Miele 7644 C Manual

							Adjust keypad tone
An audible tone sounds every time a
button is pressed.
For programming and saving in
memory, follow stepsto.
The programmable function is
programmed using the buttons.
Precondition:
–The dryer is switched off.
–The door is closed.
PressStart/Stopand keep it pressed
it during steps\015-.
\015Press theI-On/0-Offbutton in.
Wait until theStart/Stopbutton lights up
continuously...
. . . then release theStart/Stop
button.
Press theGentlebutton five times.
–
TheGentleindicator light flashes
once slowly and once briefly.
–
Pand0flash alternatingly in the
display (default setting).The number appearing alternatingly
withPmeans:
0no Keypad tone
(default setting)
IKeypad tone on
(Expressindicator light also flashes)
Pressing theStart/Stopbutton
switches from one to the other.
Using theI-On/0-Offbutton, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.
Programmable functions
51 
						

							Changing water conductivity
setting
This programmable function
should be adjusted only when
residual water content is erroneously
determined owing to the extreme
softness of the water.
Important condition
The water in which fabrics are washed
may be extremely soft with a
conductivity value less than 150 μS/cm.
Drinking water conductivity can be
ascertained from your local water
supplier.
Activate this programmable function
only if the above-mentioned
condition applies.
Otherwise the drying result will be
unsatisfactory.
For programming and saving in
memory, follow stepsto.
The function is programmed using the
buttons.
Precondition:
–
The dryer is switched off.
–
The door is closed.
PressStart/Stopand keep it pressed
it during steps\015-.
\015Press theI-On/0-Offbutton in.
Wait until theStart/Stopbutton lights up
continuously...
. . . then release theStart/Stop
button.Press theGentlebutton six times.
–TheGentleindicator light flashes
once slowly and twice briefly.
–Pand0flash alternatingly in the
display (default setting).
The number appearing alternatingly
withPmeans:
0Default setting
ILower conductivity setting
(Expressindicator light also flashes)
Pressing theStart/Stopbutton
switches from one to the other.
Using theI-On/0-Offbutton, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.
Programmable functions
52 
						

							53 
						

							54 
						

							55 
						

							M.-Nr. 07 323 260 / 01Alteration rights reserved/ 2009