Metz Clarus 32 Ml Operating Instructions

HOME ENTERTAINMENT
Operating instructions
Clarus LCD-TV ML
Metz - always first class.607 47 2042.A1
07/49/07
LCD-TV
607 47 2042.A1 Clarus GB  04.12.2007  9:59 Uhr  Seite 1
 

1. Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2. Safety notes . . . . . . . . . . . . . . . . . . . . . . . . . 5
3. The Remote Control . . . . . . . . . . . . . . . . . . . . 6
4. Daily Operation . . . . . . . . . . . . . . . . . . . . . . 8
5.  Selecting the Operating Mode . . . . . . . . . . . . 8
6.  Station Selection . . . . . . . . . . . . . . . . . . . . . . 9
7. User Help (Information) . . . . . . . . . . . . . . . . 10
8. Menu Control . . . . . . . . . . . . . . . . . . ....

3
Contents
Configuration
Worth knowing
22.3 Automatic DVB-C station search . . . . . . . . . . 65
Manual DVB-C station search. . . . . . . . . . . . 66
23. Station Logo . . . . . . . . . . . . . . . . . . . . . . . . 67
24. Sorting Stations. . . . . . . . . . . . . . . . . . . . . . 68
25. Reg. AV Devices . . . . . . . . . . . . . . . . . . . . . 69
- Data Logic . . . . . . . . . . . . . . . . . . . . . . . . 70
- Setting the signal types RGB. . . . . . . . . . . . 72
- Setting the signal types DVI /...

4
• Take care that no bright artificial light or sunshi-
ne falls directly on the screen. This could cause
reflections which have a negative effect on the
brilliance of the picture.
• The best viewing distance is three times the
screen diagonal, i.e.
- Approximately 2 m (6 ft) for 26 screens
- Approximately 2.4 m (8 ft) for 32 screens
- Approximately 2.8 m (10 ft) for 37 screens
• The antenna cable and any other components
(such as a video recorder) connected between
the antenna socket in the wall and...

5
2. Safety notes
• Always place the monitor on a solid,
stable surface.
• If a cold TV set is moved to a warm
room, always allow any condensation
on the screen to evaporate before swit-
ching it on.
• The TV set is intended for use in a dry
room. If, in exceptional circumstances,
you use it outdoors, take care that is
protected against moisture (rain, splas-
hed water, dew).
• TV sets need adequate ventilation.
Never cover the openings on the rear
of the set with curtains, doilies, new-
spapers, etc....

6








	














The remote control sends commands to
the TV set by means of an infrared sig-
nal. You must point it towards the TV set
when using it. Note that the remote con-
trol may interfere with the operation of
other devices which use infrared signals
(such as infrared headphones).
Sunlight falling directly on the TV set
may interfere with the operation of the
remote control, since the TV set cannot
detect the infrared signals from the
remote control under these...

7
3. The Remote Control
Over view of the functions of the keys
Switch to DVB radio mode.
Switch on from the standby state into radio mode1).
Function keys:
F1/F2/F3: press brieflyto call the functions set in the factory.
F1/F2/F3: press and holdto display a selection of special functions.
AV: press to select one of the previously configured AV devices.
	Cursor control key in the Information window and the “TV menu”.

OK: confirmation key.
Volume control; values can be set in the TV menu.

Exit key:...

8
4. Daily Operation
Switching on
Switch on the TV set with the main
switch. 
The TV set is now in standby mode and
the red standby indicator lights.
After about five seconds, the TV set swit-
ches to programme position 1 or to the
programmed initial programme position.
If you press no further keys on the remo-
te control, a window requesting that you
do so is displayed after about 10 minu-
tes. If you do not do this, the TV set swit-
ches back to the standby state.
Use the numeric keys to select any...

9
Selecting stations from the station table
In normal TV or radio 1)mode, you can display
the station table by pressing the white  key. 
Press the white key  repeatedly to display a vir-
tual keyboard. Use the respective key to sort the
station list alphanumerically.
In the table which is then displayed, you can use
the oval rocker key P+/P- or the
numeric keys to select the desired station
and then press the OK key to display
this station.
If the station table contains more than
20 stations, you can...

10
During the design of this TV set, we have made
every effort to make it as easy a possible for you
to use it and we hope that you will enjoy familiari-
sing yourself with your new TV set.
With the Information menu, the TV set is able to
answer the many questions which may come up
during installation and setup.
To display this menu, simply press the INFO key
for the table of contents.
The Information menu (user help)
In the table of contents or the index, you
can select the item of interest with the...