Miele T 8823 C Manual

Front view
Supply cable for electrical
connection
Condensed water container
Control panel
DoorService panel for condenser unit
Four height-adjustable screw feet
External drainage options (e.g. via
wash basin, wash basin drain outlet,
or gully).
Installation
41 

Rear view
Protruding lid for holding when
moving the machine (see arrows)
Air inlet vent for cooling the
condenser unit
Mains connection cable
Hose for external drainage of
condensed water
Accessories for connection to a sink
drain outlet
Installation site
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the machine to its
installation site
When moving the dryer, hold it by the
lid where it protrudes to the rear. To
manoeuvre the machine out of its
packing...

Levelling the machine
The machine must be perfectly level to
ensure safe and proper operation.

The screw feet can be adjusted to
compensate for any unevenness in
the floor.
The air inlet and outlet vents on
the front of the machine must not be
covered as this would prevent
sufficient ventilation for cooling the
condenser unit.
The gap between the base of the
dryer and the floor must not be
minimised by a plinth or thick-piled
carpet as this will prevent a
sufficient intake of cold air.
Room...

External condensed water
outlet
General notes
When drying is in progress, condensed
water is pumped into the condensed
water container through the drain hose at
the back of the dryer. The condensed
water can also be drained off directly if
the machine is installed near a sink, drain
outlet etc. so that the condensed water
container does not have to be emptied.
Drain hose length............1.50 m
Maximum delivery head.......1.50 m
Maximum drain hose length....4.00 m
If the on-site water drainage
system...

External drainage via a sink or gully
See Front view illustration.
If you want to drain the water off
into a sink, you will need to secure
the hose carefully, e.g. by tying it to
a tap to make sure it cannot slip
during use. Otherwise there is a risk
of overflowing water which could
cause damage.
Use the bow-shaped guide to
prevent the drain hose from
becoming kinked.
Installation conditions requiring a
non-return valve
Certain installation conditions
require the fitting of a non-return
valve...

1 Adapter
2 Nut
3 Hose clip
4 End of the hose
5 Non-return valve
6 Tumble dryer drain hoseFit adapter1to the sink drain outlet
using nut2.
If this nut has a flat disc in it, you
should take the disc out first.
Attach the end of the hose4to
adapter1.
Use a screwdriver to tighten hose
clip3up close to the nut.
Non-return valve5has to be
fitted with the arrow pointing in the
direction of flow (i.e. towards the
sink). Otherwise water will not drain
out of the machine.
Fit non-return valve5to the tumble...

Electrical connection
This tumble dryer is supplied ready for
connection to an AC single phase
supply. The machine is supplied with a
mains cable with moulded plug.
The accesibility of the plug must be
always ensured in order to separate the
dryer from the mains.
The appliance should be connected up
only by a qualified electrician, in
accordance with national and local
safety regulations.
For extra safety, it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
The...

Load1Final spin speed in a
domestic washing
machineResidual
moistureEnergy Duration
kg rpm % kWh min.
CottonsNormal27.0 1000 60 3.80 121
Cottons Normal7.0
7.0
7.0
7.01200
1400
1600
180053
50
48
433.45
3.25
2.90
2.85110
105
95
93
Cottons Normal
+ Low temperature7.0 1000 60 4.10 169
Cottons Hand iron27.0 1000 60 3.00 96
Cottons Hand iron7.0
7.0
7.0
7.01200
1400
1600
180053
50
48
432.65
2.50
2.10
2.0585
80
70
68
CottonsNormal23.5 1200 40 1.35 44
Minimum iron Normal
+ Low temperature3.5 1200 40 1.40 66...

Height 850 mm
Width 595 mm
Depth 587 mm
Depth with door open 1,062 mm
Height for building under 820 mm
Width for building under 600 mm
Depth for building under 600 mm
Suitable for pushing under a
worktopYes
Suitable for stacking Yes
Weight 51 kg
Drum volume 111 l
Maximum capacity 7 kg dry weight
Capacity of condensed water
containerapprox. 4.2 l
Drain hose length 1.5 m
Maximum delivery head 1.5 m
Maximum drain hose length 4 m
Length of connection cable 2 m
Voltage
Rated load
Fuse rating See data plate...

Extending the range of the
drying level for the Cottons
programme
The electronics of this dryer ensure a
very effective and energy efficient
drying process.
You can, however, extend the range
of the drying level in this programme.
Follow steps (
,,...) to
programme and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
– The door is closed.

Press theStart/Stopbutton and keep
it pressed in whilst carrying out steps
-.
Switch the dryer on.
Wait until the indicator...