Miele K 14820 Operating And Installation Instructions

The following applies to stainless
steel appliances:
~Do not place sticky notes, adhesive
tape, masking tape or any other
adhesive agent on the treated surface
of the door.
The coating will become damaged and
lose its protective properties against
soiling.
~The high quality treated surface of
the door is susceptible to scratching.
Even fridge magnets can cause
scratching.
Disposal of your old appliance
~Before disposing of an old
appliance, first make the door latch or
lock unusable.
This way you will...

Normal energy consumption Increased energy consumption
InstallationIn a ventilated room. In an enclosed, unventilated room.
Protected from direct sunlight. In direct sunlight.
Not situated near a heat source
(radiator, oven).Situated near a heat source
(radiator, oven).
Where the ideal ambient room
temperature is approx. 20 °C.Where there is a high ambient room
temperature.
Do not cover the cross-section of
the air inlet and outlet and keep free
of dust.
Temperature setting
with a thermostat which
is...

Before using for the first time
To ensure the correct functioning of
the appliance, let it stand for between
½ and 1 hour after transporting it to its
final location before connecting it to
the mains.
Protective foil
The stainless steel strips and frames
have a layer of protective foil to prevent
scratching during transportation.
The external surfaces of stainless steel
appliances are also covered with a
protective foil.
^Remove the protective foil only after the
appliance has been installed in its...

Switching off
^Touch the On/Off sensor until all of
the indicators go out.
The interior light will not come on when
you open the door and the cooling
process will be switched off. (If this
does not happen, the safety lock is still
activated).
Settings mode
Certain settings on the appliance can
only be selected in the settings mode.
How to select the settings mode and
how to change the settings is
described in the relevant section of
these instructions.
Overview of functions that can be
selected in the...

Switching the sensor tones on/off
The sensor tone which sounds each
time a sensor is touched can be
deactivated.
^Touch and leave your finger on the
sensor.
^At the same time, briefly touch the
On/Off sensor (without letting go of
thesensor).
^Leave your finger on thesensor for
another 5 seconds untilcappears in
the display.
^Touch thesensor repeatedly untilb
appears in the display.
^Touch the On/Off sensor.
^
By touching thesensor, you can
now select whether the sensor tones
are switched on or...

You have now left the settings mode.
The safety lock indicator
Xwill light up
in the temperature display when the
safety lock has been activated.
Switching off for longer
periods of time
If the appliance is not going to be used
for a longer period of time, e.g. whilst
on holiday:
^switch the appliance off,
^switch off at the wall and withdraw
the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable,
^clean the appliance out and
^leave the...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– the more food that is stored in it,
– the warmer the food is which is being
put into it,...

If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very fullandfor
approx. 24 hours if the appliance is
fullbefore checking the temperature
display, as it will take this long for the
display to give an accurate reading. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature range
The temperature can be adjusted from
2°Cto9°C.
The ambient temperature in the room
and the installation location can affect
the time...

Your appliance has been fitted with an
alarm to avoid energy being wasted if
the door is left open and to prevent
stored food becoming too warm.
The alarm will sound if the door is left
open for more than approx. 2 minutes.
The Alarm off sensor will light up red
and the Cooling symbol will flash.
The alarm will stop and the indicators
will go out as soon as the door is
closed.To switch off the door alarm
whilst the door is still open
If you want to keep the door open
intentionally for more than approx.
2...

SuperCool
The SuperCool function can be used to
rapidly reduce the temperature in the
refrigerator to its lowest setting
(depending on the room temperature).
Switching on SuperCool
SuperCool is particularly recommended
for the faster chilling of large amounts
of fresh food or drink.
^Touch the SuperCool sensor. It will
light up yellow.
The appliance will then work at full
power to lower the temperature.
Switching off SuperCool
The SuperCool function will switch itself
off automatically after approx. 6...