Miele K 12012 S Operating And Installation Instructions

							The appliance is supplied right hand
hinged. If left hand door hinging is
required, follow the instructions below.
^Close the door.
^
Unscrew lower hinge bracketa, and
remove.
^
Then lift the door down and off.
^
Take hinge pinbout of hinge
bracketa, then refit in the other hole
of the hinge bracket.
^
Remove covercand use it to cover
the now empty holes on the opposite
side.
^
Unscrew upper hinge pindand refit
it on the other side.
^
Take care not to lose the washer.^Remove the cover at the top left of
the door and refit it on the opposite
side.
^Fit the appliance door from below
onto upper hinge pindand then
close the appliance door.
^
Screw hinge bracketainto the lower
door bearing.
^
Use the long slots in the hinge
bracket to align the door. Make sure
you have tightened all screws
properly.
Changing the door hinging
41
 
						

							Changing the freezer
compartment door
^Lower the cover on hinge platea.
^Unscrew hinge plateb, and remove
freezer compartment doorc
together with the hinge plate.
^Unscrew door catchd.
^
Turn door catchdby 180°, and
screw into place on the opposite
side.
^
Fit freezer compartment doorcin
position at the tope, then tighten
hinge platebsecurely.
^
Close the cover on hinge platea.
Plug the holes with stoppersf
supplied.
Changing over the door handle
^Carefully remove coveraand
stoppersbfrom the sides using a
flatheaded screwdriver.
^Slide covercover to the left and
then insert a suitable plastic or
wooden tooldinto the gap on the
right hand side.
^Carefully lever covercout.
Be careful not to let the  tool slip,
causing damage to the appliance.
^
Loosen screwseon the handle side
and in the middle, and remove
handlef.
Changing the door hinging
42
 
						

							^Turn the handle 180° and fit to the
opposite side.
^First screw it at the side and then in
the middleg.
^In the same way, replace covera
and stoppersbon the opposite
side.
^Refit middle covercby pushing it in,
first on the left hand side, and then
on the right.
Changing the door hinging
43
 
						

							The appliance can be pushed
underneath a worktop run. If this is
done, then the top lid to the appliance
may need to be removed.
When placed under a worktop run it
is essential that adequate ventilation
is provided at the rear of the
appliance. A ventilation gap of at
least 140 cm
2must be made in the
worktop.
With a building under depth of
600 mm, any backmould must not
exceed 10 mm in depth.
Make sure that the socket and on-off
switch are easily accessible after the
appliance has been pushed
underneath the worktop.
^
Remove screwsafrom the rear of
the appliance.
^
Lift the appliance lid up at the rear
and then pull it towards the front of
the appliance to remove it.
Building under
44
 
						

							45
 
						

							46
 
						

							47
 
						

							Alteration rights reserved / 0812
K 12010 S-2, K 12012 S-2, K 12020 S-1, K 12022 S-1, K 12023 S-2, K 12024 S-2M.-Nr. 09 290 810 / 00