LG Gw B207 Flqa Owners Manual

1. Place your appliance where it is easy touse.
2. Avoid placing the unit near heat sources, direct sunlight or moisture.
3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient
space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.
4. To avoid vibrations, the appliance must be leveled.
5. Dont install the appliance below 5 °C. It may cause affect the performance. 

6
Installation
Select a good
location

Where to Install...

7
Installation
Door removal
Failure to do so could result in death or serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally. 
Electric Shock Hazard 
Disconnect electrical supply to refrigerator before installing. 
Remove the lower cover by lifting upward, and
remove clip, and then pull up the feed water tube
while pressing area 
shown in the figure to the
right.
Remove lower cover and
then feed water...

8
Installation
Door replacement
Feed water pipe installation
(*Dispenser model only)
Pass the refrigerator laterally through the access
door as shown in the right figure.

Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).

If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is
necessary to purchase a separate pressure pump for normal automatic icin\
g and
cool water...

9

Installation
Height adjustment
Level the door by inserting flat (-type) driver into the groove of the left height adjusting
screw and rotate it clockwise ( 
).
Level the door by  inserting flat (
-type) driver into the groove of the right height
adjusting screw and rotate it  clockwise (
).
The refrigerator doors will close smoothly by heightening the front side\
 by adjusting
the height adjusting screw. If the doors do not close correctly, perform\
ance may be
affected.
If the freezer
compartment...

10

Operation
Starting
When your refr ige ra tor  is frst in stalled, allo w it to stab ilize at normal ope rating
t e mpera tures f or 2-3 hour s prior  to flling it with  f r e sh  or frozen foods. 
If  op era tion  is in terrup ted, wait  5 min utes be fo re  rest artin g .

Optional
T ype-1
T ype-2 Function display board
Display 
Power Saving  Mode 

Refreshment Center
Refreshment Center 
Button

Adjusting the temperatures and functions
*Non dispenser model - Type 1
 

Operation
OptionalT ype-1
T ype-2
T ype-3 Function display board
Exp
re ss freez er. Child  lock  :  H old3  secs.
D is p lay  Savin g  M od e
D is p lay  Savin g  M od e
D is p lay  Savin g  M od e
Temp erature a d just ment  b utt o n
for  freeze r comp artme nt.Temp erature a d just ment  b utt o n
For  re fri gerat or comp artmen t.
12
•Your model may not include every option.•Display Type-3: The control display is operated by touch. Excessive mois\
ture on the
display may cause a malfunction....

11


\b	

\f \f	


\b	

\f
\b	


  
	 

	 
  

\b	

\f \f	
\f\f

Operation
•Your model may not include every option.
NOTE

*Dispenser model -  Type 22 1
 

13
Operation
OptionalT ype-1
T ype-2
T ype-3 Function display board
E
xpr ess fre ezer .
C hil d  l ock  : H old  3  sec . F
il t e r reset  but to n .
Tempe ra tu re  adj ustment  button
f or  fr eezer  compartm ent .Tempe ra tu re  adj ustment  butto n
f or  re friger ato r com partm ent .
Displ ay Savin g  M od e
D ispl ay Savin g  M od e
D ispl ay Savin g  M od e
LIGH T/
Filte r res et b utton.
L ight  ON/OF F but ton  - O ptio n
D isp enser  select ion  butto n
•Your model may not include every...

Optio nal Typ e-1 Typ e-2 Type- 3
FR Z
T EM P
  S etti ng
Tem peratur e
  S etti ng
Tem peratur e
Optio nal Typ e-1 Typ e-2 Type- 3
REF
T EM P

You can adjust temperatur e of and freezer room and refrigerator room.
Whenever pre ssing  b utt on,  settin g is  repeated in t he order.
The actual in ner tempe ra tu re varies  dep ending  on the food statu s, as the
indicat ed  set ting  t empe rature  is a tar get temper ature, no t actual temp erature
w ithin re fr iger ator .
Refrigeration funct ion is w...

Operation

•Your model may not include every option.•The control display is operated by touch. Excessive moisture on the disp\
lay may
cause a malfunction. Please keep display clean and dry.
NOTE
13
3