Home > Multi-Tech Systems > Communications System > Multi-Tech Systems Mvp24-48, Mvp30-60 Exoansion Cards Installation Instructions

Multi-Tech Systems Mvp24-48, Mvp30-60 Exoansion Cards Installation Instructions

    Download as PDF Print this page Share this page

    Have a look at the manual Multi-Tech Systems Mvp24-48, Mvp30-60 Exoansion Cards Installation Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 104 Multi-Tech Systems manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							82000350
    Installation Instructions for
    MVP24-48 & MVP30-60 Expansion Cards
    Both the MVP2410 and the MVP3010 use the same mechanical chassis.
    This chassis accommodates a second MultiVOIP circuit card or
    motherboard module.  The add-on module for the MVP2410 is the
    MVP24-48 product; the add-on module for the MVP3010 is the
    MVP30-60 product.
    To install an expansion card into an MVP2410 or MVP3010, you must:
    1. Power down and unplug the MVP2410/3010 unit.
    2. Using a Phillips or star-bit screwdriver, remove the blank plate at
    the rear of the MVP2410/3010 chassis (see Figure 1).  Save the screw.
    Figure 1:  Remove Plate Covering Expansion Slot 
    						
    							3. A power cable for the expansion card (+5V) is already present
    within the MVP2410/3010 unit.  This power cable has a two-pin
    “molex” connector.  When the rear cover plate has been removed, the
    cable is accessible from the rear at the right side of the expansion slot.
    Locate this connector within the MVP2410/3010.  See Figure 2.Power Cable
    Molex Connector
    Figure 2:  MVP2410/3010 Chassis (top/rear view)
    4. While keeping the power cable out of the way, fit the MVP24-48 or
    MVP30-60 card into the grooves of the expansion slot.  Push it in far
    enough to allow connection of the power cable to the receptacle on the
    vertical plate of the expansion card.  (See Figure 2.)  Connect the power
    cable.5. Push the expansion card fully into the chassis.  See Figure 3.
    Figure 3: Sliding Expansion Card into Chassis
    Secure the vertical plate of the expansion card to the chassis with a
    screw.
    Operation
    The MVP2410/3010 front panel has two sets of identical LEDs.  In the
    MVP2410/3010 without an expansion card, only the left-hand set of
    LEDs is functional.  However, when the MultiVOIP unit has been
    upgraded with an MVP24-48 or MVP30-60 expansion card, the right-
    hand set of LEDs will also become active.
    Remember that the expansion card must be configured as though it
    were simply another complete MultiVOIP unit:  it requires its own
    T1/E1 line; it requires its own connection to a computer running the
    MultiVOIP configuration software.  All of the procedures and
    operations that apply to the original motherboard of the
    MVP2410/3010 will also apply to the expansion card.  See applicable
    User Guide chapters for details. 
    						
    All Multi-Tech Systems manuals Comments (0)

    Related Manuals for Multi-Tech Systems Mvp24-48, Mvp30-60 Exoansion Cards Installation Instructions