Mitsubishi Xd211u Data Projector User Manual

EN-21
ENGLISH
Troubleshooting
Before asking for repair of the projector, check the following. If the symptom persists, stop using the projector, be sure to unplug the power plug, and 
then contact your dealer.
No image appears on the screen.
 
ProblemSolution
Power can not be turned on.• Check whether the indicators are on or off and how they are lightning. 
No image appears on the screen.• Cancel the AV mute by pressing the AV MUTE button.
• Check that the lens cap is removed.
• It may take about 1...

EN-22
Troubleshooting (continued)
Images are not displayed correctly.
ProblemSolution
Projected images are shaking.
Projected images are displaced.• Check that the cable connected to the external device isn’t intermittent.
• Connect the cable’s plug with the external device’s connector firmly.
• Press the AUTO POSITION button.
• Some computers output out-of-spec signals on rare occasion. Adjust the Computer Image menu. (See page 
17.)
Projected images are distorted. • Adjust the projector and the screen...

EN-23
ENGLISH
Troubleshooting (continued)
Others
If the following problem occurs after the lamp is replaced, check the following first.
Maintenance 
Warning:Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols when cleaning the projector body and lens. Flammable substances 
may ignite causing fire or breakdown while the lamp is illuminating.
Caution: Be sure to turn off the lamp and unplug the power cord from the wall outlet before you perform any maintenance on the projector....

EN-24
Indicators
This projector has two indicators, each of which shows the operation condition of the projector. 
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.
Normal condition
Abnormal condition
POWERSTATUSCONDITIONNOTE
Stand-by
The projector is in good condition.
The projector is shutting and the fan motor is cooling the lamp for 
shutdown. Do not unplug the power cord or turn the power off 
before the POWER LED changes to...

EN-25
ENGLISH
Specifications
• The specifications and outside appearance of the projector are subject to change without prior notice. 
Type DLP™ DATA projector 
Model XD211U
Rated power supply 100 - 240 V AC, 50 / 60 Hz 
Rated input 2.5 A
Display Technology0.55-inch Single chip Digital Micromirror Device (DMD) 
Pixels 1024 x 768 = 786432 pixels
Colors 16770000 colors
Projection lens F 2.5 - 2.7, f = 19.9 - 23.9 mm
Light source lamp 180 W
Picture size 40 - 300 inch (aspect ratio 4:3) 
PC...

EN-26
Specifications (continued)
Connectors
Dimensional drawings (unit : mm)
What’s included in the box
Replacement part
15 11
610 15
pin No.Spec.
1 R(RED)/C
R
2 G(GREEN)/Y
3B(BLUE)/C
B
4NC
5GND
6GND
7GND
8GND
9DDC5V
10-
11-
12 DDC Data
13 HD/CS
14 VD
15 DDC Clock
pin No.Spec.
1R(RED)
2G(GREEN)
3B(BLUE)
4-
5GND
6GND
7GND
8GND
9-
10 GND
11 GND
12 -
13 HD/CS
14 VD
15 -
COMPUTER IN/MONITOR OUT (D-SUB 15-pin)
IN OUT
AC power cord
1 RGB cable for PCfor US J2552-0063-01
for EU J2552-0066-01
for UK...

EN-27
ENGLISH
Specifications (continued)
Specification of RGB signals in each computer mode of the projector 
Important:
• Some computers aren’t compatible with the projector.
• The projector’s maximum resolution is 1024 x 768 pixels. It may not display images of higher resolutions than 1024 x 768 (or 800 x 600) cor-
rectly.
• Images with SYNC on G (Green) signal may jitter.
• Images with SYNC on G (Green) signal may be tinged with green.
• If the resolution and frequency of your computer aren’t shown on...

EN-28
MITSUBISHI Projector Contact Information
1 Zusho Baba, Nagaokakyo-City, Kyoto Japan
MITSUBISHI ELECTRIC CORPORATION
North America
MESCA (Mitsubishi Electric Sales Canada Inc.)
http://www.mitsubishielectric.ca
Information Technologies Group, 4299 14th Avenue, 
Markham, Ontario L3R 0J2, Canada
Sales & Technical Inquires
 Phone :+1-(800) 450-6487
 Fax :+1-(905) 475-7958
 E-mail :[email protected]
Customer Care
 E-mail :[email protected]
MDEA (Mitsubishi Digital Electronics...