Miele K 12820 Sd Manual

Remove cap	from the bearing
bush in the door and refit on the
opposite side.

Using a screwdriver, remove spring
clamp
from underneath the door
and fit it on the opposite side.Pull hinge pintogether with disc
and adjustable footupwards and
off.
Remove cover cap.
Undo screwsand take hinge plate
off.
Undo the screw of hinge part	on
hinge plateslightly. Fit it into the
hole opposite in hinge plateand
tighten up the screw.
Refit cover capin the other hole.

Remove coverand fit it into the...

Screw hinge plateinto position on
the opposite side using the twoouter
long slots only. To make it possible to
align the door later, do not replace
thecentrescrew at this stage.
Important. Screw the adjustable foot
into hinge pinas far as it will go.
Refit hinge pintogether with disc
and adjustable foot. Important.
The notch at the bottom of the hinge
pin should face towards the back.
Place the door onto hinge pin.

Close the appliance door.Fit hinge plateonto the opposite
side and secure...

Refitting the handle
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
Loosely attach the handle to the
opposite side of the door with the two
front screws.
Mounting platemust be positioned
on the side of the door so that when the
door isclosedit is flush with the side of
the appliance.
If this is not the case,

tighten both grub screwswith a
suitable allen key until mounting plate
lines up...

The appliance door can be aligned to
the housing using the outer long slots in
the lower hinge plate.
In the following illustration the door
is not shown in the closed position to
make it easier to see what you have
to do.
Remove centre screwfrom the
hinge plate.
Slightly loosen both outer screws.
Align the door by sliding the hinge
plate to the left or right.

Then tighten screwsagain. Screw
does not need to be used again.
Aligning the appliance door
44 

Top box
Appliance
Housing unit
Wall
The appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top box.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance across the entire width of the
top box for air to circulate.
The cross section of the air outlet under
the room ceiling must be at least
300 cm
2to ensure that air can circulate
without hindrance. Otherwise the
appliance has to work...

46 

47 

Alteration rights reserved / 4912
K 11820 SD, K 12820 SD, K 12820 SD edt/csM.-Nr. 09 434 270 / 00