Miele Cs12121 Manual

							Installation51Installation with a downdraftextractorPlease refer to the separate "Downdraftextractor with CombiSet" instructionmanual for details about installing adowndraft extractor with a CombiSetappliance.Installing the CombiSet
000EFeed the mains connection cabledown through the cut-out.000EStarting at the front, position theCombiSet in the worktop cut-out.000EUsing both hands, press down evenlyon the edges of the CombiSet until itclicks into position. When doing thismake sure that the seal underneaththe appliance sits flush with the work-top. This is important to ensure an ef-fective seal with the worktop.
Do not use sealant (e.g. silicone).If the seal does not meet the worktopcorrectly on the corners, the corner ra-dius (≤ R4) can be carefully scribed tosuit.
Building in several CombiSets000EPush the built-in CombiSet to theside until the holes in the spacer barcan be seen.000EFit cover strip 0015 into the holes inspacer bar 0012.000EStarting at the front, position the nextCombiSet in the worktop cut-out.000EProceed as described previously.  
						

							Installation52Connecting the CombiSet000EConnect the CombiSet(s) to themains.000ECheck that each CombiSet works.
Removing the CombiSet
If the CombiSet cannot be accessedfrom below, you will need a specialtool to remove it.000EIf the CombiSet can be accessedfrom below, push it out from below.Push the rear side out first. 
						

							Electrical connection53All electrical work should be carried outby a suitably qualified and competentperson in strict accordance with currentlocal and national safety regulations(e.g. BS 7671 in the UK). Connectionshould be made via a switched socket.This will make it easier for service tech-nicians should the appliance need to berepaired. The electrical socket must beeasily accessible after installation.
Danger of injury.Miele cannot be held liable for unau-thorised installation, maintenanceand repair work as this can be dan-gerous to users. Miele cannot be held liable for dam-age or injury caused by incorrect in-stallation, maintenance or repairwork, or by an inadequate or faultyearthing system (e.g. electric shock).If the plug is removed from the con-nection cable or if the cable is sup-plied without a plug, the appliancemust be connected to the electricalsupply by a suitably qualified electri-cian.If the switched socket is not access-ible after installation, or if the appli-ance is to be hard-wired, an addi-tional means of disconnection mustbe provided for all poles. Whenswitched off, there must be an all-pole contact gap of at least 3 mm inthe switch (including switch, fusesand relays). Connection data isshown on the data plate. It mustmatch the mains electrical supply.After installation ensure that all elec-trical components are shielded andcannot be accessed by users.
Total power ratingSee data plateConnectionAC 230 V, 50 HzThe connection data is quoted on thedataplate. It must match the householdsupply.Residual current deviceFor extra safety, it is advisable to pro-tect the CombiSet with a suitable resid-ual current device (RCD) with a triprange of 30 mA. 
						

							Electrical connection54Disconnecting from the mainsDanger of electric shock.After disconnection, ensure the ap-pliance cannot be switched back onby mistake.
To disconnect the appliance from themains power supply, do one of the fol-lowing depending on installation:Safety fuses
000ECompletely remove fuses
Automatic circuit breakers
000EPress the (red) button until the middle(black) button springs out.
Built-in circuit breakers
000ECircuit breakers, type B or C: switchthe on-off switch from 1 (on) to 0 (off).
Residual current device (RCD)
000ESwitch the main switch from 1 (on) to0 (off) or press the test button.Replacing the mains cableDanger of electric shock.The mains connection cable must bereplaced by a suitably qualified andcompetent person in accordancewith current local and national safetyregulations. (e.g. BS 7671 in the UK).
If the mains cable needs to be replacedit must be replaced with a special con-nection cable, type H 05 VV-F (PVC-in-sulated), available from Miele.The connection data is quoted on thedata plate. 
						

							After sales service, data plate, guarantee55After sales serviceIn the event of any faults which you cannot easily remedy, please contact–your Miele Dealer, or–Miele Service.See end of this booklet for contact details.Please note that telephone calls may be monitored and recorded for training pur-poses.
N.B. A call-out charge will be applied to service visits where the problem couldhave been resolved as described in these instructions.When contacting your Dealer or Miele, please quote the model and serial numberof your appliance.Data plateSpace in which to stick the extra data plate supplied with the appliance. Ensurethat the model number is the same as the one on the back page of these instruc-tions.
Guarantee: UKThe appliance is guaranteed for 2 years from the date of purchase.In the UK, you must activate your cover by calling 0330 160 6640 or registeringonline at www.miele.co.uk.Guarantee: Other countriesFor information on the appliance guarantee specific to your country please contactMiele. See end of this booklet for contact details. 
						

							Product data sheets56The following data sheets apply to the models described in this operating instruc-tion manual.Information for domestic electric hobsIn acc. with regulation (EU) No. 66/2014
MIELEModel name / identifierCS 1212-1Number of cooking zones and/or areas2For circular cooking zones: diameter of useful sur-face area/cooking zoneFor non-circular cooking zones or areas: lengthand width of useful surface area per electric cook-ing zone or area
1. = Ø 100-160 mm2. = Ø 160-230 mm3. = 4. = 5. = 6. =
Energy consumption per cooking zone or area cal-culated per kg (ECelectric cooking)1. = 185,2 Wh/kg2. = 168,9 Wh/kgEnergy consumption for the hob calculated per kg(ECelectric hob)177,1 Wh/kg
Information for domestic electric hobsIn acc. with regulation (EU) No. 66/2014
MIELEModel name / identifierCS 1221-1Number of cooking zones and/or areas1For circular cooking zones: diameter of useful sur-face area/cooking zoneFor non-circular cooking zones or areas: lengthand width of useful surface area per electric cook-ing zone or area
1. = Ø 180-300 mm2. = 3. = 4. = 5. = 6. =
Energy consumption per cooking zone or area cal-culated per kg (ECelectric cooking)1. = 170,3 Wh/kgEnergy consumption for the hob calculated per kg(ECelectric hob)170,3 Wh/kg 
						

							Product data sheets57Information for domestic electric hobsIn acc. with regulation (EU) No. 66/2014MIELEModel name / identifierCS 1222Number of cooking zones and/or areas2For circular cooking zones: diameter of useful sur-face area/cooking zoneFor non-circular cooking zones or areas: lengthand width of useful surface area per electric cook-ing zone or area
1. = Ø 100-160 mm2. = Ø 200 / 200x300 mm3. = 4. = 5. = 6. =
Energy consumption per cooking zone or area cal-culated per kg (ECelectric cooking)1. = 185,2 Wh/kg2. = 188,7 Wh/kgEnergy consumption for the hob calculated per kg(ECelectric hob)187,0 Wh/kg 
						

							United KingdomMiele Co. Ltd.Fairacres, Marcham RoadAbingdon, Oxon, OX14 1TWCustomer Contact Centre Tel: 0330 160 6600E-mail: [email protected]: www.miele.co.uk
AustraliaMiele Australia Pty. Ltd.ACN 005 635 398ABN 96 005 635 3981 Gilbert Park Drive, Knoxfield, VIC 3180Tel: 1300 464 353Internet: www.miele.com.au
Miele (Shanghai) Trading Ltd.1-3 Floor, No. 82 Shi Men Yi RoadJing' an District200040 Shanghai, PRCTel: +86 21 6157 3500, Fax: +86 21 6157 3511E-mail: [email protected], Internet: www.miele.cn
China41/F - 4101, Manhattan Place23 Wang Tai RoadKowloon Bay, Hong KongTel: (852) 2610 1025, Fax: (852) 3579 1404Email: [email protected]: www.miele.hk
Miele (Hong Kong) LimitedMiele India Pvt. Ltd.Ground Floor, Copia Corporate SuitesPlot No. 9, Jasola, New Delhi - 110025Tel: 011-46 900 000, Fax: 011-46 900 001E-mail: [email protected], Internet: www.miele.in
IndiaMiele Ireland Ltd.2024 Bianconi AvenueCitywest Business Campus, Dublin 24Tel: (01) 461 07 10, Fax: (01) 461 07 97E-Mail: [email protected], Internet: www.miele.ie
IrelandMalaysiaMiele Sdn BhdSuite 12-2, Level 12Menara Sapura Kencana PetroleumSolaris Dutamas No. 1, Jalan Dutamas 150480 Kuala Lumpur, MalaysiaPhone: +603-6209-0288Fax: +603-6205-3768
Miele New Zealand LimitedIRD 98 463 631Level 2, 10 College HillFreemans Bay, Auckland 1011, NZTel: 0800 464 353Internet: www.miele.co.nz
New ZealandMiele Pte. Ltd.163 Penang Road# 04 - 03 Winsland House IISingapore 238463Tel: +65 6735 1191, Fax: +65 6735 1161E-Mail: [email protected]: www.miele.sg
SingaporeMiele (Pty) Ltd63 Peter Place, Bryanston 2194P.O. Box 69434, Bryanston 2021Tel: (011) 875 9000, Fax: (011) 875 9035E-mail: [email protected]: www.miele.co.za
South AfricaMiele Appliances Ltd.Gold & Diamond ParkOffice No. 6-217, Sheikh Zayed RoadP.O. Box 11 47 82 - DubaiTel. +971 4 3044 999Fax. +971 4 3418 852800-MIELE (64353)E-Mail: [email protected]: www.miele.ae
United Arab EmiratesCarl-Miele-Straße 29, 33332 Gütersloh, GermanyManufacturer:Miele & Cie. KG      
						

							M.-Nr. 09 055 450 / 06en-GBCS 1212-1 I / CS 1221 I / CS 1222 I0016