Miele K 121 Ui Operating And Installation Instructions

Before using for the first time
Remove the transit fitting from the
appliance, and dispose of it.
Place the stopper supplied in the
empty hole.
Clean the inside of the appliance and
the accessories with luke warm water
and a little washing-up liquid, and
then dry with a soft cloth.
Important:
To ensure the correct functioning of
the appliance, let it stand for
between ½ and 1 hour after
transporting it to its final location
before connecting it to the mains.
Switching on

Turn the temperature...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– if too much food is stored in it at
once,
– the warmer the food is which is being
put...

Different storage zones
Due to the natural circulation of the air
in the appliance, there are different
temperature zones in the refrigerator.
Cold, heavy air sinks to the lowest
section of the appliance. Make use of
the different zones when placing food
in the appliance.
Warmest area
The warmest area is in the top section
of the door. Use this for storing butter
and cheese.
Coldest area
The coldest area in a refrigerator is
directly above the vegetable
containers.
Use this for all delicate and highly...

Storing food correctly
Store food covered or packaged. This
will prevent food smells or tastes from
affecting other foods, and prevent food
from drying out and also any
cross-contamination of bacteria. The
growth of bacteria, such as salmonella,
can be avoided by setting the correct
temperature and maintaining good
standards of hygiene.
Fruit and vegetables
Fruit and vegetables can be stored
loose in the vegetable containers.
However, you should bear in mind that
some types of vegetables give off a...

Moving the shelves
The shelves can be adjusted according
to the height of the food.
Pull the shelf forwards and then tilt it
downwards to remove it.
With the rear barrier facing upwards,
place the shelf at the required
position.
The rear barrier must face upwards
to prevent food from touching the
back of the appliance and freezing to
it.
Split shelf
In order to accommodate tall items in
the appliance, one of the shelves is
divided. The front section of the shelf
can be pushed under the rear section....

The refrigerator defrosts automatically.
Condensate and frost can build up on
the back wall of the refrigerator whilst it
is in use. You do not need to remove
this, as it will defrost and evaporate
automatically with the warmth
generated by the appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate can flow away without...

Never use cleaning agents
containing abrasive substances
such as sand, soda, acids or
chemical solvents.
Non-abrasive cleaning agents are
also unsuitable as they can cause
matt areas to appear.
Make sure that water cannot get into
the light.
Do not let water get into the
drainage channel and drain hole
when cleaning.
Do not use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be...

After cleaning
Replace all shelves and accessories
in the appliance.
Insert the plug in the socket and
switch the appliance back on using
the temperature selector.
Place food back in the appliance and
close the door.
Cleaning and care
18
 

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if...
. . . the appliance does not get cool.
Make sure that the temperature
selector is not set at 0.
Check that the plug is correctly
inserted in the socket and switched
on.
Check that the...

Replace the cover.
. . . the floor is wet.
The drain hole is blocked.
Clean the condensate channel and
drain hole.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature it is advisable not to
open the door while waiting for the
appliance to be serviced.
Problem solving guide
20