Miele K 14827 Operating And Installation Instructions

Disposal of your old appliance
~Before disposing of an old
appliance, first make the door latch or
lock unusable.
This way you will prevent children from
accidentally locking themselves in and
endangering their lives.
~Be careful not to damage any part of
the pipework whilst awaiting disposal,
e.g. by
–puncturing the refrigerant channels
in the evaporator.
–bending any pipework.
– scratching the surface coating.
Splashes of refrigerant can damage the
eyes.
The manufacturer cannot be held
liable for...

Normal energy
consumptionIncreased energy
consumption
Installation siteIn a ventilated room. In an enclosed, unventilated room.
Protected from direct sunlight. In direct sunlight.
Not situated near to a heat source
(radiator, oven).Situated near a heat source
(radiator, oven).
Where the ideal ambient room
temperature is approx. 20°C.Where there is a high ambient
room temperature.
Temperature setting with
a thermostat which is
approximate
(set in stages).With a medium setting of 2 to 3. With a high...

Before using for the first time
The stainless steel external and internal
surfaces of the appliance have a layer
of protective foil to prevent scratching
during transportation.
^Do not remove this foil until the
appliance has been installed or built
in.
^After removing the protective foil,
treat stainless steel surfaces with a
suitable stainless steel conditioning
agent (available from
www.miele-shop.com) (depending on
country).
Important: A stainless steel
conditioner gives long lasting
protection, and...

Settings mode
Certain settings on the appliance can
only be selected in the settings mode.
How to select the settings mode and
how to change the settings is
described in the relevant section of
these instructions.
Overview of functions that can be
selected in the settings mode:
To enter or leave the settings
modec
To switch the sensor tones
on/off
(see Switching on and off)b
To confirm that the active
charcoal filters have been
changed (see Active charcoal
filters)^
To switch the safety lock on/off
(see...

Activating or de-activating the safety
lock
The safety lock can be activated to
prevent the appliance being switched
off inadvertently.
^Touch and leave your finger on the
sensor.
^At the same time, briefly touch the
On/Off sensor (without letting go of
thesensor).
^Leave your finger on thesensor for
another 5 seconds untilcappears in
the display.
^Touch thesensor repeatedly untilu
appears in the display.
^
Touch the On/Off sensor again.
^
By touching thesensor, you can
now select whether the safety...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– the more food that is stored in it,
– the warmer the food is which is being
put into it,...

–Leaving a finger on the sensor,
adjusts the temperature
continuously.
When the highest or lowest
temperature in the range is reached,
theorsensor disappears.
Approx. 5 seconds after taking your
finger off the sensor, theaverage,
currenttemperature inside the
appliance is automatically shown.
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very fullandfor
approx. 24 hours if the appliance is
fullbefore checking the temperature
display, as it will take this long...

§5is the default setting for the
PerfectFresh zone. If a setting of§1
to§4is selected, the temperature
can fall below 0°C. Food could
freeze!
Temperature display
During normal operation, the
temperature display on the control
panel shows the average temperature
in the refrigerator.
Thetemperature display will flashif
– the temperature is not within the
possible temperature range (0 °C to
19 °C),
– a different temperature is being set.
Changing the temperature display
brightness
The temperature display...

Your appliance has been fitted with an
alarm to avoid energy being wasted if
the door is left open and to prevent
stored food becoming too warm.
The alarm will sound if the door is left
open for more than approx. 2 minutes.
The Alarm off sensor will light up red
and the Cooling symbol will flash.
The alarm will stop and the indicators
will go out as soon as the door is
closed.To switch off the door alarm
whilst the door is still open
If you want to keep the door open
intentionally for more than approx.
2...

The SuperCool function
The SuperCool function can be used to
rapidly reduce the temperature in the
refrigerator to its lowest setting
(depending on the room temperature).
Switching on SuperCool
SuperCool is particularly recommended
for the faster chilling of large amounts
of fresh food or drink.
^Touch the SuperCool sensor. It will
light up yellow.
The appliance will then work at full
power to lower the temperature.
Switching off SuperCool
The SuperCool function will switch itself
off automatically after...