Home > Lyman > Firearms accessories > Lyman The Mag 2 Press Instructions Manual

Lyman The Mag 2 Press Instructions Manual

Add to Favourites
    Download as PDF

    View the Lyman The Mag 2 Press Instructions Manual for free. All the Lyman manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 THE T-MAG II PRESS The Lyman T-Mag Press features a powerful compound leverage with a unique position index- able turret and quick disconnect release system. This allows you to mount several die sets, pre- cisely locked in and ready to reload at all times. You may also mount your powder measure in one of the die stations if it is compatible with the 7⁄8 x 14 threads (as many are). The Lyman #55 Powder Measure can be mounted to the turret using the Lyman 7⁄8 x 14 Adapter. A long steel handle adapted...
    Page 2 Should you need to seat small primers, substitute the small flat primer punch and sleeve packed separately using the enclosed Hex wrench. To install, remove the quick release pin from the priming arm lug. Position the priming arm as shown in Figure 6.Re- insert the quick release pin. To use the priming arm, place an unprimed cartridge case in the shell holder and a primer (anvil up) into the sleeve of the priming punch. Raise the ram to the top of its stroke and push the priming arm toward the press. The...
    Page 3 Force the slotted end of the tube down over each primer. The cotter pin will prevent the primers from dropping from the open end of the tube when you turn it over. Fill the tube completely, press the bushing (“0 ring”) end firmly into the primer feed body and remove the cotter pin. One of the red plastic sleeves supplied should be slipped over the open end of the primer tube to prevent injury should your face or arm strike to top of the primer tube. Lubrication and Care of Your Press Before using your...
    Page 4 INSTRUCTIONS FOR INDEXING AND REMOVING THE TURRET OF YOUR T-MAG 11 PRESS Your T-Mag II Press is supplied with a turret handle (item #2) which can be used for index- ing or removing the turret from the reloading press. For easy indexing. insert the turret handle into one of the two holes in the turret (item #3) and turn as desired. To change or remove the turret, secure the press to a table or other fixed surface. Insert the turret handle through the cross hole in the turret shoulder bolt (item #1). Using...
    Start reading Lyman The Mag 2 Press Instructions Manual

    Related Manuals for Lyman The Mag 2 Press Instructions Manual

    All Lyman manuals