/t button and select [Volume].
When the item to be adjusted is selected, the adjustment bar of the selected
item is displayed at the bottom edge of the display.
Adjust with the cursor § (Ð)/ © (+) button.
The adjustment range is from 0 to 63.
(Ð)...

E-73
5MAINTENANCE
Step 1
Step 2
Step 3
Step 4
Step 5 This section describes the simple maintenance procedures you should follow
to replace the lamp, clean or replace the filter, and replace the batteries in the
remote control.
Replacing The Lamp
After your lamp has been operating for 2000 hours or longer, the red
ÒstatusÓ light in the cabinet will go on and the lamp icon will appear on
the above right of the screen whenever the projector is turned on. The
lamp icon remains on after 2100 hours of service....

E-74
Cleaning Or Replacing The Filter
The air-filter sponge keeps the inside of the MultiSync GT2000/
GT2000R LCD Projector free from dust or dirt and should be
cleaned after every 100 hours of operation (more often in dusty
conditions). If the filter is dirty or clogged, your projector may
overheat.
NOTE:  Clean your filter after every 100 hours of operation.
CAUTION
¥ Turn off the main power and unplug the projector before
replacing the filter.
¥ Only clean the outside of the filter cover with a...

E-75
Etape 1
Etape 2
Etape 3
Etape 4
Etape 5 Cette section dŽcrit les procŽdures simples dÕentretien que vous aurez ˆ suivre
pour remplacer la lampe, nettoyer ou remplacer le filtre et remplacer les piles
de la tŽlŽcommande.
Remplacement de la lampe
Lorsque la lampe a ŽtŽ utilisŽe pendant 2000 heures ou plus, le voyant

fonctionner, remplacez-la au bout de 2000 heures pour conserver une
performance optimale de votre projecteur.
PRECAUTION
¥ 

la manipuler..
¥ NE RETIREZ AUCUNE VIS mis ˆ part la vis qui...

E-76
Nettoyage ou remplacement du filtre
Le coussin Žponge du filtre ˆ air maintient lÕintŽrieur du
projecteur ˆ affichage ˆ cristaux liquides MultiSync GT2000 /

nettoyŽ toutes les 100 heures dÕutilisation (plus souvent dans les
endroits poussiŽreux). Si le filtre est sale ou bouchŽ, le
projecteur risque de surchauffer.
REMARQUE:  Nettoyez le filtre toutes les 100 heures
dÕutilisation.
PRECAUTION
¥ Coupez lÕalimentation et dŽbranchez le projecteur avant
de remplacer le filtre.
¥ Nettoyez uniquement le...

E-77
TROUBLESHOOTING6
This section helps you resolve problems you may encounter while setting up or using your MultiSync GT2000/GT2000R LCD
Projector.
Status Light Messages
Status
mNormal
mThe projector lamp has exceeded 2000 hours of operation and
should be replaced.
mEither the lamp cover or filter cover is not fastened properly.
Check each and reattach them if necessary.
mThe cooling fan has stopped. Contact your NEC dealer for service.
mThe lamp is not turned on.
¥ The projector was turned off and...

E-78
Common Problems & Solutions
Problem
Does not turn on
No picture
Image isnÕt square to the screen
Picture is blurred
Image is scrolling vertically,
horizontally or both
Volume button does not work
Remote control does not work
Status indicator is lit or
blinking
Cross color in RGB modeCheck These Items
¥ Check that the cord is plugged in and that the power switch on the front panel is on.
¥ Ensure that the filter cover is installed correctly.
¥ Check to see if the projector has overheated or the lamp...

E-79
SPECIFICATIONS7
This section provides technical information about the MultiSync GT2000/GT2000R LCD Projectors performance.
Model Number    GT2000 / GT2000R
Optical
LCD Panel 1.3, p-Si TFT active-matrix, 136621024 dots
Lens GT2000 : F 2.5 f = 52 Ð 68 mm (Power zoom, power focus)
GT2000R: F2.5 f = 30 mm (Fixed focus)
Lamp New short arc high pressure lamp 150 W
Image Size GT2000 : 20 Ð 300 inches (50.8 Ð 762 cm) diagonal
GT2000R : 40 Ð 200 inches (102 Ð 508 cm) diagonal
Projection Distance GT2000 : 1.0...

E-80
Cabinet Dimensions
Unit : mm (inch)
92.2
(3.6)
378
(15)
171
(6.7)111.5 (4.4)
Lens center290 (11.4)
not including side protrusion
84.2
(3.3) MAX.
99.96
(3.9) MAX.
95.76
(3.8)378
(15) 405
(16)
171
(6.7)290 (11.4)
not including side protrusion
111.5 (4.4)
Lens center
Lens center
Lens center
GT2000
GT2000R