Miele Kfn 8767 Sed Operating And Installation Instructions

Never re-freeze partially or fully
defrosted food. Consume defrosted
food as soon as possible as it will
lose its nutritional value and spoil if
left for too long.  Defrosted food may
only be re-frozen after it has been
cooked.
Ice cubes
(with or without release button
depending on model)
^Press down the release button on the
ice cube tray and fill the tray with wa-
ter. Any excess will flow out through
the outlet.
^Now pull the release button up to
seal the ice cube tray. Place the tray
on the bottom of...

Cool pack
The cool pack prevents the
temperature in the freezer rising too
quickly in the event of a power cut.
Place the cool pack in the upper
drawer directly on top of food or to save
space on the freezer tray. The cool
pack will be at its most effective after it
has been in the freezer for approx. 24
hours.
If there is a power cut, place the cool
pack directly on top of the frozen food
in the upper drawer so that the food will
be kept cold for as long as possible.
When placing fresh food in the...

Refrigerator section and
StayFresh zone
Condensate and frost can build up on
the back wall of the refrigerator section
and the StayFresh zone whilst in use.
These are automatically removed and
defrosted by the appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate can flow away without
hindrance.
Freezer section
This freezer is...

Never use cleaning agents
containing abrasive substances
such as sand, soda, acids or
chemical solvents. Non-abrasive
cleaning agents are also unsuitable
as they can cause matt areas to
appear.
For stainless steel surfaces, use a
proprietary stainless steel cleaning
agent.
Do not let water get into the
electronic unit, ventilation gaps or
into the light.
Do not let water get into the
drainage channel and drain hole
when cleaning.
Do not use steam cleaning
apparatus to clean the appliance.
Steam could...

Ventilation gaps
^The ventilation gaps should be
cleaned regularly with a brush or
vacuum cleaner. A build-up of dust
will increase the energy consumption
of the appliance.
Door seals
Do not use any grease or oil on the
door seals as these will cause the
seals to deteriorate and become
porous over time.
The door seals should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
Metal grille at the back of the
appliance
The metal grille at the back of the
appliance (heat exchanger)...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting the Service
Department.
What to do if . . .
. . . the refrigerator section or freezer
section does not get cool.
^Check whether the respective section
is switched...

... the compressor is running
constantly
When the appliance is sufficiently cold
inside, the compressor will switch on for
longer, but at a low setting to save
energy.
. . . the frozen food is thawing
because the freezer section is too
warm.
^Is the room temperature lower than
the ambient temperature for which
the appliance is designed?
If so, raise the temperature of the
room.
Operating in a room which is too cold
will cause the cooling system to switch
off for too long causing the freezer
section to...

The warmest temperature will show in
the display for about 1 minute. The
display will then revert to showing the
current temperature in the freezer
section.
At the end of a power cut, the
appliance will start operating again at
the last temperature setting selected.
. . . the super freeze or super cool
indicator light is not lit up although
the appliance is working.
The indicator light is defective. Call the
Service Department.
...you cannot switch the appliance
off.
The safety lock has been activated.
....

If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature it is advisable not to
open the door while waiting for the
appliance to be serviced.
Problem solving guide
39
 

Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Remember that the noise of the...