Lexmark X 203 Service Manual

Lexmark X203n and X204n Series
Maintenance Guide
February 2011 www.lexmark.com 

Contents
Maintaining the printer
................................................................................ 3
Cleaning the exterior of the printer .......................................................................................................... 3
Cleaning the scanner glass ........................................................................................................................ 4
Cleaning the ADF separator rollers...

Maintaining the printer
Periodically, certain tasks are required to maintain optimum print quality.
Cleaning the exterior of the printer 1 Make sure that the printer is turned off and unplugged from the wall outlet. CAUTION—SHOCK HAZARD:  To avoid the risk of electric shock when cleaning the exterior of the printer, 
unplug the power cord from the wall outlet and disconnect all cables to the printer before proceeding.
2 Remove all paper from the printer.
3 Dampen a clean, lint ‑free cloth with...

Cleaning the scanner glass
If you encounter print quality problems, such as streaks on copied or scanned images, clean the areas shown. 1 Slightly dampen a soft, lint-free cloth or paper towel with water.
2 Open the scanner cover. 1
White undersides of the scanner glass cover and the ADF cover
2 Scanner glass and ADF glass
3 ADF tabs 3 Wipe the areas shown and let them dry.
Warning—Potential Damage:  Do not fold or crease the ADF tabs. Doing so may cause jams.
4 Close the scanner cover. Maintaining the...

Cleaning the ADF separator rollers
After you have copied over 5,000 pages using the ADF, or if streaks are appearing, clean the ADF separator rollers. 1 Open the ADF cover. 2
Unlock the separator roll. 3
Remove the separator roll. Maintaining the printer
5 

4
Use a clean, lint-free cloth dampened with water to wipe the separator roller. 5
Reinstall the separator roll. 6
Lock the separator roll. Maintaining the printer
6 

7
Use a second clean, lint-free cloth dampened with water to wipe the other separator roller while gently rotating it. 8
Close the ADF cover. Storing supplies
Choose a cool, clean storage area for the printer supplies. Store supplies right side up in their original packing until you 
are ready to use them.
Do not expose supplies to: • Direct sunlight
• Temperatures above 35°C (95°F)
• High humidity above 80%
•
Salty air
• Corrosive gases
• Heavy dust
Checking the status of supplies from a network...

1
Type the printer IP address into the address field of your Web browser. Note:  If you do not know the IP address of the printer, print a network setup page and locate the IP address in 
the TCP/IP section.
2
Click  Device Status. The Device Status page appears, displaying a summary of supply levels.
Ordering supplies To order supplies in the U.S., contact Lexmark at 1-800-539-6275 for information about Lexmark authorized supplies 
dealers in your area. In other countries or regions, visit the Lexmark...

Part name Part number
Photoconductor kit
X203H22GReplacing supplies
Replacing the toner cartridge
When 88 Cartridge is low appears, or when you experience faded print, remove the toner cartridge. Firmly 
shake it side ‑to‑side and front ‑to‑back several times to redistribute the toner, and then reinsert it and continue printing. 
When shaking the cartridge no longer improves the print quality, replace the toner cartridge. Note:  You can check to see approximately how much toner is left in your cartridge...

2
Press the button on the base of the photoconductor kit, and then pull the toner cartridge out using the handle. 3
Unpack the new toner cartridge.
4 Shake the cartridge in all directions to distribute the toner. Maintaining the printer
10