LG 32ld320 Owners Manual

PREPARATION
21
DETACHMENT
Carefully  place  the  TV  screen  side  down  on  a
cushioned  surface  to  protect  the  screen  from
damage.1
Loose the bolts from TV.2
Detach the stand from TV.3
PROTECTION COVER
After  removing  the  stand,  install  the  included
p pr
ro
ot
te
ec
ct
ti
io
on
n 
 c
co
ov
ve
er
r
over  the  hole  for  the
stand.
Press the P PR
RO
OT
TE
EC
CT
TI
IO
ON
N 
 C
CO
OV
VE
ER
R
into the TV
until you hear it click.
4  

PREPARATION
22
VESA WALL MOUNTING
PREPARATION
Install your wall mount on a solid wall perpendicular to the floor. When attaching to other building materials, please
contact your nearest installer.
If installed on a ceiling or slanted wall, it may fall and result in severe personal injury.
We recommend that you use an LG brand wall mount when mounting the TV to a wall.
LG recommends that wall mounting be performed by a qualified professional installer.
G GDo not install your wall mount kit while your TV...

PREPARATION
23
CABLE MANAGEMENT
For 19/22LD350
After connecting the cables as necessary,
install CABLE HOLDERas shown and bundle
the cables.
K
AC-IN1
Image shown may differ from your TV.  

PREPARATION
24
CABLE MANAGEMENT
PREPARATION
Image shown may differ from your TV.
For 26/32LD350, 32/37/42/47LD450
AC  IN
AC  IN
AC  IN
AC  IN
AC  IN
AC  IN
AC  IN
AC  IN
AC  IN
Connect the cables as necessary.
To connect additional equipment, see the
EXTERNAL EQUIPMENT SETUP section.
Open the CABLE MANAGEMENT CLIPas
shown.
CABLE MANAGEMENT CLIP
1
2
Put the cables inside the CABLE MANAGEMENT
CLIPand snap it closed.3  

PREPARATION
25
SWIVEL STAND (Except 19/22LD350)
After installing the TV, you can adjust the TV set manually to the left or right direction by 20 degrees to suit
your viewing position.
POSITIONING YOUR DISPLAY (For 19/22LD350)
Here shown may be somewhat different from your TV.
Adjust the position of the panel in various ways for maximum comfort.
• Tilt range
12030  

PREPARATION
26
DESKTOP PEDESTAL INSTALLATION
PREPARATION
For proper ventilation, allow a clearance of 4 inches on all four sides from the wall.
Image shown may differ from your TV.
4 inches
G GEnsure adequate ventilation by following the clearance recommendations.
G
GDo not mount near or above any type of heat source.
CAUTION
4 inches 4 inches4 inches  

PREPARATION
27
ATTACHING THE TV TO A DESK (Except 19/22LD350)
The TV must be attached to a desk so it cannot be pulled in a forward/backward direction, potentially causing
injury or damaging the product.
G GTo prevent TV from falling over, the TV should be securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the machine may cause injury.
WARNING
1-Screw
(provided as parts of the product)
Desk
Stand
KENSINGTON SECURITY SYSTEM
This feature is not available for...

PREPARATION
28
SECURING THE TV TO THE WALL TO PREVENT FALLING
WHEN THE TV IS USED ON A STAND
PREPARATION
We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. 
Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction,
potentially causing injury or damaging the product. 
Caution: Please make sure that children don’t climb on or hang from the TV. 
Insert the eye-bolts (or TV brackets and bolts) to tighten the...

PREPARATION
29
ANTENNA OR CABLE CONNECTION
1. Antenna (Analog or Digital)
Wall Antenna Socket or Outdoor Antenna without a Cable Box
Connections.
For optimum picture quality, adjust antenna direction if needed.
2. Cable
Wa l l
Antenna
Socket
Outdoor
Antenna
(VHF, UHF)
Cable TV
Wall JackMulti-family Dwellings/Apartments
(Connect to wall antenna socket)
RF Coaxial Wire (75 ohm)
RF Coaxial Wire (75 ohm) Single-family Dwellings /Houses
(Connect to wall jack for outdoor antenna)
Be careful not to bend the...

EXTERNAL EQUIPMENT SETUP
30
EXTERNAL EQUIPMENT SETUP
HD RECEIVER SETUP
This TV can receive digital over-the-air/digital cable signals without an external digital set-top box. However, if
you do receive digital signals from a digital set-top box or other digital external device.
Component Connection
1. How to connect
Connect the video outputs (
Y,   PB, PR)
of the digital set-
top  box  to  the C CO
OM
MP
PO
ON
NE
EN
NT
T 
 I
IN
N 
 V
VI
ID
DE
EO
O 
 
jacks  on
the TV. Match the jack colors (Y = green, P...