Miele G 2830 Sci Operating Instructions

							Adding detergent
^To open, press the latch on the
detergent dispenser. The flap will
spring open.
The flap is always open at the end of a
program.^Add detergent to compartment II and
close the flap.
^If a Pre-rinse is desired, and available
for your chosen program, add
1 teaspoon (5 ml) of detergent to
compartment I.
The horizontal marks in compartment II
indicate the levels of approximately 1 ¼
and 2 tablespoons (20 and 30 ml)
respectively. Compartment I holds a
maximum of 2 teaspoons (10 ml).
Use
31
 
						

							Turning on
^Make sure the spray arms can rotate freely.
^Close the door.
^Open the water supply, if closed.
^Turn the dishwasher on by touching thescontrol.
The main menu shows in the display.
If the memory function is selected, the last selected program
is displayed. See SettingsJ- Memory.
Main menu12:00
°Normal
m
°Pots + Pans
°China + Crystal:
Selecting a program
Choose your program according to the type of load and
soiling.
See the Program guide for a description of the programs
and uses.
Information about the selected program can be displayed
by touching theKcontrol.
^
Select the desired program.
The display changes to the program menu.
Sensor Wash1:32 h12:00
°Options
°Start time
End at 3:32Start°
Use
32
 
						

							Program When to use Program sequence
Pre-
rinse
12Main
washInterim
rinse
12Final
rinseDrying
Normal Fornormally soileddishware withdried onfood
Run-time131 minXX X X X X
Pots +
PansFornormally soiled pots and panswithdried
on food, and heavily soiled dishware,
120% detergent recommended
Run-time129 minXX X XX
China +
CrystalFor temperature sensitive glassware and lightly
soiled dishware, 50% detergent recommended;
sensor controlled GlassCare program
Run-time100 minas re-
quiredXXas
requiredXX
Short Quick program forlightly soileddishware, e.g.
party dishware or to remove salt traces from the
wash cabinet after refilling salt, includes sensor
controlled GlassCare; not suitable for detergent
tabs
Run-time30 minXXX
Sensor
WashSensor controlled program
fornormally soileddishware
Run-time123 minas re-
quiredXXas
requiredXX
Economy Fornormally soileddishware, energy saving
program with a long soaking time and a low
temperature; includes sensor controlled
GlassCare
Run-time95 minXXXX
Heavy Soil Forheavily soileddishware with dried starchy
food
Run-time120 minXX X XX
Energy
SaverThe water intake temperature must be a minimum
of 115°F (45°C);
forlight to normally soileddishware
Run-time74 minXX X X X X
Rinse +
HoldTo rinse dishes when a complete program is not
needed.
Run-time13 minX
Water
SaverForlight to normally soileddishware without
dried food; water saving program
Run-time87 minXXXX
Program guide
33
 
						

							Program When to use Program sequence
Pre-
rinseMain
washInterim
rinse
12Final
rinseDrying
Starch For dishware withdried on starchy food;
120% detergent recommended
Run-time148 minXXX XX
Cheese For dishware withdried on cheese;
120% detergent recommended
Run-time150 minXXX XX
Sani Wash Tosanitize dishware, e.g. baby bottles,
cutting boards and preparation dishware
Run-time122 minXX XX X
Plastics To gently clean dishwasher safe plastics
and plastic toys
Run-time115 minXXX XX
Large items
soiledFor extra large,heat-resistant items
e.g. large vases
Run-time103 minXXX XX
Large items
normalFor extra large itemssensitive to high
temperaturese.g. large plastics
Run-time98 minXXX XX
Glassware no
rinse aidTo wash glassware without detergent
and rinse aid; rinse cycle with warm water
Run-time50 minXX X
Glassware
coldFor a quick cleaning of glassware for
direct reuse; use without detergent and
rinse aid
Run-time17 minXX X
Plate Warming For plate warming; use without detergent
and rinse aid
Run-time12 minX
Usage:
Electric: 0.01 - 1.3 kWh
Water: 1.06 - 6.6 gal (4 - 25 l)
Program guide
34
 
						

							Selecting Options
Options can be added to the selected program.
^Select
Options.
The display shows the available options for the selected
program.
Available options:
Pre-rinse:
–For easily removable soiling
Soak:
–To soak stubborn soiling.
When using powder detergent, fill approx. 1 teaspoon (5 g)
of detergent in the detergent compartment I.
Extended drying:
– To enhance drying of odd shaped dishware and plastic
items.
Options12:00
°§Extend drying
OK°
^
Select the desired options.
The selected options are marked by aLcheck.
^
To deselect the selected options, touch the respective
control again.
^
When finished customizing the program, confirm with
OK.
The display changes back to the program menu.
The program menu shows
Options selected.
Use
35
 
						

							You can now select the detergent
used. Availabe selections are:
Powder, Gel, 2 in 1 and 3 in 1
tabs.
See SettingsJ, Detergent.
Starting a program
^SelectStart.
The program begins.
Cancel a program only in the first
5 minutes. Otherwise important
program steps (e.g. the water
softening) could be interrupted.
The program can be locked. To use this
function, see SettingsJ- Program
lock.
Time display
Before the program starts, the time
display shows the running time of the
selected program in hours and minutes.
During the running program the
remaining time shows in the time
display.
The running time for the same program
may vary depending on the intake
water temperature, the load size and
soiling.
When a program is selected for the first
time, a time is shown which equals an
average program running time with
cold water.
The time values in the program guide
correspond to the program running
times with standard loads and standard
temperatures.
Each time a program is run, the
electronic adjusts the program running
time according to the water intake
temperature and the load size.
Use
36
 
						

							At the end of a program
At the end of a program the display
shows
Program finished.
Dishes tends to chip if removed still hot
from the dishwasher.
Let the dishware cool.
After turning off the dishwasher open
the door slightly. The dishes will cool
much faster.
^Open the dishwasher and unload the
dishes.
^Turn the dishwasher off by touching
thescontrol.
The dishwasher continues to use
electricity until turned off with the
scontrol.
^If the dishwasher is not used for a
longer period of time, e.g.
vacationing, turn off the water supply.
Interrupting a program
A program is interrupted as soon as the
door is opened. If the door is closed,
the program will continue from where it
was interrupted.
,Open the door with care. The
water in the dishwasher is hot.
Danger of scalding. Before closing
the door again, leave it ajar for
approx. 20 secs. This will enable the
temperature in the wash cabinet to
settle. Close the door firmly until it
clicks into place.
Use
37
 
						

							Changing a program
If the detergent flap is already open, do not change the
program.
If a program has already started and you wish to change it:
Sensor Wash12:00
Pre-rinse
Time left 1:30 h
Cancel°
^SelectCancel.
^Confirm the message
Cancel program?withOK.
The program is canceled.
Sensor Wash12:00
Program finished
Main menu°
^
SelectMain menu.
The display changes to the main menu.
^
Select and start the desired program.
Use
38
 
						

							Delay start
The start time of a program can be delayed from 15 minutes
to 24 hours in 15-minute-increments.
When using the Delay Start function, make sure that the
detergent compartment is dry before adding detergent.
Wipe dry with a cloth if necessary. Otherwise the
detergent could stick together and not completely rinse
out.
Liquid detergent should not be used when selecting
Delay Start, the detergent could leak.
,It is recommended to add the detergent and lock the
dishwasher door to prevent children from coming in
contact with the detergent.
^Turn the dishwasher on by touching thescontrol.
^Select the desired program.
^Select
Start time.
The most recent saved start time will be displayed.
Sensor Wash1:32 h12:00
°Options+°
°Start time12:00-°
End at 1:32OK°
^
Select the desired start time with the+/-sensors.
Holding the touch control automatically increases or
decreases the time.
The end time is automatically adjusted.
^
Confirm with
OK.
^
Select
Start.
Additional options
39
 
						

							Sensor Wash12:00
Start at 12:00
Cancel°
The program name and the start time are displayed.
The program starts automatically at the selected time.
Starting a program before the delay start has elapsed:
A program can be started before the delay start time has
elapsed. Proceed as follows:
^Select
Canceland confirm withOK.
^Select
Main menu.
The display changes to the main menu.
^A program can now be selected and started.
Additional options
40