Miele Kf 1901 Vi Operating And Installation Instructions

							Mieles RemoteVision Wi-Fi technology
creates a virtual link between your
appliance and our monitoring center. If
a fault occurs, Mieles client service
center will be notified and contact you,
or another trusted individual identified
on your call roster, in order to gain
access to your appliance to fix the
problem.
For information on set-up and
installation of the RemoteVision module
see the Installation section of this
manual.Be sure your wireless system meets the
following requirements
–A wireless router that supports an
IEEE 802.11b protocol
–Windows XP
®or newer operating
system, Mac®OS X 10.3 or higher
–Cable or DSL modem
–Microsoft
®Internet Explorer 6 or
higher, Safari 2.0 or higher, Firefox
1.5 or higher
* Please note that each wireless router
manufacturer supplies their own device
drivers and setup programs. Due to the
differences in manufacturers, exact
router setup instructions are not
included in this manual. Wording and
instructions may vary.
RemoteVision (optional accessory)
81
 
						

							Accessing the RemoteVision
control panel
Touch the access button soit
turns yellow.
Note the position of thebutton, but
do not touch.
Touch the access button  again so
it turns white.
Only the access button  is visible.
Place one finger on the position of
thebutton and hold (thebutton
will not be visible).
While holding down thebutton,
press the access button  once.
Keep holding thebutton down until
the following appears in the display
(approx. 5 seconds).
Access to the Custom settings mode is
now active for approximately 10
seconds.Tap thebutton untilappears in
the display.
Touch the access button to
confirm.
See the table on the following page for
a description of each setting in the
display.
Use theorbuttons to select the
RemoteVision options.
The module has been connected to
the network when#appears in the
display.
If#does not appear, refer to the
Network options section of the
XKM 2000 Installation Instruction
manual.
Press and hold the access button 
for 2 seconds to confirm the change.
To return to the main menu, tap the
button until a solid-appears in the
display.

Press the access button to
confirm.

Tap thebutton until aappears in
the display.

Touch the access button .
You have left the Custom settings
mode.
When you are in the Custom settings
mode the door alarm is turned off
automatically. Once the door is
closed it is reactivated.
RemoteVision (optional accessory)
82
 
						

							MasterCool control panel options for RemoteVision
Status indicators Description of function
Flashing~Module booting phase
Flashing‡Not connected to network
Flashing|Connection to network established, no IP address
assigned
Solid#Connected to network
FlashingIn Ad-Hoc Mode, not connected
FlashingIn Ad-Hoc Mode, connected
Selectable
optionsDescription of function
-Back
2Reboot the module
3Reset to factory settings
4Enter Ad-Hoc Mode
Note:If you cannot select any option (other than-Back, the module has not
been installed correctly.
RemoteVision (optional accessory)
83
 
						

							Alteration rights reserved / 4811
INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST
CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.M.-Nr. 09 169 250 / 01