Lexmark X 203 Service Manual

							5
Install the new toner cartridge by aligning the rollers on the toner cartridge with the arrows on the tracks of the 
photoconductor kit. Push the toner cartridge in as far as it will go. The cartridge  clicks into place when correctly 
installed. 6
Close the front door.
Replacing the photoconductor kit The printer automatically notifies you before the photoconductor kit reaches a page maximum by showing  84 PC 
Kit life warning or  84 Replace PC Kit on the display. You can also see the status of the photoconductor 
kit by printing a menu settings page.
When  84 PC Kit life warning or  84 Replace PC Kit first appears, you should immediately order a new 
photoconductor kit. While the printer may continue to function properly after the photoconductor kit has reached its 
official end ‑of‑life, print quality significantly decreases. Note:  The photoconductor kit is one item only.
Maintaining the printer
11 
						

							1
Open the front door by pressing the button on the left side of the printer and lowering the front door. 2
Pull the photoconductor kit and toner cartridge out of the printer as a unit by pulling on the toner cartridge handle. Note:  The photoconductor kit and toner cartridge form a unit.
Place the unit on a flat, clean surface.
Maintaining the printer
12 
						

							3
Press the button on the base of the photoconductor kit. Pull the toner cartridge up and out using the handle. 4
Unpack the new photoconductor kit. Be careful not to touch the photoconductor drum. Warning—Potential Damage:  When replacing the photoconductor kit, do not leave the kit exposed to direct 
light for an extended period of time. Extended light exposure can cause significant print quality problems. Maintaining the printer
13 
						

							5
Insert the toner cartridge into the photoconductor kit by aligning the rollers on the toner cartridge with the tracks. 
Push the toner cartridge until it  clicks into place.6
Install the unit into the printer by aligning the arrows on the guides of the unit with the arrows in the printer. Push 
the unit in as far as it will go. 7
After you replace the photoconductor kit, reset the photoconductor counter. To reset the counter, see the 
instruction sheet that came with the new photoconductor kit. Warning—Potential Damage:  Resetting the photoconductor counter without replacing the photoconductor 
may damage your printer and void your warranty.
8 Close the front door.
Moving the printer to another location Warning—Potential Damage:  Damage to the printer caused by improper moving is not covered by the printer 
warranty. CAUTION—POTENTIAL INJURY:  Follow these guidelines to avoid personal injury or printer damage:
• Turn the printer off using the power switch, and then unplug the power cord from the wall outlet.
• Disconnect all cords and cables from the printer before moving it. Maintaining the printer
14 
						

							•
Use the handholds located on both sides of the printer to lift it.
• Make sure your fingers are not under the printer when you set it down.
• Before setting up the printer, make sure there is adequate clearance around it.   .
The printer and options can be safely moved to another location by following these precautions: • Any cart used to move the printer must be able to support its weight and have a large enough surface to support 
the full footprint of the printer.
• Keep the printer in an upright position.
• Avoid severe jarring movements.
Shipping the printer
When shipping the printer, use the original packaging or call the place of purchase for a relocation kit. Maintaining the printer
15