Miele Da2894 Manual

Installation Instructions 

22 

Disposal of packing material
The cardboard box and packing
materials protect the appliance during
shipping. They have been designed to
be biodegradable and recyclable.
Please recycle.
To prevent suffocation of children,
ensure that any plastic wrappings,
bags, etc. are disposed of safely
and kept out of their reach.
Disposal of an old appliance
Old appliances may contain materials
that can be recycled. Please contact
your local recycling center about the
possibility of recycling these materials.
Before...

Installation accessories
24 

a3 protective shields
prevent scratches to the chimney
during installation.
bUpper retaining platesecures the
chimney extension.
cMiddle retaining platefor
additional stability of the chimney.
d2 hose clipsfor securing the
ducting.
e1 reducing collar
for use with 5 (125 mm) exhaust
ducting.
Caution: During the installation
process, please be careful of sharp
edges that can cause harm.5 large headed screws 5 x 40 mm
for securing the retaining plates and the
canopy.
(S8 wall anchors included in the...

The majority of the weight of the
installed ventilation system will be
supported by the lower retaining
plate. It must be firmly attached to
the stud framingbehindthe drywall.
If studs are not available in the
required locations, a plywood
backing (min.
½ (13 mm) thick)
spanning at least two studs mustbe
installed. Failure to adequately
support the weight as stated may
result in the ventilation system falling
off the wall, causing personal injury
and property damage.
(If plywood backing is not needed,...

All electrical work should be
performed by a qualified electrician
in strict accordance with national
and local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held responsible for
unauthorized work.
Ensure that power to the appliance
is OFF while installation or repair
work is performed.
^Verify that the voltage, load and
circuit rating information found on the
data plate (located behind the
grease filters), match the...

Appliance dimensions
28 

1) and 2)
Cut out area in wall or ceiling for
entrance of 6 (150 mm)
ductwork or 5 (125 mm) ductwork with
a reducing collar.
Do not install this exhaust hood over
cooktops burning solid fuel.
Provided a larger distance is not
given by the manufacturer of the
cooktop, follow the recommended
minimum safety distances between
a cooktop and the bottom of the
grease filter of 30 (762 mm).
If local building codes require a
greater safety distance, follow their
requirement.
Follow the safety distances...

Installation instructions
^See the enclosed installation
instruction sheet.
^Please read the Important Safety
Instructions and Installation
instructions before installing this
hood.
Protective film
The casing is covered with a protective
film to prevent scratching during
transport.
^Peel off the film before installing the
casing parts.
Dismantling
If the hood needs to be disassembled,
follow the instructions on the installation
sheet in the reverse order.
A lever is enclosed for easier removal
of the...