Miele K 9557 Id Operating And Installation Instructions

For every type of food, there are ideal
storage conditions to ensure it stays
fresh as long as possible, retaining
both flavour and vitamins.
The important factors for this are the
storage temperature and the humidity.
The correct combination of temperature
and humidity is a unique feature of the
PerfectFresh zone. Food can be stored
for up to three times longer in the
PerfectFresh zone than in a standard
refrigerator.
Storage temperature
The optimum storage temperature for
fresh food which is not...

Always keep these foodscovered or
wrapped.
Exception: Meat.The surface of the
meat dries out slightly, helping to
prevent the growth of bacteria, which
results in the meat lasting longer. To
prevent the risk of bacterial
cross-contamination and meat
deteriorating, do not let one type of
meat come into direct contact with
another type.
Humidity-controlled compartment
The humidity-controlled compartment
has a regulator which is used to adjust
the relative humidity. Slide the regulator
to the relative...

Moving the shelves
The shelves can be adjusted according
to the height of the food.
^Raise the shelf, and pull it forwards
slightly until the notch at the side is in
line with the shelf support. It can then
be raised or lowered to the required
level.
The raised edge at the back must face
upwards to prevent food from touching
the back of the appliance and freezing
to it.
Stoppers prevent the shelves from
being dislodged by mistake.
Split shelf
In order to accommodate tall items in
the appliance, one of...

PerfectFresh zone
compartments
The compartments in the PerfectFresh
zone are on telescopic rails, and can
be removed for filling, emptying or
cleaning purposes.
^Pull out the compartment as far as it
will go, and then lift it up and out.
Push the runners back in again to
avoid injury or damage.
^Carefully pull out the lid between the
compartments slightly, and lift it
down and out.
^To replace it, insert the compartment
lid from beneath into the holders, and
push it back into place.
To replace the...

Universal container
(depending on model)
The universal container can be used
both to store and serve food.
It consists of a deep trayaand a
shallow trayb. Both trays fit the
stainless steel frame.
If you wish to use the universal
container to serve food,
^place the shallow traybin the
stainless steel frame, and use the
deep tray as a lida.
You can lift the universal container,
including contents, out of the frame and
take it to the table.
Moving the bottle divider
(depending on model)
The bottle divider...

Refrigerator section and
PerfectFresh zone
The refrigerator section and the
PerfectFresh zone defrost
automatically.
Condensate and frost can build up on
the back wall of the refrigerator section
and the PerfectFresh zone whilst in use.
You do not need to remove this, as it
will defrost and evaporate automatically
with the warmth generated by the
appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate...

Never use cleaning agents
containing abrasive substances
such as sand, soda, acids, chlorides
or chemical solvents. Non-abrasive
cleaning agents are also unsuitable
as they can cause matt areas to
appear.
To help prevent re-soiling, treat
stainless steel surfaces with a
proprietary conditioning agent for
stainless steel (available from the
Miele Spare Parts Department or via
the internet on www.miele.co.uk).
Do not let water get into the
electronic unit or the light.
Do not let water get into the...

^Clean stainless steel surfaces with a
suitable non-abrasive stainless steel
cleaning agent following the
manufacturer’s instructions on the
packaging.
^To help prevent re-soiling, a
conditioning agent for stainless steel
should always be used after
cleaning. Follow the manufacturer’s
instructions on the label.
Ventilation gaps
^The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner. A build-up
of dust will increase the energy
consumption of the appliance.
Door seal
Do...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied to
the appliance until after
maintenance or repair work has
been carried out.
What to do if...
. . . the appliance does not get cool.
^Check whether the appliance has...

. . . the interior light is not working.
Has the refrigerator door been left open
for too long? The lighting switches itself
off automatically after approx. 15
minutes.
If it also does not come on when the
door is opened briefly, but the
temperature display is working, then
the light is defective.
^Call the Service Department.
The LED lighting may only be repaired
or changed by a service technician.
Danger of injury and damage.
Should the cover be damaged or
need to be removed due to damage,
exercise...