Home
>
Multi-Tech Systems
>
Communications System
>
Multi-Tech Systems Mvp400, Mvp800 Voice/fax Over Ip Networks User Guide
Multi-Tech Systems Mvp400, Mvp800 Voice/fax Over Ip Networks User Guide
Here you can view all the pages of manual Multi-Tech Systems Mvp400, Mvp800 Voice/fax Over Ip Networks User Guide. The Multi-Tech Systems manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 2
User Guide S0000008 Revision A MultiVOIP400 (Model MVP400) and MultiVOIP 800 (Model MVP 800) This publication may not be reproduced, in whole or in part, without prior expressed written permission from Multi- Tech Systems, Inc. All rights reserved. Copyright © 2000, by Multi-Tech Systems, Inc. Multi-Tech Systems, Inc. makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose....
Page 3
iii Contents Chapter 1 - Introduction and Description Introduction ................................................................................................................................................ 6 Preview of this Guide ................................................................................................................................. 7 Typical Application...
Page 4
iv Applications Setup ................................................................................................................................... 64 Viewing Statistics ..................................................................................................................................... 65 IP Statistics ........................................................................................................................................ 65 SNMP Statistics...
Page 6
6 MultiVOIP 400/800 User Guide Introduction Welcome to Multi-Techs new voice/fax gateway, the MultiVOIP, models MVP400 and MVP800 (Hereafter referred together as MultiVOIP 400/800). The MultiVOIP 400/800 allows analog voice and fax communication over a traditional data communications/data networking digital Internet. Multi- Tech’s new voice/fax gateway technology allows voice and fax communication to be transmitted, with no additional expense, over your existing communications Internet, which has...
Page 7
7 Chapter 1 - Introduction and Description Preview of this Guide This guide describes the MultiVOIP and tells you how to install and configure the unit. The information contained in each chapter is as follows: Chapter 1 - Introduction and Description Chapter 1 describes the MultiVOIP and provides a typical application. Front panel indicator and back panel connector descriptions are provided. In addition, a list of relevant specifications is provided at the end of the chapter. Chapter 2 - Installation...
Page 8
8 MultiVOIP 400/800 User Guide Typical Application Before Voice Over IP (VOIP), i.e., voice over the Internet, a corporate office had a data connection to the Internet and a voice connection to the public switched telephone network (PSTN). With VOIP, the two networks can be tied together. To accomplish this, a MultiVOIP is connected between the public switched telephone network and the data network as shown in the typical VOIP application in Figure 1-2. A MultiVOIP 400/800 at the corporate office is...
Page 9
9 Chapter 1 - Introduction and Description sales office. The corporate caller could then dial any telephone number from the sales office PSTN and this would be a local call. The regional office is set up very similar to the corporate office with the exception that a MVP200 is connected between the network and the PBX. This allows two voice/fax channels to be used at the regional office. A person in the regional office can pick up a telephone and dial a trunk extension (for example, trunk extension 10)...
Page 10
10 MultiVOIP 400/800 User Guide tone or wink), 2-wire or 4-wire connection, and if the wink option is the signaling option, the wink timer delay in milliseconds. The default is 250 milliseconds. Additional channel setup parameters cover the voice coder, DTMF gain, voice gain, and faxing in the Voice/Fax tab of the Channel Setup dialog box. The most important parameter is this group is to ensure that the voice coder is the same for all MultiVOIPs in the network. The Billing/Misc tab handles the billing...