NEC E552, E462, E422, E322 Users Manual
Have a look at the manual NEC E552, E462, E422, E322 Users Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1168 NEC manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
English-1 www.necdisplaysolutions.com Index Precautions And Reminders ����������������������������������������������������������������English-1 Important Safety Instructions ���������������������������������������������������������������English-2 Safety Instructions ������������������������������������������������������������������������\ �������English-4 Important Information ������������������������������������������������������������������������\ ��English-5 Declaration Of Conformity �������������������������������������������������������������������English-8 Preparation ������������������������������������������������������������������������\ ����������������English-10 Preparing Your LCD Display For Wall Mounting ���������������������English-10 Attaching the Base �������������������������������������������������������������������English-11 Place The Display On A Solid Surface �������������������������������������English-11 Antenna Connection �����������������������������������������������������������������English-11 Battery Installation and Replacement��������������������������������������English-12 Connect To The Power Source �����������������������������������������������English-13 Power On/Off Your New LCD Display �������������������������������������English-13 Source Connection Guide �������������������������������������������������������English-14 RS-232C Port Specifications ���������������������������������������������������English-16 Power Mode Status �����������������������������������������������������������������English-16 Operating Instructions �����������������������������������������������������������������������English-17 Using The Side Panel Controls �����������������������������������������������English-17 Using The Remote Control ������������������������������������������������������English-18 Picture Format for Each Input Source �������������������������������������English-19 Navigating The On-Screen Menu ������������������������������������������������������English-20 Video Menu �����������������������������������������������������������������������������English-20 Audio Menu �����������������������������������������������������������������������������English-21 TV Menu �������������������������������������������������������������������������������\ ���English-22 Setup Menu �����������������������������������������������������������������������������English-22 Parental Menu �������������������������������������������������������������������������English-24 USB Menu �������������������������������������������������������������������������������\ English-25 Tips ������������������������������������������������������������������������\ ����������������������������English-27 Care Of The Screen ����������������������������������������������������������������English-27 Mobile Telephone Warning ������������������������������������������������������English-27 End Of Life Directives��������������������������������������������������������������English-27 License Notice and Trademark Acknowledgement �����������������English-27 Product Specification ������������������������������������������������������������������������\ �English-28 Before Calling Service �����������������������������������������������������������������������English-30 Glossary ������������������������������������������������������������������������\ ��������������������English-31 Limited Warranty ������������������������������������������������������������������������\ �������English-32 References ������������������������������������������������������������������������\ ����������������English-33
English-1 English Precautions And Reminders Do not place the display in confined spaces or in a box when in use� Maintain ample ventilation for the display when in use� Do not open the display cabinet�Call a NEC certified service personnel for any internal service needed for your display� Keep the display away from direct sunlight, dust, humidity, and smoke� Unplug immediately if any foreign object is put in the display or if the display falls� Unplug immediately if there is a display malfunc-tion such as a loss of audio/video, the presence of smoke, or a bad odor coming from the display � Unplug the AC cord from the AC outlet before cleaning� Do not use liquid cleaners or aerosol cleaners to clean the display� Do not place the display near water such as a bathtub, washbasin, sink, laundry tub, swimming pool, or a damp base-ment� Do not cover or block any vents or openings� Inadequate ventilation may shorten the life of the display and cause overheating� Place the unit on a sturdy, even surface�Do not insert any foreign objects into the display cabinet� Unplug the power cord from the outlet when the display is not in use for long periods of time (days)� Notice for Remote Controller Avoid Liquids 1 234567 89 0 Avoid Aerosol Cleaners 123 4567 8 9 0 Avoid Dropping 1 2 3 456 7 890 www.necdisplaysolutions.com
English-3English-2 Important Safety Instructions Read before operating equipment The lamps in this product contain mercury. Please dispose according to state, local or federal law. Follow all warnings and instructions marked on this display� 1� Read these instructions� 2� Keep these instructions� 3� Heed all warnings� 4� Follow all instructions� 5� Do not use this apparatus near water� 6� Clean only with dry cloth� 7� Do not block any ventilation openings� Install in accordance with the manufacturer's instructions� 8� Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat� 9� Do not defeat the safety purpose of the polarized or grounding-type plug� A polarized plug has two blades with one wider than the other� A grounding type plug has two blades and a third grounding prong� The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet� 10� Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus� 11� Only use attachments/accessories specified by the manufacturer. 12� Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus� When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over � S3125A13� Unplug this apparatus during lightning storms or when unused for long periods of time� 14� Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped� 15� The display complies with the recommended safety standards for stability� Do not put excessive force on the front or top of
English-3English-2 English the cabinet� This could cause the product to tip over and cause damage and/or personal injury� 16� If monitor or glass is broken, do not come in contact with the liquid crystal and handle with care� 17� Follow instructions for wall, shelf or ceiling mounting as recommended by the manufacturer � 18� An outdoor antenna should not be located near overhead power lines or any electrical circuits� 19� If an outside antenna is connected to the receiver, confirm that the antenna system is grounded to protect against voltage surges and built up static charges� Section 810 of the National Electric Code, ANSI/NFPA No� 70-1984, provides information with respect to proper grounding for the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna discharge unit, connection to grounding electrodes and requirements for the grounding electrode� NOTE: To the display system installer: This reminder is provided to call attention to Article 820-44 of the National Electric Code that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the facility, as reasonably close to the point of cable entry as possible Power source This LCD display operates on 120 volts 60 Hz, AC current� Insert the power cord into a 120 volts 60 Hz outlet� The mains plug is used as the disconnect device and shall remain readily operable� To prevent electric shock from the display, do not use with an extension cord, receptacle, or other outlet unless the blades and ground terminal can be fully inserted to prevent blade exposure� Never connect the LCD display to 50 Hz, direct current, or anything other than the specified voltage. CAUTION: Never remove the back cover of the LCD display as this can expose you to very high voltages and other hazards� If the display does not operate properly, unplug the LCD display and call your authorized dealer or service center� Adjust only those controls that are covered in the instructions, as improper changes or modifications not expressly approved by NEC could void the user’s warranty�
English-5English-4 Safety Instructions FCC STATEMENT This equipment has been tested and found to comply with the limits for a\ Class B digital device, pursuant to Part 15 of the FCC Rule� These limits are designed to provide reasonable protection against harmful interference i\ n a residential installation� This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with\ these instructions, may cause harmful interference to radio communicatio\ ns� However, there is no guarantee that interference will not occur in a particular\ installation� If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o\ ff and on, the user is encourage to try to correct the interference by one \ or more of the following measures: 1� Reorient or relocate the receiving antenna� 2� Increase the separation between the equipment and receiver� 3� Connect the equipment into an outlet on a circuit different from that to which the receiver is connected� 4� Consult the dealer or an experienced radio/display technician for help� This device complies with Part 15 of the FCC Rules� Operation is subject to the following two conditions: 1� This device may not cause harmful interference� 2� This device must accept any interference received, including interferenc\ e that may cause undesired operation� FCC CAUTION To assure continued compliance and possible undesirable interference, fer\ rite cores may be used when connecting this LCD display to video equipment; and maintain at least 400mm spacing to other peripheral device� CANADIAN NOTICE This Class B digital apparatus complies with Canadian ICES-003
English-5English-4 English Important Information WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE� ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED� REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE� REFER SERVICING TO QUALIFIED SERVICE PERSONNEL� CAUTION CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS UNPLUGGED FROM WALL SOCKET� TO FULLY DISENGAGE THE POWER TO THE UNIT, PLEASE DISCONNECT THE POWER CORD FROM THE AC OUTLET� DO NOT REMOVE COVER (OR BACK)� NO USER SERVICEABLE PARTS INSIDE� REFER SERVICING TO QUALIFIED SERVICE PERSONNEL� This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit� This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included� Therefore, it should be read carefully in order to avoid any problems� CAUTION: Please use the power cord provided with this display in accordance with the table below � If a power cord is not supplied with this equipment, please contact your supplier � Plug TypePlug ShapeRegionVoltage North AmericaU�S�A�/CanadaAC 120 V Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus� The Class I apparatus shall be connected to a mains socket outlet with a\ protective grounding connection�
English-7English-6 Batteries installed warning Caution - Danger of explosion if batteries are incorrectly replaced� Replace only with the same or equivalent type� The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other \ than that contained in the operating instructions unless you are qualified to do so. Ventilation The slots and openings in the TV are provided for necessary ventilation� To ensure reliable operation of the TV and to protect it from overheating, these slots and openings must never be blocked or covered� Unless proper ventilation is provided, the TV may gather dust and get dirty� For proper ventilation, observe the following: • Do not install the TV face up, down or sideways� • Do not install the TV turned over or upside down� • Never cover the slots and openings with a cloth or other materials� • Never block the slots and openings by placing the TV on a bed, sofa, rug or other similar surface� • Never place the TV in a confined space, such as a bookcase or built-in cabinet, unless proper ventilation is provided� Leave some space around the TV set as shown below� Otherwise, air-circulation may be inadequate and will cause overheating, which may caus\ e a fire or damage to the TV set. Install on the wall 4 inches 10 cm4 inches10 cm 4 inches 10 cm Leave at least this space around the set. 11 7/8 inches 30 cm
English-7English-6 English Installed with stand 4 inches10 cm4 inches10 cm Leave at least this space around the set. 11 7/8 inches 30 cm 4 inches10 cm Never install the TV set where Air circulation is blocked� Objects and ventilation holes Never push objects of any kind into the TV through the cabinet slots as they may touch dangerous voltage points or short out parts that could result \ in a fire or an electric shock. Do not place any objects on the TV.
English-9English-8 Declaration Of Conformity This device complies with Part 15 of FCC Rules� Operation is subject to the following two conditions� (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation� U.S. Responsible Party:NEC Display Solutions of America, Inc. Address:500 Park Boulevard, Suite 1100 Itasca, Illinois 60143 Tel. No.:(630) 467-3000 Type of Product:Digital Signage Display Equipment Classification:Class B Peripheral Model:E552(L550UQ) E462(L460UR) E422(L420UT) E322(L320UU) We hereby declare that the equipment specified above conforms to the technical standards as specified in the FCC Rules. Canadian Department of Communications Compliance Statement DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations� C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22�2 No� 60065-03� FCC Information: 1� Use the attached specified cables with the E322/E422/E462/E552 color monitor so as not to interfere with radio and television reception� (1) Please use the supplied power cord or equivalent to ensure FCC compliance� (2) Please use the supplied shielded video signal cable, Mini D-SUB 15 pin to Mini D-SUB 15 pin� 2� This equipment has been tested and found to abide by the limits of a Class B digital device, pursuant to part 15 of the FCC Rules� These limits are intended to provide reasonable security against harmful interference\ in a residential deployment� This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radi\ o communications� However, there is no guarantee that interference will not occur in a certain installation� If this equipment does cause damaging interference to radio or television reception, which can be determined b\ y powering the equipment on and off, the user is encouraged to attempt correcting the interference by one or more of the following procedures: