Motorola S10 Manual

Listen to music
9
Crank it upPress 9 (to increase) and  Ï (to decrease) 
buttons to adjust the volume. 
Note: The volume setting on your phone may 
impact volume on your headphones.On a call?When a call is active, your music either pauses 
or is silenced. When the call ends, music 
resumes playing. 

Calls
10Callsit’s good to talk
Note: Some features are phone/network 
dependent.To...
answer call Press  .
reject call Press and hold 
9 or Ï until 
you hear a tone.
make a voice 
dial call Press   and you hear a 
tone. Follow prompts to make 
call.
redial last call Press and hold  until you  hear a tone.
mute or 
unmute a call Press 
Å. 
end a call Press  . 

Status light
11
Status lightknow your headphonesIf status light 
shows... your headphones are...
three blue 
flashes powering on/off
steady blue in pairing mode
rapid blue/red 
flashes connecting to your phone
quick blue 
flash receiving or making a call
slow blue 
pulse on a call
slow red 
pulse call muted 

Status light
12slow blue 
flashin standby (not on a 
call—connected to phone)
slow red 
flash idle (not connected to a 
phone)
steady red trying to connect to your  phone
quick purple 
flash playing/pausing music
quick red 
flash stopping music
slow purple 
pulse music playing
If status light 
shows...
your headphones are... 

Status light
13
Note: The status light stops flashing to 
conserve power after 20 minutes on a call or of 
inactivity, but the headphones remain on. The 
status light is reactivated by pressing the   
(power) key or by certain changes in 
headphone activity.ver y quick 
red flash (and 
repeating 
short tones)
in a low batter y state 
(need recharge)
If status light 
shows...
your headphones are... 

Got an iPod®?
14Got an iPod®?let’s get them togetherListen to your iPod wirelessly with your headphones 
and the Motorola D670 Bluetooth Adapter for iPod.
 1Turn off any Bluetooth devices previously paired 
with your headphones. 2Turn headphones off. Turn on by pressing the   
(power key) and holding until the status light is 
steadily lit in blue.3Turn on your iPod and place in pause mode. 4Connect your D670 to your iPod.5Press your iPod’s Play/Pause button.
When the D670’s status light begins to pulse...

Tips & tricks
15
Tips & tricksa few handy hintsReconnect with your phoneTo reconnect your headphones to your phone:
 Press   to reestablish handsfree-phone 
connection and make/receive calls.
 Press  Å to reestablish streaming music 
connection and restart music.Reset to factory settingCaution:  This action erases all pairing 
information stored in your headphones.
Press and hold the  (power) and  9 keys 
while headphones are on until the status light 
is steadily lit in blue. 

Tips & tricks
16Outdoor useTo help you avoid choppy or distorted music in 
your headphones:
 Position your phone close to and within line 
of sight of your headphone’s internal 
antenna (located in the base behind your 
head).
 Do not place your phone in your front pocket 
or other location that can obscure its signal 
connection to the headphone’s antenna.
 If your choice of phone location doesn’t 
work, try moving it closer to the 
headphones or turning it. 

Problems?
17
Problems?we’ve got solutions
My headphones will not enter pairing mode
Make sure that any devices previously paired 
with your headphones are turned off. If the 
status light is not steadily lit in blue, turn off 
both the other device and headphones, wait 10 
seconds, then turn headphones back on by 
pressing and holding the   (power) key until 
the status light becomes steadily lit in blue.
My phone doesnt find my headphones 
when sear ching
Make sure the status light on your headphones...

Problems?
18My headphones worked b efore but now 
theyre not working
Make sure your phone is on and the Bluetooth 
feature is turned on in your phone. If the 
Bluetooth feature was turned off or was turned 
on only temporarily, you may need to restart 
the Bluetooth feature and pair your phone and 
headset again (see “Turn on & off” on page 4).