Miele G 2732 Operating Instructions

							Issue Possible fault Solution
Detergent is left in the
dispenser at the end of a
program.The dispenser was
damp when
detergent was
added.Dry the dispenser before
adding detergent.
The detergent lid cannot
be closed properly.Detergent residue is
blocking the catch.Remove the residue.
The door and the interior
walls are still wet after a
program has finished.This is not a fault. It is
the normal operating
mode of the drying
system.The moisture will evaporate
after a short time.
Water remains in the
wash cabinet at the end
of a program.Before fixing the fault:
–Turn the dishwasher off	.
The triple filter in the
wash cabinet is
clogged.Clean the triple filter. See
User Maintenance
Instructions.
The drain pump or
the non-return valve
may be blocked.Clean the drain pump and
non-return valve, see User
Maintenance Instructions.
The drain hose is
kinked.Remove any kinks from the
drain hose.
Frequently asked questions
51
 
						

							Sounds
Issue Possible fault Solution
There is a knocking
noise in the wash
cabinet.The spray arm is hitting an
item in the basket.Interrupt the program,
rearrange items blocking
the spray arms.
There is a rattling
noise in the wash
cabinet.Items are not secure in the
wash cabinet.Interrupt the program and
rearrange loose pieces.
There is a knocking
noise in the water
pipes.This may be caused by
the installation or the
diameter of the pipe.This has no effect on the
dishwasher. If in doubt
contact a plumber.
Frequently asked questions
52
 
						

							Poor cleaning results
Issue Possible fault Solution
The dishes are not
clean.The dishes were not loaded
correctly.See Loading the
dishwasher.
The program was not
powerful enough.Select a more intensive
program, see Program
Guide.
Stubborn but normal soiling
(e.g. coffee, tea).Use the function Adjust
Sensor Wash. See
Settings- Adjust Sensor
Wash.
Not enough detergent was
dispensed.Use more detergent, see
Adding detergent.
The spray arms are blocked. Turn the spray arm and
rearrange the dishes if
necessary.
The triple filter is clogged or
not correctly inserted. The
spray arm jets might be
clogged.Clean the filter and insert it
correctly, see User
Maintenance Instructions.
The drain pump or the
non-return valve is blocked.
Wash water will run back
into the wash cabinet.Clean the drain pump and
the non-return valve, see
maintenance instructions.
Glasses and
cutlery show
streaks. There is a
bluish sheen on the
surface of glasses
and a film which
can be wiped off.The rinse aid dosage is set
too high.Reduce the dosage, see
Before using for the first
time.
Frequently asked questions
53
 
						

							Issue Possible fault Solution
Dishes are not dry,
glasses and cutlery
are spotted.The rinse aid setting may be
too low, or the rinse aid
reservoir is empty.Increase the dosage, refill
the reservoir or switch the
rinse aid product when
refilling, see Before using
for the first time.
Dishes were taken out too
soon.Leave dishes in longer, see
Use.
A Tab product was used.
These products have a low
drying effect.Set the Detergent setting for
a normal (powder or gel)
detergent and add rinse aid.
The Tab setting is turned
on, but a normal (powder or
gel) product was used.Set the Detergent setting to
the detergent used, see
Additional options - Tab.
White residue is
visible on cutlery
and dishes.
Clouding occurs on
glassware and film
can be wiped off.Not enough rinse aid was
used.Increase the dosage, see
Before using for the first
time.
The salt container is empty. Refill the salt container, see
Before using for the first
time.
The salt container lid was
not correctly screwed on.Reseat it making sure it
screws back on correctly.
Unsuitable Tab products
were used.Change detergent, use
normal (powder or gel)
detergent.
The water softener is
programmed on too low a
setting.See Before using for the
first time.
Frequently asked questions
54
 
						

							Issue Possible fault Solution
Glasses are
discolored and the
film cannot be wiped
off.Detergent deposits. Use a different detergent.
Glasses are dull and
discolored, film
cannot be wiped off.Glasses are not dishwasher
safe.There is no remedy. Only
wash dishwasher safe
glasses in the dishwasher.
Tea or lipstick stains
have not been
completely removed.The wash temperature of
the selected program was
too low.Select a program with a
higher temperature.
The detergent has a low
bleaching effect.Use a different detergent.
Plastics are
discolored.Natural dyes e.g. from
vegetables may be the
cause. Not enough
detergent was used to
break down natural dyes.Use more detergent, see
Adding detergent.
Discoloration is permanent.
There are rust stains
on cutlery.The affected items are not
corrosion resistant.There is no remedy. Only
wash dishwasher safe
cutlery in the dishwasher.
No program was run after
refilling salt. Salt residuals
got in the wash cycle.Start the Express program
(with the Turbo option)
without a load after refilling
salt.
The salt container lid was
not screwed on properly.Reseat and screw the lid on
firmly.
Frequently asked questions
55
 
						

							10 place settings, Standard program:Normal
Upper basket Lower basket
Cutlery tray
Comparison Tests
56
 
						

							12 place settings, Standard program:Normal
Upper basket Lower basket
Cutlery tray
Comparison Tests
57
 
						

							14 place settings, Standard program:Normal
Upper basket Lower basket
Cutlery tray
Comparison Tests
58
 
						

							Repairs
In the event of a fault which you cannot
correct yourself please contact the
Miele Service Department at the phone
number on the back of this booklet.
Please quote the model type and
number of your appliance.
These can be found on the data plate
along the right edge of the door.
PC Update
The Program Correction (PC) allows a
technician to update the dishwasher to
make use of new technology.
When, for example, technological
developments offer advanced
modifications to your existing program
cycles a service technician will be able
to input these into your machine
controls via the indicator light marked
PC. Miele will provide information when
such possibilities become available.
MieleCare
(USA only)
MieleCare, our Extended Service
Contract program, gives you the
assurance of knowing that your
appliance investment is covered by
5 years of worry free ownership.
MieleCareis the only Extended Service
Contract in the industry that guarantees
repairs by a Miele Authorized Service
Provider using genuine Miele parts.
Only genuine Miele parts installed by
factory trained professionals can
guarantee the safety, reliability, and
longevity of your Miele appliance.
Please note that unless expressly
approved in writing by Miele’s Service
department, Extended Service
Contracts offered by other providers for
Miele products will not be recognized
by Miele. Our goal is to prevent
unauthorized (and untrained) service
personnel from working on your Miele
products, possibly doing further
damage to them, you and/or your
home.
To learn more aboutMieleCare
Extended Service Contracts, please
contact your appliance dealer or visit
us online at:
http://miele.com/mielecare
After sales service
59
 
						

							To transport the dishwasher, e.g. when
moving to a new home, note the
following:
–Empty the dishwasher.
–Secure any loose parts, e.g. hoses,
cables, cutlery baskets.
–Transport the dishwasher in the
upright position. If unavoidable it
may be transported on its back. Do
not transport it on its side or on the
door. Residual water in the machine
could leak and cause electrical
damage.
Transport
60