Home > Mountfield > Lawn Mower > Mountfield Lawn Mower 4125M - 4135H - 4155H - 4155H 4WD Instructions Manual

Mountfield Lawn Mower 4125M - 4135H - 4155H - 4155H 4WD Instructions Manual

Add to Favourites

Download as PDF Print this page Share this page

Have a look at the manual Mountfield Lawn Mower 4125M - 4135H - 4155H - 4155H 4WD Instructions Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 153 Mountfield manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

Page 11 11
ENGLISHEN
1. Install the steering column jacket on the steer-
ing column and secure by knocking in the ten-
sion pin (C) approximately 1/3 of its length.
2. Pull the steering column jacket and the steering
column up.
3. From the outside, check whether no washers,
the 0.5 mm washer, the 1.0 mm washer or both
washers can be inserted into the gap. The wash-
er/washers must not be forced in, as there must
be a little axial play.
4. Pull out the cotter pin and dismantle the steering
wheel jacket.
5....

Page 12 12
ENGLISHEN
4.4 Controls
4.4.1 Implement lifter, mechanical (10:A)
To switch between working position and transport
position:
1. Depress the pedal fully.
2. Release the pedal slowly.
4.4.2 Service brake - Clutch (10:B)(4125M)
A pedal that combines both service brake and
clutch. There are 3 positions:
1. Pedal released – forward drive
engaged. The machine will
move if a gear is engaged.
Service brake not activated.
2. Pedal depressed halfway –
forward drive disengaged, gear shifting can be...

Page 13 13
ENGLISHEN
4.4.8 Gear lever (11:H) (4125M))
A lever for selecting one of the five forward gears
in the gearbox (1-2-3-4-5), neutral (N)
or reverse (R).
The clutch pedal must be kept pressed in when
changing gear.
NOTE! You must make sure the machine is quite
stationary before changing from reverse to forward
gear or vice versa. If a gear does not engage
immediately, release the clutch pedal and then
press it in once again. Engage the gear once again.
Never force a gear in.
4.4.9 Power take-off...

Page 14 14
ENGLISHEN
Never completely fill the petrol tank. Leave an
empty space (= at least the entire filler tube plus 1
- 2 cm at the top of the tank) to allow the petrol to
expand when it warms up without overflowing.
See fig. 16.
6.2 Checking the engine oil levelOn delivery, the crankcase is filled with SAE 30
oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick. Un-
screw and pull it up. Wipe off...

Page 15 15
ENGLISHEN
6. Depress the clutch-brake pedal fully.
7. Turn the ignition key and start the engine.
8 Once the engine has started, move the throttle
control gradually to full throttle (approx. 2 cm
behind the choke position) if the choke has been
used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the
engine run for a few minutes first. This will al-
low the oil to warm up.
When the machine is in operation, full throttle
should always be used.
6.6...

Page 16 16
ENGLISHEN
Use synthetic oil of service grade SF or higher in
accordance with the table below.
Use oil without any additives.
Do not fill with too much oil. This can cause the
engine to overheat.
Change oil when the engine is warm.
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. Therefore allow the engine to
cool a few minutes before draining the
oil.
1. Attach the clamp on the oil drainage hose. Use
a polygrip or similar. See fig. 19:V.
2. Move the...

Page 17 17
ENGLISHEN
NOTE! The oil is drawn into the system very
quickly. The reservoir must always be
topped up. Air must never be drawn in.
5. Set the accelerator pedal to the forward position
by blocking it using a wooden wedge. See fig.
23. Fill the oil reservoir by hand using new oil.
6. Run in the forward position for one minute.
7. Move the wooden wedge and set the accelerator
pedal to the reverse position. Continue filling
with oil.
8. Run in reverse mode for one minute.
9. Change driving direction...

Page 18 18
ENGLISHEN
7.8.4 Cleaning
If the battery terminals are coated with oxide, they
should be cleaned. Clean the battery terminals with
a wire brush and lubricate them with terminal
grease.
7.9 Air filter, engineThe pre-filter (foam filter) must be cleaned/re-
placed after 25 hours of operation.
The air filter (paper filter) must be cleaned/re-
placed after 100 hours of operation.
NOTE! The filters should be cleaned/replaced
more often if the machine operates on dusty
ground.
Remove/install the air...

Page 19 19
ENGLISHEN
PURCHASE TERMS
A full guarantee is issued against manufacturing
and material defects. The user must carefully fol-
low the instructions given in the enclosed docu-
mentation.
Guarantee period
For consumer use: two years from purchase date.
For batteries: six months from the purchase date.
Exceptions
The guarantee does not cover damage due to:
- neglect of the user to acquaint himself with ac-
companying documentation
- carelessness
- incorrect and non-permitted use or assembly
- the use of...

Page 20 EC conformity declaration
1.Category
5.VibrationLawnmower with petrol engine
P901
1. 13-6101 + 13-2939
2. 13-6101 + 13-2927
3. 13-6102 + 13-2939
4. 13-6102 + 13-2927
< 0.9 m/s
2
< 2.5 m/s2
(2.Type
3.Item no
GGP Sweden AB
P.O. Box 1006
SE-573 28 Tranås
Sweden8.Make Mountfield
9.Cutting width1, 3, 5, 7: 92 cm
2, 4, 6, 8: 107 cm10.Serial numberSee label on chassis
6A.Guaranteed sound power level
(L
WA)100 dB(A)11. Engine
MakeBriggs & Stratton
1, 2, 3, 4: 21A907
5, 6, 7, 8: 282H07 Model
12.Rotation...

Page 21 Manufactured by GGP Sweden AB

View all the pages

Add page 21 to Favourites

image text

							Manufactured by GGP Sweden AB

All Mountfield manuals Comments (0)

Related Manuals for Mountfield Lawn Mower 4125M - 4135H - 4155H - 4155H 4WD Instructions Manual