Miele G 1272 Scvi Operating Instructions
Here you can view all the pages of manual Miele G 1272 Scvi Operating Instructions. The Miele manuals for Dishwasher are available online for free. You can easily download all the documents as PDF.
Page 41
Buzzer An audible tone sounds at the end of the programme or if there is a fault. You will hear the buzzer at the end of a programme in bursts of five with a short pause in between. The buzzer will continue to sound for up to an hour if you do not switch the dishwasher off. In the event of a fault, the buzzer will sound continuously for up to two minutes if you do not switch the dishwasher off or correct the fault. The buzzer is activated as standard at the factory. You can deactivate the buzzer at the...
Page 42
Factory default setting If you have altered any settings from the factory default, you can re-set them back to the factory default settings as follows: ^Open the door. ^Switch the dishwasher off with the Off button. ^Press the programme selector button in, andwhilst holding it inswitch the dishwasher on using the On button. Keep the programme selector button pressed in until the lower right hand programme indicator comes on. If this does not happen, start the procedure from the beginning again. ^Press...
Page 43
Adjust Sensor wash You can adjust the Sensor wash programme so that it will remove stubborn soiling in a lightly soiled load. ^Open the door. ^Switch the dishwasher off with the Off button. ^Press the programme selector button in, andwhilst holding it inswitch the dishwasher on using the On button. Keep the programme selector button pressed in until the lower right hand programme indicator comes on. If this does not happen, start the procedure from the beginning again. ^Press the Turbo/Combi tabs...
Page 44
Check your dishwasher regularly (approx. every4-6months). This way faults and problems can be avoided. Miele branded cleaning and conditioning products are available from the Miele Spare Parts Department or via the internet at www.miele-shop.com. ,External surfaces of the dishwasher are susceptible to scratching. Contact with unsuitable cleaning agents can alter or discolour the outer surfaces. Cleaning the wash cabinet The wash cabinet is largely self-cleaning, provided that the correct amount of...
Page 45
Cleaning the control panel and door front ,Remove any soiling immediately. If not, it might become impossible to remove and could cause the outer surface to alter or discolour. ^The control panel shouldonlybe wiped with a damp cloth. ^Clean the front using a damp Miele microfibre E-cloth or with a sponge and a solution of hot water and washing-up liquid. Then dry with a soft cloth.To avoid damaging external surfaces, do not use: –cleaning agents containing soda, ammonia, acids or chlorides, –cleaning...
Page 46
Cleaning the filters in the wash cabinet The filter combination in the base of the wash cabinet retains coarse soil from the suds solution, preventing it accessing the circulation system and re-entering the cabinet through the spray arms. ,The dishwasher must not be used without all the filters in place. Collection of coarse soil may cause the filters to clog. The level of soiling and time it takes before the filters need cleaning will vary depending on use. Check the condition of the filters regularly...
Page 47
To clean the inside of the filter, the flap must be opened: ^Press catchesatogether in the direction of the arrows as shown, and open the filterb. ^Rinse all the filters under running water. ^Then close the flap so that the catch engages.^Replace the filter combination so that it lies flat in the base of the wash cabinet. ^Then turn the handle clockwise, until the arrows line up, to lock the filter combination in place. ,Take care when you are fitting the filter combination that it is secured in position...
Page 48
Cleaning the spray arms Particles of food can get stuck in the spray arm jets and bearings. The spray arms should therefore be inspected and cleaned regularly (approx. every 4 - 6 months). ^Switch the dishwasher off. Remove the spray arms as follows: ^Take out the cutlery tray (if your dishwasher is fitted with one). ^Push thetopspray arm upwards to engage the inner ratchet. Then unscrew the spray arm. ^ Push themiddlespray arms upwards ato engage the ratchet. Then unscrew the spray armb.^Remove the...
Page 49
With the aid of the following guide,faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Miele Service Department. ,Repairs should only be carried out by a suitably qualified and trained person in strict accordance with current local and national safety regulations. Unauthorised or incorrect repairs could cause personal injury or damage to the appliance. Technical problems Problem Possible cause Remedy The dishwasher does...
Page 50
Problem Possible cause Remedy The In-operation indicator is flashing quickly. The buzzer is sounding. All the programme indicators flash when the door is open. Fault code FXX shows in the display.There may be a technical fault.–Clean the water filter and clean the drain pump and non-return valve as described in Maintenance. If this does not resolve the problem: –switch the dishwasher off with the Off button. After a few seconds: –Switch the dishwasher back on. –Select the programme required with the...