Motorola Wing 5 Manual

INTERFACE-RADIO COMMANDS 24 - 37
24.1.25 rts-threshold
interface-radio Instance
Configures the RTS threshold value on this radio
Supported in the following platforms:
 RFS4011
Syntax
rts-threshold 
Parameters
• rts-threshold 
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#rts-threshold 100
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#show context
 interface radio1
  rf-mode sensor
  rts-threshold 100
  wlan wlan1...

24 - 38 WiNG CLI Reference Guide
24.1.26 shutdown
interface-radio Instance
Terminates or shuts down a radio interface
Supported in the following platforms:
 RFS4011
Syntax
shutdown
Parameters
None
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#shutdown
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#
Related Commands
noEnables a disabled radio interface 

INTERFACE-RADIO COMMANDS 24 - 39
24.1.27 sniffer-redirect
interface-radio Instance
Captures and redirects packets to an IP address running a packet capture/analysis tool
Supported in the following platforms:
 RFS4011
Syntax
sniffer-redirect  channel [1|1+|10|10-|100--------165]
Parameters
• sniffer-redirect  channel [1|1+|10|10---------165]
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#sniffer-redirect 
172.16.10.13 channel ?
  1     Channel 1 in 20Mhz
  1+    Channel 1 as primary,...

24 - 40 WiNG CLI Reference Guide
24.1.28 use
interface-radio Instance
The use command enables the use of an association ACL policy and a radio QoS policy by this radio interface
Supported in the following platforms:
 RFS4011
Syntax
use [association-acl-policy|radio-qos-policy]
use [association-acl-policy |radio-qos-policy ]
Parameters
• use [association-acl-policy |
radio-qos-policy ]
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#use association-acl-pol
icy test1...

INTERFACE-RADIO COMMANDS 24 - 41
24.1.29 wireless-client
interface-radio Instance
Configures wireless client parameters
Supported in the following platforms:
 RFS4011
Syntax
wireless-client tx-power 
Parameters
• wireless-client tx-power 
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#wireless-client tx-power 20
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#show context
 interface radio1
  rf-mode sensor...

24 - 42 WiNG CLI Reference Guide
24.1.30 wlan
interface-radio Instance
Enables a WLAN on this radio
Supported in the following platforms:
 RFS4011
Syntax
wlan  {bss|primary}
wlan  bss  {primary}
Parameters
• wlan  bss  {primary}
Examples
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#wlan wlan1
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#
RFS4000-880DA7(config-profile-default-RFS4000-if-radio1)#show context
 interface radio1
  rf-mode sensor
  placement outdoor
  beacon...

CHAPTER 25 FIREWALL LOGGING
This chapter summarizes firewall logging commands within the CLI. 
The firewall uses logging to send system messages to one or more logging destinations, where they can be collected, 
archived and reviewed.
Set the logging level to define which messages are sent to each of the target destinations. 
Logging messages can be sent to any of the following destinations: 
 The firewall console
 Telnet or SSH session to the firewall
 A temporary buffer internal to the firewall...

25 - 2 WiNG CLI Reference Guide
25.1 Firewall Log Terminology and Syslog Severity Levels
Abbreviation Description
FTP File transfer protocol
ACL Access control list
Src MAC Source MAC address
Dest MAC Destination MAC address
LOGRULEHIT ACL rule applied
PKT DROP Packet drop
Src IP Source IP address
Dest IP / Dst IP Destination IP address
FWSTARTUP Firewall enabled
DP Destination port
SP Source port
Matched Temporary Rule This is a internal rule created to allow data traffic
Syslog Severity Level as...

FIREWALL LOGGING 25 - 3
25.1.1 Date format in Syslog messages
The following output displays the wireless controller date in proper format:
RFS7000-81916A(config)#Jul 25 11:09:00 2011: USER: cfgd: deleting session 4
RFS7000-81916A(config)#
RFS7000-81916A(config)#Jul 25 11:09:17 2011: USER: cfgd: deleting session 5
The date format is  Month   Date   Time  Year 
Month is Jul
Date is 25
Time is 11:09:00
Year is 2011
To generate a date log, enable logging
For example, the following command has to be...

25 - 4 WiNG CLI Reference Guide
25.1.2 FTP data connection log
An ACL rule has to be applied and logging has to be enabled to generate a FTP data collection log.
The FTP connection is Control Connection
Jul 25 11:10:17 2011: %DATAPLANE-5-LOGRULEHIT: Matched ACL:ftpuser:ip Rule:0 
Disposition:Allow Packet  Src MAC: Dst MAC: 
Ethertype:0x0800 Src IP:192.168.1.99 Dst IP:192.168.2.102 Proto:6 Src Port:3014 Dst 
Port:21
Date is Jul 25
Time is 11:10:17
Year is 2011
Module name is DATAPLANE
Syslog Severity...