Mitsubishi CP D2E User Manual

Printing pictures from a PC
Printing
EN-31
Print screen: The following items can be set.
ItemContents
Printer Select [CP-D2E].
Presets Select [Standard], then select [Printer Features]. From the [Feature Sets], 
select [Setting 1] or [Setting 2].
Setting 1 Saturation Set the [Saturation] from 0 to +10 (strongest).
Brightness Set the [Brightness] from -5 (darkest) to +5 (brightest).
Contrast Set the [Contrast] from -5 (lightest) to +5 (strongest).
Sharpness Select the [Sharpness] among [OFF], [Soft],...

Loading the paper and replacing the ribbon cartridge
Additional information
EN-32
Additional information
Loading the paper and replacing the ribbon 
cartridge
If paper runs out during printing
The PAPER indicator blinks slowly. Load paper into the paper-cassette. The remaining data is automatically 
printed.
Under normal circumstances the ribbon will end at the same time as the paper runs out. Replace the ribbon 
cartridge with a new one.
If the ribbon runs out during printing
The RIBBON indicator blinks...

Error signals
Additional information
EN-33
Error signals
* This light goes off when the connection is complete.
IndicatorIndicator  
statusPrinter statusSolutionPage(s)
Power On Power ON
–18
Off Power OFF
Access On* Connected to a 
digital camera, or 
the printer is 
cooling offWait for a while. Do not disconnect 
the digital camera or PC.
–
Blinking 
slowlyCommunicating
Blinking 
very slowlyPrinting
––
PAPER Blinking 
slowlyOut of paper Load paper into the paper-cassette. 22, 32
RIBBON Blinking...

Troubleshooting
Additional information
EN-34
Troubleshooting
Before asking for repairs, check the printer using the following checklist. If the problem still occurs, contact  
your dealer.
ProblemCause / statusSolutionPage(s)
The power does not 
turn on.The AC adapter is not connected. Connect the AC adapter. 18
The ribbon 
cartridge cannot be 
removed.The power turns off during printing. Push the ribbon cartridge until it 
clicks. Turn on the printer again, 
and wait until the operation 
sound stops.–...

Troubleshooting
Additional information
EN-35
Trimming 
specification is 
ignored although it 
is included in the 
print reservation 
information.The printer does not support 
trimming.
––
Noise interferes 
with printed 
images.Pictures that were not taken with a 
digital camera were printed from a 
digital camera.Images that were not taken by a 
digital camera must be printed 
from a PC.27
The printing 
interval has 
become longer.The printer is designed to prevent 
overheating by automatically...

Troubleshooting
Additional information
EN-36
When paper is jammed
When paper is jammed, the Access and PAPER indicators blink and printing stops.
Follow these steps to remove jammed paper.
1Turn off the printer.
2Remove the paper-cassette.
3Turn on the printer again. The paper should be ejected automatically.
If the paper is automatically ejected, go to Step 8.
If the paper is not automatically ejected, turn off the printer and go to Step 4.
4Check the inside of the paper-cassette door to see whether...

Troubleshooting
Additional information
EN-37
6Pull the paper out.
7Turn on the printer.
8Re-set the paper-cassette.
If the printer operates normally, the paper jam problem has been solved. You can continue printing.
If the ribbon cartridge is removed during printing
1
Turn off the printer.
2Insert the ribbon cartridge all the way, and then be sure to close the ribbon cartridge 
door.
3Turn on the printer.
If the paper-cassette is removed during printing
1
Turn off the printer.
2Insert the paper-cassette...

About the paper/ink ribbon set
Additional information
EN-38
About the paper/ink ribbon set
When ordering, please specify the models indicated in the table below.
The used ribbon cartridge is not reusable.
Handle ribbon cartridges carefully to ensure that they remain clean.
Do not disassemble ribbon cartridges.
Fingerprints, dust, scratches, oil, or other debris on the print surface may degrade printing quality.
Do not use sheets of paper that have already been printed on. A failure might occur. Do...

About the paper/ink ribbon set
Additional information
EN-39
Notes on storing printed paper
Do not store printed paper with their printed surfaces facing each other.
Do not leave the printed surface in contact with an adhesive tape, desk mats, plastic erasers, or similar objects 
for a long time. Discoloration might occur.
Do not apply organic solvent to printed surfaces. Discoloration might occur.
Do not expose printed surfaces to sunlight or other strong light sources for a long time. Discoloration...

Specifications
Additional information
EN-40
Specifications
Printer
AC adapter
Requires a power cord that meets the safety standards of your country.
The specifications and design are subject to change without notice. Printing method Dye sublimation thermal transfer printing
Resolution 306 dpi
Paper size 4 × 6 paper : 3.9 × 5.8 (H × W)
(after perforated)
Color representation Over 16.77 million colors
Printing speed 4 × 6 paper : Approx. 88 seconds per sheet
(excluding data transmission time from digital...