Lexmark X 950 User Manual

Setting up and using the home screen
applications
Notes:
Your home screen, icons, and buttons may vary depending on your home screen customization settings,
administrative setup, and active embedded applications.
There may be additional solutions and applications available for purchase. For more information, go to
http://support.lexmark.com or contact the place where you purchased the printer.
Accessing the Embedded Web Server
The Embedded Web Server is the printer Web page that lets you view and...

Activating the home screen applications
Your printer comes with preinstalled home screen applications. Before you can use these applications, 
first
activate and set up these applications using the Embedded Web Server. For more information about accessing
the Embedded Web Server, see 
“Accessing the Embedded Web Server” on page 21.
For detailed information about configuring and using the home screen applications, go to the Lexmark Web
site at 
http://support.lexmark.com.
Setting up Forms and Favorites
Icon...

1Open a Web browser, and then type the printer IP address in the address field.
Note: View the printer IP address on the printer control panel home screen. The IP address appears as
four sets of numbers separated by periods, such as 123.123.123.123.
2Click Settings > Device Solutions > Solutions (eSF) > Scan to Network.
3Specify the destinations, and then customize the settings.
4Click Apply.
To use the application, touch Scan to Network on the printer home screen, and then follow the instructions on
the...

Setting up Remote Operator Panel
This application shows the printer control panel on your computer screen and lets you interact with the printer
control panel, even when you are not physically near the network printer. From your computer screen, you can
view the printer status, release held print jobs, create bookmarks, and do other print-related tasks you might
normally do while standing at the network printer.
1Open a Web browser, and then type the printer IP address in the address 
field.
Note: View...

5Click Configure > Import.
6Browse to the saved configuration file that was exported from a previously configured printer, and then load
or preview it.
Note: If a timeout occurs and a blank screen appears, then refresh the Web browser, and then click
Apply. Setting up and using the home screen applications 25 

Additional printer setup
Turning on the printer
1Open the front door.
2Press the printer power switch.
3Close the front door.
Additional printer setup26 

Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer 
off, and unplug the power
cord from the wall outlet before continuing. If you have any other devices attached to the printer, then
turn them off as well, and unplug any cables going into the printer.
Available internal options
Memory cards
–Printer memory
–Flash memory
–Fonts
Firmware cards
–Bar Code...

Note: This task requires a flathead screwdriver.
1Turn the screws counterclockwise to loosen them.
2Pull the system board forward to remove it.
3Use the following illustration to locate the appropriate connectors.
Warning—Potential Damage: System board electronic components are easily damaged by static
electricity. Touch something metal on the printer before touching any system board electronic
components or connectors. Additional printer setup28 

1
2
3
1ISP connector
2Firmware and flash memory card connectors
3Memory card connectors
4Push the system board back into place.
Installing a memory card
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer 
off, and unplug the power
cord from the wall outlet before continuing. If you have any other devices attached to the printer, then
turn them off as well, and unplug any cables going...

3On the system board, open the memory card connector latches.
4Align the notch on the memory card to the ridge on the connector.
1
2
1Notch
2Ridge
Additional printer setup30