Miele Kfn12924sd-1 Manual

Fit hinge pin
into middle hinge
platein the lower door. The ridge
on the hinge pin will fit into the notch
in the hinge plate.
Then fit the upper door on middle
hinge pin
.
Close the upper door.

Fit hinge plateonto the opposite
side and secure it with screws.
If necessary drill pilot holes for the
screws or use a battery operated
screwdriver.

Fit coversandto their opposite
sides.Align the door with the appliance
housing using the long slots in the
lower hinge plate. Then tighten the
screws....

Refitting the handles
Please make sure you follow the
instructions below carefully when
you refit the handles. The door seal
will be damaged if the handle is
fitted incorrectly.
Loosely attach the handle to the
opposite side of the door with the two
front screws.
Mounting platemust be positioned
on the side of the door so that when the
door isclosedit is flush with the side of
the appliance.
If this is not the case,

tighten both grub screwswith a
suitable allen key until mounting plate
lines up...

The appliance doors can be aligned
with the housing after they have been
fitted.
In the following illustration the door is
not shown in the closed position to
make it easier to see what you have
to do.
To align thelower dooruse the long
outer slots in the lower hinge plate:
Remove centre screwfrom the
hinge plate.

Slightly loosen both outer screws.

Align the door by sliding the hinge
plate to the left or right.

Then tighten screwsagain. Screw
does not need to be used again.To align theupper...

* The appliance depth is increased
by approx. 35 mm for appliances
with wall spacers fitted.
Top box
Appliance
Housing unit
WallThe appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top box.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance across the entire width of the
top box for air to circulate.
The cross section of the air outlet under
the room ceiling must be at least
300...

55 

Alteration rights reserved / 0313
KFN12823SD(-x), KFN12823SDedt/cs-x, KFN12923SD(-x), KFN12923SDedt/cs-x, KFN12924SD-xM.-Nr. 09 435 380 / 00