Motorola Magone Basic 6816101h01 A Manual
Have a look at the manual Motorola Magone Basic 6816101h01 A Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 249 Motorola manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Hardware Tuning Setup and Procedure 3-7 5. Then adjust R216 counterclockwise at the point where the Audio Frequency signal appears. 2.4.3 PLL Synthesizer Tuning Rx PLL Frequency Tuning 1. Set the radio to the appropriate tuning frequency (refer Table 3-1). 2. Detect output voltage at test point TP1 (refer to Figure 3-3). 3. Using the ceramic tool, adjust C710 to tune the voltage to 5.0V +/-0.1V(refer to Figure 3-5). R425 R426 C722 R216 C710 FL701 Tx PLL Frequency Tuning R215 Figure 3-5 Bottom Side of PCB 1. Set the radio to the appropriate tuning frequency (refer Table 3-1). 2. Detect output voltage at test point TP1. 3. Using the ceramic tool, adjust C722 to tune the voltage below 5.0V +/-0.1V (refer to Figure 3-5).
Introduction 4-1 Section 4 RADIO PROGRAMMING 1.0 Introduction The radios can be programmed using the Customer Programming Software (CPS). 2.0 Programming Your Radio 2.1 Overview of the Programming Process To prepare properly programmed radios for your customers, you should 1. program your radio with all the necessary parameters, as required by your customers, and then 2. clone these parameters over to all your customer‟s radios. 2.2 Cloning Radio Parameters to User Radios Cloning duplicates the contents of Radio 1 (master radio) into Radio 2 (slave radio). 2.3 Parameters which are cloned • Radio Configuration parameters • Conventional Personality parameters 2.4 Parameters which are not cloned • Unit Serial Number. • Model Number 2.5 To Clone a Radio Cloning duplicates the contents of your radio (master radio) into your customer‟s radio (slave radio). Tuning and alignment information are not affected by cloning. 2.5.1 Setting Up the Master Radio 1. Turn off the radio. 2. Press and hold Programmable Button 1 (the top programmable button) and turn on the radio. Keep pressing the Programmable Button 1 until beep is heard twice. 3. Release Programmable Button 1. Notice that the LED changes to RED.
4-2 CPS Programming 2.5.2 Setting Up the Slave Radio 1. Turn off the radio. 2. Press and hold Programmable Button 1(the top programmable button) and turn on the radio. Keep pressing Programmable Button 1 until the beep is heard three times. 3. Release Programmable Button 1. Notice that the LED changes to GREEN. 2.5.3 Radio to Radio Cloning Procedures 1. Connect the cloning cable to both the Master and Slave radio. 2. Press and release Programmable Button 1 of the Slave radio. 3. Press and release Programmable Button 1 of the Master radio. 4. The LED for both radios show flashing orange during cloning. 5. Once cloning is completed, an „Out Chirp‟ alert tone can be heard from both radios. 6. Disconnect radios from the cloning cable. They are now ready for operation. 2.6 Error Conditions An error may occur when cloning a radio. When this happens, the radio sounds a Faulty Condition Alert tone and shows a Flashing Orange LED momentarily. NOTE The LED will illuminate in RED and the radio will keep transmitting if the cloning cable is still connected to the radio after cloning is completed. Please disconnect the cloning cable from the radio 3.0 CPS Programming The CPS is designed for use in the Windows 98/NT/2000/XP and above environment. An Installation instruction manual is contained within each CPS kit. Description Kit Number Mag One™ Customer Programming Software (CD) RVN5079_
Factory Reset 4-3 Refer to the diagram below for the programming setup. Radio Programming Cable PMDN4043_R Comm Port Figure 4-1 CPS Programming Setup 3.1 To Read Radio Data to a PC 1. Turn off the radio. 2. Connect the programming cable to the radio. 3. Press and hold Programmable Button 1 (top side button on the radio), then turn on the radio. 4. The radio beeps once. Immediately release Programmable Button 1. The radio‟s LED illuminates in orange. 5. Click the Read button on the CPS. 6. The CPS shows a reading progress bar. 3.2 To Write Data to a Radio 1. Turn off the radio. 2. Connect the programming cable to the radio 3. Press and hold Programmable Button 1 (top side button on radio) then turn on the radio. 4. The radio beeps once. Immediately release Programmable Button 1. The radio‟s LED illuminates in orange. 5. Click the Write button on the CPS. 6. The CPS shows writing progress bar. 4.0 Factory Reset This feature allows the user to restore the radio to the factory default settings. 1. Press and hold both the PTT and Programmable Button 2 (the lower programmable button), while turning on the radio. 2. The radio emits the Good Key Chirp tone upon completion of the factory reset.
Antennas 5-1 Section 5 ACCESSORIES 1.0 Antennas PMAD4050_R Mag One™ 136-150MHz Antenna PMAD4051_R Mag One™150-174MHz Antenna PMAE4019_R Mag One™ 403-425MHz Antenna PMAE4020_R Mag One™ 450-470MHz Antenna PMAE4028_R Mag One™ 490-512MHz Antenna 2.0 Carry Accessories PMLN4691_R Mag One™ Belt Clip PMLN4743_ Mag One™ Spring Belt Clip 3.0 Carry Cases PMLN4741_ Soft Leather Carry Case PMLN4742_ Hard Leather Carry Case 4.0 Chargers AZPMLN4685_R Mag One™ Mid-rate Charger Base AZPMLN4686_R Mag One™ Mid-rate Charger 110V 60Hz US 2-pin AZPMLN4687_R Mag One™ Mid-rate Charger 240V 50Hz UK 3-pin AZPMLN4688_R Mag One™ Mid-rate Charger 230V 50Hz EU 2-pin PMLN4689_R Mag One™ Mid-rate Charger 220V 50Hz CN 2-pin PMLN4826_R Mag One™ Mid-rate Transformer 110V US 2-pin PMLN4827_R Mag One™ Mid-rate Transformer 240V UK 3-pin PMLN4828_R Mag One™ Mid-rate Transformer 230V EU 2-pin PMLN4830_R Mag One™ Mid-rate Transformer 220V CN 2-pin 5.0 Batteries PMNN4071_R Mag One™ NiMH Battery, 1200mAH PMNN4071_RC Mag One™ NiMH Battery 1200mAH (Chinese Label)
5-2 Audio Accessories 6.0 Audio Accessories PMMN4008_ Remote Speaker Microphone PMLN4442_ Earbud with in-line microphone and PTT/VOX switch PMLN4443_ Ear Receiver with in-line microphone and PTT/VOX switch PMLN4445_ Ultra Lightweight Headset with in-line PTT/VOX switch PMLN4294_ Earbud with microphone and PTT combined PMLN4605_ Clear Acoustic Tube (replacement kit) PMLN4606_ 2-Wire Surveillance kit with Clear Acoustic Tube PMLN4658_ D-shell Earset with Boom Microphone with PTT/VOX switch 7.0 Publications 6815549H01 A8 User Guide (APAC English) 6815553H01 A8 User Guide (APAC Chinese) 6815692H01 Mag One™ by Motorola Series Radio Service Manual, English 6815693H01 Mag One™ by Motorola Series Radio Service Manual, Chinese 6816103H01 Mag One™ Warranty Card 6816309H01 Mag One™ CPS User Guide 6816189H01 Mag One™ Mid-Rate Charger User Guide (APAC) 8.0 Service Kits PMDN4038_R Chassis Opener PMDN4039_R Crab Eye Nut Opener PMDN4040_R Test Box PMDN4041_R RF Adapter PMDN4042_R Battery Eliminator PMDN4043_R Programming Cable PMDN4060_R Cloning Cable PMDN4054_R Antenna Ground Plate PMDN4044_R T-Head Ceramic Tuning Tool PMDN4053_R Flat Ceramic Tuning Tool (0.9mm) PMDN4026_R Flat Ceramic Tuning Tool (1.8mm)
VHF Band 1 Information (136-150 MHz) 6-1 Section 6 MODEL CHART AND TEST SPECIFICATION NOTE For specific models and options configuration, please refer to the Price Pages available on Motorola Online at https://businessonline.motorola.com/ . 1.0 VHF Band 1 Information (136-150 MHz) A8 136-150 MHz VHF Model Description LAH84JDC8AA4AN Option STDCHG0027AE Option Q665AG Option Q312BD Option Q91AB Option H951FF Item A8 136-150 MHz, 5W, 12.5/25K-16CH Standard Mid-Rate Charger 120V US Plug 60Hz Mid-Rate Charger 230V EURO Plug 50Hz Mid-Rate Charger Base Only - Argentina Mid-Rate Charger 240V UK Plug 50Hz Delete Standard Charger Description X X X X X X PMUD2088_AL A8 136-150 MHz 5W 12.5/25K - 16CH X X X X X X PMAD4050_ X X X X X X PMNN4071_ X X X X X X PMLN4691_ X PMLN4685_ X 2515945H01 X PMLN4685_ X 2515943H01 X PMLN4685_ X PMLN4685_ X 2515942H01 X X X X X X PMLN4739_ X X X X X X 68P81095C98 VHF 136-150MHZ Antenna NiMH Battery Belt Clip Mag One Mid-Rate Charger Base Mag One Mid-Rate Transformer 110V US 2-pin Mag One Mid-Rate Charger Base Mag One Mid-Rate Transformer 230V EU 2-pin Mag One Mid-Rate Charger Base Mag One Mid-Rate Charger Base Mag One Mid-Rate Transformer 240V UK 3-pin A8 User Guide ENG/SPAN/POR and Charger manual Safety Leaflet - Portable 2-Way Radios
6-2 2.0 Specifications General VHF Frequency: 136-150MHz Channel Capacity: 16 Power Supply: 7.5 Volts ±20% Dimensions with 118mm x 56mm x 37mm Standard High Capacity NiMH Battery: Weight with 350g Standard High Capacity NiMH Battery: Sealing: Passes rain testing per IPX4 (EN60529=1991) Shock and Meets MIL STD 810C, D Vibration: E and F Dust: Meets MIL STD 810C, D E and F Humidity: Meets MIL STD 810C, D E and F Specifications Transmitter VHF Channel Spacing 12.5/25 kHz Freq. Stability 0.00025% (-30°C to +60°C) Spurs/Harmonics: -26 dBm Audio Response: +1, -3 dB (from 6 dB/oct. Pre- Emphasis, 300 to 3000Hz) Audio Distortion: