Motorola Gm Series Detailed 6864115b62 B Manual

GM640/GM660/GM1280 Model Chart1-3
3.0 GM640/GM660/GM1280 Model Chart
GM Series UHF 403-470 MHz
Model Description
MDM25RHC9CK1_EGM640, 403-470 MHz, 1-25W, 6 Ch
MDM25RHF9CK5_E GM660, 403-470 MHz, 1-25W, 255 Ch
MDM25RHN9CK8_EGM1280, 403-470 MHz, 1-25W, 255 Ch
MDM 25 RH A9C K7_E   Dat ab ox,  40 3-4 70  MHz,  1-2 5W ,  16  C h
Item Description
XGCN6112_Control Head GM640
X GCN6120_ Control Head GM660
XGCN6121_Control Head GM1280
X GCN6116_ Databox Radio Blank Head
XI M UE6009 _AS/T 403-470MHz 1-25 SEL5
X...

1-4 MODEL CHART AND TECHNICAL SPECIFICATIONS
4.0 Technical Specifications
Data is specified for +25°C unless otherwise stated.
General Specifications
Channel Capacity
GM140
GM160
GM340
GM360
GM380
GM640
GM660
GM1280
Databox
4
128
6
255
255
6 
255
255
16
Power Supply 13.2Vdc (10.8 - 15.6Vdc)
Dimensions:  H x W x D (mm)  Depth excluding knobsGM140/340/640
56mm x 176mm x 177mm (1 - 25W)
56mm x 176mm x 189mm (25 - 40W)
(add 8mm for Volume Knob)
Dimensions:  H x W x D (mm)  Depth excluding knobsGM160/360/660...

Technical Specifications1-5
*Availability subject to the laws and regulations of individual countries.
Transmitter UHF
*Frequencies - Full BandsplitUHF 403-470 MHz
Channel Spacing12.5/20/25 kHz
Frequency Stability
(-30°C to +60°C, +25° Ref.)±2.0 ppm
Power 1-25W/25-40W
Modulation Limiting±2.5 @ 12.5 kHz 
±4.0 @ 20 kHz
±5.0 @ 25 kHz
FM Hum & Noise-40 dB @ 12.5kHz
-45 dB @ 20/25kHz
Conducted/Radiated Emission (ETS)-36 dBm 1 GHz
Adjacent Channel Power-60 dB @ 12.5 kHz
-70 dB @ 25 kHz
Audio Response (300 -...

1-6 MODEL CHART AND TECHNICAL SPECIFICATIONS 

Chapter 2
THEORY OF OPERATION
1.0 Introduction
This Chapter provides a detailed theory of operation for the UHF circuits in the radio. For details of 
the theory of operation and trouble shooting for the the associated Controller circuits refer to the 
Controller Section of this manual.
2.0 UHF (403-470MHz) Receiver
2.1 Receiver Front-End
The receiver is able to cover the UHF range from 403 to 470 MHz. It consists of four major blocks: 
front-end bandpass filters and pre-amplifier, first mixer, high-IF,...

2-2THEORY OF OPERATION
There are two 2-pole 44.85 MHz crystal filters in the high-IF section and 2 pairs of 455 kHz ceramic 
filters in the low-IF section to provide the required adjacent channel selectivity .The correct pair of 
ceramic filters for 12.5 or 25KHz channel spacing is selected via control line BWSELECT. The 
second IF at 455 kHz is mixed, amplified and demodulated in the IF IC. The processing of the 
demodulated audio signal is performed by an audio processing IC located in the controller...

UHF (403-470MHz) Transmitter Power Amplifier (PA) 25 W 2-3
produce the low IF signal at 455 kHz. The 2nd LO frequency is determined by crystal Y3101. The 
low IF signal is amplified and filtered by an external pair of 455 kHz ceramic filters FL3112, FL3114 
for 20/25 kHz channel spacing or FL3111,FL3113/F3115 for 12.5 kHz channel spacing. These pairs 
are selectable via BWSELECT. The filtered output from the ceramic filters is applied to the limiter 
input pin of the IF IC (pin 14).
The IF IC contains a...

2-4THEORY OF OPERATION
controlled by a DC voltage applied to pin 1 from the op-amp U4402-1, pin 1. The control voltage 
simultaneously varies the bias of two FET stages within U4401. This biasing point determines the 
overall gain of U4401 and therefore its output drive level to Q4421, which in turn controls the output 
power of the PA.
Op-amp U4402-1 monitors the drain current of U4401 via resistor R4444 and adjusts the bias 
voltage of U4401 so that the current remains constant. The PCIC (U4501)...

UHF (403-470MHz) Transmitter Power Amplifier (PA) 25 W 2-5
3.5 Antenna Switch
The antenna switch consists of two PIN diodes, D4471 and D4472. In the receive mode, both diodes 
are off. Signals applied at the antenna jack J4401 are routed, via the harmonic filter, through 
network L4472, C4474 and C4475, to the receiver input. In the transmit mode, K9V1 turns on Q4471 
which enables current sink Q4472, set to 96 mA by R4473 and VR4471. This completes a DC path 
from PASUPVLTG, through L4437, D4471, L4472,...

2-6THEORY OF OPERATION
4.0 UHF (403-470MHz) Frequency Synthesis
The synthesizer subsystem consists of the reference oscillator (Y4261 or Y4262), the Low Voltage 
Fractional-N synthesizer (LVFRAC-N, U4201), and the Voltage Controlled Oscillator VCO.
4.1 Reference Oscillator
The reference oscillator (Y4262) contains a temperature compensated crystal oscillator with a 
frequency of 16.8 MHz. An Analogue to Digital (A/D) converter internal to U4201 (LVFRAC-N) and 
controlled by the microprocessor via serial...