Motorola I30sx User Guide

							133
Settings
After Phone — Set the time that the recent calls screen displays after a 
phone call.
After Prvt/Group — Set the time that the recent calls screen displays after 
a private or group call.
To set the recent calls timeout.:
Vo i c e  Vo l u m e
Voice Volume sets the volume of the sound coming from your phone’s earpiece 
or speaker:
Tkgrp (Talkgroup) Settings
Tkgrp Settings enables you to set certain Talkgroup options. See “Group Call” 
on page 110 for more information.
1From the Initial Setup screen, press R to scroll to Return to Idle:.
2Press C under CHANGE.
3Press S to scroll to the desired display option.
4Press C under SELECT.
1From the Vo i c e  Vo l u m e screen, highlight Earpiece Vol to set the 
earpiece volume, or press 
R to scroll to Speaker Vol to set the speaker 
volume.
2Press C under CHANGE. 
3To select a volume level:
Press 
T to raise or lower the volume setting.
Or,
Press the volume control buttons on the side of your phone.
4Press C under OK. 
						

							134
nextel.com
Service Status
The Service Status screen shows the status of your Nextel services. This screen 
is for information only; no options can be set. 
						

							135
Accessories
To order additional accessories or an accessories catalog, go to nextel.com or 
call Nextel NextdaySM Accessories at 1-800-914-3240. You can also contact 
your Nextel Authorized Sales Representative or stop by any Nextel Store. For 
information on Nextel retail store locations, go to nextel.com.
This section includes information on the following accessories:
i30sx Faceplates and Keypads 
Your i30sx phone comes with a standard faceplate and keypad. You can order 
additional face plates and keypads to change the look of your phone.
The following steps and accompanying illustration detail the procedure for 
removing and replacing the changeable faceplate and keypad.
NOTE: Before replacing the faceplate, ensure that the keypad is 
present and undamaged. For security and operational reasons, 
power to the i30sx phone should be off prior to performing the 
removal and replacement procedure. There is a protective 
plastic liner over the lens. Peel off prior to operation. 
Removal and Replacement Procedure
i30sx Faceplates and Keypads Page 135
BatteriesPage 137
Chargers Page 138
Data AccessoriesPage 140
1While holding the back of the phone, press the 
faceplate release button located at the bottom of 
the phone to release the faceplate. When you 
press the release button, ensure that both sides 
are disengaged from the faceplate prior to 
removal. 
2In an upward motion, grasp the bottom part of the faceplate and detach 
it from the phone. 
Release Button 
						

							136
nextel.com
3Remove the keypad from the phone (or from the faceplate).
4To replace the faceplate and keypad, lay the keypad on the phone body.
5As shown in the illustration, attach the faceplate to the phone body, first 
at the top and then at the bottom. The top of the faceplate needs to be 
securely seated into the top of the phone. Rotate faceplate towards 
bottom of the phone until the lower snaps are engaged. Snap 
engagement will be verified by a clicking sound. After the lower snaps 
are engaged, verify that the middle of the faceplate is engaged by 
pressing the faceplate near the  s and r keys. This will be verified by 
a clicking sound.
6Re-apply power to the phone by pressing and holding p near the 
bottom of the phone until the status light glows red and a tone briefly 
sounds. 
						

							137
Batteries
Batteries
For best results, charge the batteries within the temperature range of 10oC to 
40oC (50oF to 104oF).
Prolonged charging is not recommended. For battery charging guidelines, see 
“Battery Charging Times” on page 137.
Charging Lithium Ion Batteries
The following table provides the approximate time to fully charge a battery 
using a Motorola iDEN Approved Lithium Ion battery charger. Check the item 
number on your battery and charger to determine the appropriate charging time.
                                             Battery Charging Times 
NOTE:  Charging times are based on a fully discharged battery.
Battery Operating Instructions
Extreme temperatures will degrade battery performance. Do not store your 
battery where temperatures exceed 60°C (140°F) or fall below -20°C (4°F).
Lithium Ion batteries have a self discharge rate and without use, will lose 
about 1% of its charge per day.
The battery capacity will be degraded if stored for long periods while fully 
charged. If long term storage is required, store at half capacity. 
The Motorola iDEN Approved Lithium Ion chargers will provide optimum 
performance. Other chargers may not fully charge your iDEN Lithium Ion 
battery or may yield reduced number of lifetime charge cycles. 
When batteries are not in use, always store them in the plastic safety tray.
 MOTOROLA BATTERIES                         Charging Time to 100%
Kit NumberDescription/
ChemistryStandard 
Charger 
(SPN4808)Rapid 
Charger 
(SPN4716)Mid Rate 
Charger 
(SPN4940) 
SNN5716 Maximum 
Capacity Battery8 hours       3 hours 8 hours     
SNN5705 Standard  Battery  5  hours 2 hrs 30 min      5  hours 
						

							138
nextel.com
Chargers
Using one of the Chargers listed below, you can charge a battery from an AC 
outlet. On one end of the Charger, an accessory connector attaches to the bottom 
of the phone. At the other (AC outlet) end of the device, there is a compact 
housing that contains the plug-in power supply. 
NOTE: Additional adaptor plugs to accommodate various International 
power outlets can be purchased separately for the Mid-Rate and 
Rapid Travel Chargers.
CHARGERS
Item 
NumberDescription
SPN4940 Mid-Rate Travel Charger
SPN4716 Rapid Travel Charger
SPN4992 Standard Charger
Accessory 
Connector 
Standard Charger Accessory 
Connector
Rapid Travel Charger 
						

							139
Chargers
Using the Charger
Mid-Rate Charger Operating Specifications
Input voltage range: 90-264 VAC @ 50/60 Hz.
Operating temperature range: 0°C to +50°C
Standard Charger (U.S. Only)
Input voltage range: 90-120 VAC @60Hz.
Operating temperature range: 0°C to +50°C
1While holding the phone with its keypad facing up, insert the accessory 
connector into the bottom of the phone until you hear a click.
2If you have either the Mid-Rate Charger or the Rapid Charger, flip open 
the prongs, and plug the Charger transformer into an AC wall outlet. 
Or,
If you have the Standard Charger, plug the charger transformer into an 
AC wall outlet. 
						

							140
nextel.com
Data Accessories
The i30sx phone supports both RS232 communications and USB 
communications (with USB mother devices). The i30sx phone will 
automatically detect whether an RS232 or USB cable has been connected to it 
and will utilize the appropriate protocol. No other action is required in order to 
select between USB or RS232 serial communications.
iDEN PC applications will support USB drivers for the following operating 
systems only:
Windows 98
Windows 2000
Windows ME
Windows XP
USB Cable
RS232 Cable 
						

							141
Other Important Information
This section includes the following topics:
Nextel Customer Care
Relax! Nextel Customer Care is here to help. There are lots of features packed 
into your Nextel service...and into your i30sx phone. But don’t worry. If, after 
reading this guide, you still have questions about coverage, billing, Nextel 
Direct Connect or any other service or feature, contact us.
Domestic Customer Care
Visit nextel.com for a variety of Customer Care services:
Browse for information on phones, coverage, rates and other Nextel 
services. View and download users guides, try out our interactive virtual 
product and service demos, find answers to frequently asked questions, 
order accessories, locate service and repair centers, upgrade phone 
software, send a message and more.
For self-service on your Nextel account, click on My Account to view 
your account, pay your bill, add phones to your account, reset your Voice 
Mail password, add Nextel Online services and more.
For online assistance, click on Contact Us to send us an email request. Our 
representatives are committed to assisting you. Every effort will be made to 
address your questions or concerns within 24 hours. Contact us to add 
Nextel Online and other services, change rate plans, inquire on your bill 
and more.
Or, call us at 1-800-639-6111 or dial 611 from your Nextel phone.Nextel Customer Care   Page 141
Understanding Status MessagesPage 142
Nextel Terms and Conditions of Service Page 145
Safety and General Information  Page 151
Limited Warranty Information Page 161
Patent and Trademark InformationPage 169 
						

							142
nextel.com
Nextel Worldwide Customer Care 
We’ll be happy to give you help, explanations and anything else you need to 
enjoy your Nextel service as soon as possible!
Call us at 1(360) 662-5202 (toll free) from your Nextel phone.
Before you contact Nextel Customer Care for service or to resolve an issue, be 
sure to have your Nextel Personal Telephone Number, your model number 
(located on your phone underneath the battery), and the ID number printed on 
your SIM card. You’ll want to record these numbers and keep them handy so 
that you can replace the battery prior to contacting Customer Care.
Understanding Status Messages
You may receive status messages under certain conditions. Before contacting 
Nextel Customer Care, note the message, numeric code, and the conditions 
under which it appeared. The following table lists and describes the status 
messages.
 
Status Messages Message Description
Number Not in ServiceThe number that you entered is not valid.
User Not AvailableThe phone that you called is either busy, out-
of-coverage, or turned off. Please try again 
later.
User Not AuthorizedThe person that you called has not purchased 
this service.
Please Try LaterThis service is temporarily not available. 
Please try again later.
User Busy in PrivateThe phone that you called is busy in a Private 
Call.
User Busy in DataThe phone that you called is busy using Nextel 
Online services or Nextel Online Dial-Up 
Service.
Service RestrictedThis service was restricted by Nextel, or this 
service was not purchased.